離心吸入 的英文怎麼說

中文拼音 [líxīnxīrù]
離心吸入 英文
positive prime
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 吸 : 動詞1 （把液體、氣體等引入體內） inhale; breathe in; draw 2 （吸收） absorb; suck up 3 （吸引） a...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 離心 : 1 （不是一條心） be at odds with the community or the leadership2 （離開中心） centrifugal; eccen...
  1. Washed air purifier working principle : siphon and using centrifugal principle will be mixed in water pure plant essential oils inhaled through its siphon principle the motor base coaxial centrifugal turbines in the bottom of straw through exchanges cover a very high - speed rotary motor, reuse centrifugal principle, will be mixed in water pure plant essential oil spray bottle in the form within a water film bile, the dust in the air and inhaled bacteria in water purification at the same time after the indoor air insufflation, quickly and efficiently by removing indoor toxin biological, dust, cigarette smoke, the smell, virus

    水洗空氣清新機工作原理：是利用虹吸以及離心原理；將混合於水的純植物精油通過虹吸原理吸入其電機底座的同軸離心渦輪下部的吸管中，通過交流罩極電機高速旋轉，再利用離心原理，將混合於水的純植物精油噴在瓶膽內形成一層水膜，將空氣中的灰塵以及細菌吸入水中，同時將經過凈化的空氣吹入室內，快速有效地去除室內的有毒素生物、灰塵、煙味、臭味、病毒等。
  2. The dynamo runs at rull speed to drive main shaft, then the main shaft makes the emulsifying wings in emulsification grove rotate, which absorbs the liquid in its brand groove into ring groove through guide vanes on upper and lower sides of the groove. the vanes spins circularly at high speed with the main shatf as center, and the blade and emulsificaton groove cut and crush it continuously. after that. it gers squeezed by the vanes highspeed centrifugal rotation. at last, it finishes isotropt emulsification tratment within extremely short time after continuous circulating mixing

    由電動機全速運轉帶動主軸，經主軸轉動乳化框槽內之乳化翼片，使其將桶槽內之液體經框槽上、下兩側之導流葉片吸入環狀框槽內，經以主軸為中心高速圓周旋轉葉片；連續使乳化翼端刀面與乳化框間極小之間系高頻率之強力切割剪斷、粉碎，再借葉片高速離心旋轉排擠，持續循環混合，以極短之時間即可完成均質乳化之處理。
  3. This machine is of vertical crushing structure, and the material is fed into the crushing chambezr through a hopper, crushed by simultaneous cutting of both fixed and movable knives and rotating impact of rotating knife, and entered into the catcher automatically under the effect of rotating centrifugal force, and the dust is filtered and recovered by dust collector through a bag

    本機為立式粉碎結構，物料由進料斗進入粉碎室，利用旋轉刀的旋轉沖擊，固定刀和活動刀同進剪切而獲得粉碎，粉碎好的物料經旋轉離心力的作用，自動進入捕集袋，粉塵由吸塵箱經布袋過濾回收。
  4. Due to the centrifugal force of rcvolving object, aotomatically run to the exit

    粉碎好的物料經旋轉離心力的作用，自動進入輔集袋，粉塵由吸塵箱經布袋過濾回收。
  5. This principle is a lettle like centrifugal pump. when runing, stock enters via the center of tubine wheel, and then under the function of centrifugal force is flung to the direction of tangent and drains out through specified channel

    其作用原理類似離心泵，運轉時漿料從渦輪中心吸入，由於離心力的作用，被甩到葉輪的切線方向，經特定的腔道流出。
  6. The band was previously associated with f - type color centers and v - type color centers, as analyzed in x - ray irradiated ysz sample. however, the absorption band observed in our experiments has a shift towards the longer wavelength ( red shift ) as comparing with that in the x - ray or neutron irradiated ysz spectra. this shift may mainly due to large local distortions near the f - type centers and the v - type centers and the presence of multiple color centers

    本文通過光吸收、光熒光、 tem 、 xps測試及trim96計算分別研究了不同注量xe ~ +注入ysz前後光學性能和缺陷形態變化，以及ni ~ +注入對不同摻雜單晶al _ 2o _ 3結構和光學性能的影響，得到以下結果： （ 1 ） ysz注量達到10 ~ （ 16 ） cm ~ （ - 2 ）時，開始出現由f型和v型色心重疊而產生的吸收帶，與x射線、中子輻照相比，重離子輻照產生了更為復雜的缺陷復合體而導致吸收峰紅移。
  7. When ready to start centrifugal pumps, fully open suction valves and throttle discharge valves of a positive displacement

    當準備好啟動離心式泵時，吸入閥全開，容積式排出閥節流。
  8. End - suction centrifugal pumps, rating with 10 bar with bearing bracket. nominal duty point, main dimensions, designation system

    帶支承架的額定值10巴的端部吸入式離心泵.公稱負荷點主要尺寸和命名體系
  9. This machine is of hammer type high speed crusher, material is fed into the crushing chamber by a hopper through screw conveyor and crushed by high speed rotating hammer, the crushed material is entered into the catcher automatically under the effect of rotating centrifugal force, and the dust is filtered and recovered by dust collector through a bag

    本機為錘式高速粉碎機，物料由料斗經螺旋輸送桿進入粉碎室，被高速旋轉的錘子擊碎，而獲得粉碎，粉碎好的物料經旋轉離心力的作用，自動進入捕集袋，粉塵由吸塵箱經布袋過濾回收。
  10. Specification for sealless horizontal end suction metallic centrifugal pumps for chemical process

    化學工藝用無縫水平末端吸入式金屬離心泵規范
  11. End - suction centrifugal pumps - baseplate and installation dimensions

    軸向吸入離心泵底座尺寸和安裝尺寸
  12. End - suction centrifugal pumps. baseplate and installation dimensions

    端部吸入離心泵.底盤及設備的尺寸
  13. Iso 3661 : 1977 ; end - suction centrifugal pumps - baseplate and installation dimensions iso 3661 : 1977 ; german version en 23661 : 1993

    離心式末端吸入泵.基座和安裝尺寸
分享友人
分享到 Line

分享到臉書