離散誤差 的英文怎麼說

中文拼音 [lísǎnwùchā]
離散誤差 英文
discretization error
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 離散 : dispersed; scattered about; separated from one another; spread; debunching; straggling; fringing;...
  • 誤差 : error
  1. Method of deal with data error by subsection curve fitting and discrete degree

    分段曲線擬合與離散度加權的數據誤差處理方法
  2. The parameters that influence the single photon acquisition probability are the transmitter ' s tracking - pointing error, the far - field divergence angle, the link distance between transmitter and receiver and the receiver ' s antenna aperture

    得到影響單光子捕獲概率的主要參量是發射機的跟瞄誤差、光束遠場發散角、發射機和接收機的鏈路距離和接收機天線孔徑。
  3. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  4. Optimal error estimation on semi - discrete solution of parabolic equation

    拋物型方程半離散解的最優誤差估計
  5. In chapter two, we consider full disceret scheme of mixed finite element methods for the following initial - value problems of linear integro - differential equations of parabolic in this chapter, we give the error analysis of this full discrete scheme and get optimal error estimates for the discrete solutions of u and p

    第二章討論下述線性拋物型積分微分方程初邊值問題混合有限元方法的后差全離散格式。給出了該全離散格式的誤差分析，得到了離散解逼近未知函數u以及伴隨速度p的關于空間和時間的最優階誤差估計。
  6. It is discussed that the present harmonic analyzers do n ' t satisfy the requirements of china standard for harmonic measure of quick disturbance harmonic load. the measurement error brought about by the harmonic analyzers adopting ft or fft algorithm is analyzed. a cycle discrete fourier algorithm that should n ' t be effected by aperiodic component is presented, and the results of simulation show that it has higher accureacy

    本文對電力系統諧波的測量方法，數據處理及電力牽引負荷對電力系統的影響進行了研究，論述了目前國內外生產的諧波分析儀用於快速波動諧波負荷的測量不滿足國標的要求，分析了諧波分析儀普遍採用的ft或fft演算法所產生的測量誤差，提出了一種不受非周期分量影響的全周波離散傅里葉演算法，模擬結果表明精度好。
  7. Meanwhile the technology for separating scattering field from total field is improved in this paper, which could eliminate the calculation error and get precise scattering field

    論文還改進了時域有限差分方法中的總場散射場的分離技術，消除了原來因為分離帶來的計算誤差，提高了散射計算的精度。
  8. In this paper, data acquisition and processing method is introduced, surface fitting and error estimation methods based on special scattered data is put forward

    本文介紹了三維坐標數據的採集和數據處理方法，提出了基於空間離散點坐標進行二次曲面擬合及其誤差評定的方法。
  9. Based on the output - voltage error function, a novel time discrete modulation technique is proposed for matrix converters ( mcs ) and time - discrete difference equations of a mc circuit are derived

    摘要針對矩陣變換器調制方式的特點，提出了基於輸出電壓誤差函數分析的矩陣變換器離散調制技術，推導了基於時間離散和差分原理的電路方程。
  10. Abstract : the attitude error performance of electrostatic gyro should be understood and the relevant error equations must be set up in order to ensure the navigation precision of esgm. the relation between the navigation errors and the attitude errors of gyro was derived by use of spherical triangle. the simulation results show that the temporal performances of the longitudinal and distance errors which come from the initial alignment errors are periodically variational. they also show that the longitudinal and distance errors resulted from gyro drifts are not convergent in time. thus, the effects of initial alignment errors and gyro drifts can not be neglected and must be estimated and compensated

    文摘:為了保證靜電監控器的導航定位精度，需要了解靜電陀螺的姿態誤差特性，建立相應的誤差方程.本文採用球面三角形原理推導了導航定位誤差與陀螺姿態誤差的關系式.模擬結果表明，由初始定向誤差引起的經度誤差和距離誤差的時間特性是周期變化的；由陀螺漂移引起的經度誤差和距離誤差是隨時間發散的.因此，初始定向誤差和陀螺漂移的影響不能忽略，必須對其進行估計和補償
  11. It is proved that the investment decision - making process which is described by general backward stochastic differential equations ( bsdes ) can be approached by discrete investment

    摘要證明了一般的倒向隨機微分方程所描述的投資決策過程可用離散的投資決策過程進行逼近，並給出了逼近誤差的估計。
  12. Firstly, discrete methods of time and space in the dns are introduced in the present paper. and the procedure of solving the navier - stokes equation is also presented. in addition, ways of correcting time - splitting error and removing aliasing error in pesudospectral transform method are introduced too

    本文首先介紹了直接數值模擬中時間和空間離散的方法，並詳細介紹方程的求解的步驟以及偽譜法中混淆誤差產生的原因及其消除方法，並對時間分裂法造成的散度誤差的修正方法進行了簡要的介紹。
  13. In the fields of fluid dynamics, entropy inequality reflects the second law of thermodynamics. i. e. entropy must increase across shock waves ( a kind of discontinuity ). all kind of approximate schemes should reflect the fact that it must satisfies some kind of discrete entropy inequality ). from the view of practical computation, stability and theo - retical error of any kind discrete schemes all dependend of the smoothness of the solution of ( 0. 2. 1 ). generally, the approximate solution have good stability and theoretial error in the area where the solutions have more regularity and poor stability and theoretial error in other area

    從流體力學來看，它事實上是熱力學第二定理的反映，即熵越過激波（一種間斷）要增加。各種估計格式構造的估計解應反映這一事實，即滿足熵不等式。從實際計算來看，總是通過離散化求解，不考慮計算的積累誤差，它的穩定性與計算精度都依賴與真解的光滑性，一般說，在解較光滑的區域有較好的穩定性與計算精度，而在較粗糙的區域則相反。
  14. By using auto - adjusting boundary conditions and the method of three cubed spline curve fitting, the system software can recover both of the horizontal and vertical beam profile. the measurement system can also measure the beam landing screen error of cpt. it provides a important measurement and analysis tool to improve the performance of electron gun and dy, and improve the definition of cpt

    系統軟體中，提出了採用動態確定邊界條件，通過對離散采樣點的三次樣條插值曲線的擬合恢復束斑x和y方向的輪廓，本系統既能準確客觀地描述電子束輪廓，又能夠準確快速地測量電子束著屏誤差等多種參數，為cpt電子槍和偏轉系統的性能改進與解析度的提高提供了有力的測試分析和研究手段。
  15. Finally, we establish rational spectral formation of discrete with regard to time and space, and gained the error estimate in the finite - time in the abstract

    最後，我們構造了同時關于時間空間方向離散的譜格式，並從理論上建立了在有限時間上的全離散格式近似解的誤差估計。
  16. We introduce some marks and lemmas before we construct chebyshev rational spectral formation of semi - discrete with respect to space. then we obtian the error estimate for the approximate solution and the existence of approximate attractor an, and besides, we prove the upper semi - continuty on the global attractor

    在引入一些本文所需的記號和引理之後，通過建立chebyshev關于空間方向的半離散有理譜格式，證明了方程近似解的誤差估計，以及在此格式下近似吸引子a _ n的存在性，並且得到關于原方程整體吸引子的上半連續性。
  17. Lyapunov exponent depict the discrete extent of chaotic dynamic system. there propose an estimation of one step prediction error based on lyapunov exponent, the estimation express the reliability of prediction numerically. at the same time, in order to improve the predictive precision it drew out an error complement methods creatively to correct one step prediction

    Lyapunov指數定量刻畫混沌離散動力系統的平均發散程度，基於lyapunov指數作出了一步預測的誤差估計，以此來定量反映預測的可靠性；根據奇異吸引子流形的性質，創造性的提出殘差補充法，對預測值作出修正以降低誤差，提高預測精確性。
  18. The paper gave disperse pattern of laplace function under in - uniform grid, which fulfills acceptance character and error maximization theory. it also has fulfills the character of extreme value

    本文在一個不規則網路上離散拉普拉斯運算元的差分格式，不但能滿足相容性及極值原理，而且還具有誤差極少性質。
  19. The error accumulation caused by the errors of modal vectors is banished and an emendation to the classical modal model is conducted, due to the extraction of the independent contribution of each mode by means of the orthogonality of the modal filter

    通過對離散模態濾波器的改進，避免了載荷重構階段模態向量誤差引起的載荷識別誤差積累，從而實現了對經典載荷識別模態模型的校正。
  20. Based on the simplified principle, the modal shapes of selected structural modes are converted into modal strains. to minimize the calculation error, curve - fitting technique is used in the process. the modal strains are summed together to determine the global distribution of the structure for selected vibration modes so that the position of piezoelectric elements could be optimally determined according to the simplified optimization principle

    通過二階中心差分運算將模態振型轉化為模態應變，採用應變曲線擬合方法降低離散誤差，進而將各階待控模態應變進行疊加，獲取系統整體特徵應變分佈情況；最後根據壓電元件位置優化的簡化目標函數，將壓電片的最優位置確定為柔性板疊加模態應變的極值區域。
分享友人
分享到 Line

分享到臉書