雷諾比擬 的英文怎麼說

中文拼音 [léinuòbǐnǐ]
雷諾比擬 英文
reynolds analogy
  • 雷 : 1. （雲層放電時發出的響聲） thunder 2. （軍事上用的爆炸武器） mine 3. （姓氏） a surname
  • 諾 : Ⅰ動詞（答應; 允許） promise Ⅱ感嘆詞（答應的聲音） yesⅢ名詞（姓氏） a surname
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 雷諾 : jean renoir
  • 比擬 : 1 （比較） compare; parallel; draw a parallel; liken; match 2 （一種修辭手法; 把人擬作物或把物擬...
  1. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  2. Numerical simulation on the three - dimensional turbulence flow in the pick - up tube is based on reynolds time - average navier - stokes equations. the k - turbulence - closed model is used in this paper. in the near wall area the standard wall function is used

    對集流管的三維粘性紊流模擬計算是建立在雷諾平均的navier - stokes方程的基礎上，紊流封閉模型採用目前工程上應用比較廣泛的模型，在靠近固壁區採用了標準的壁面函數法。
  3. By comparing the results between two dimension simulation and three dimension, it deemed that the results are very close to each other when under lower re number, but varied quite under high re number. in company with the test syst

    對二維大渦模擬和三維大渦模擬的時均結果進行比較，認為二維模擬在低雷諾數下計算結果和三維計算結果較為接近，但是在高雷諾數下計算結果差別很大。
  4. Firstly, for jet array impingement cooling, the effects of the distance of adjacent holes, the impinging distance and jet reynolds number on heat transfer characteristic at the target wall are summarized under staggered holes arrangement and the same hole diameter. and then, the numerical simulation of inclined multi - hole film cooling has been studied. the influence factors examined in this case include blowing ratio and the distance of adjacent holes

    首先通過對射流沖擊冷卻方式的研究，分析了相鄰孔間距、沖擊間距以及射流入口雷諾數對沖擊靶面換熱系數的影響情況，然後對多斜孔冷卻方式進行了數值模擬，重點探討了吹風比和相鄰孔間距對絕熱溫比與壁面換熱系數的影響規律，最後，針對沖擊-發散復合冷卻流場的計算物理模型，研究吹風比、相鄰孔間距的變化對沖擊-發散復合冷卻流動與傳熱特性的影響。
  5. In this paper i was in virtue of the fluent software, set up the geometrical model of jin ’ ao mansion and adjacent buildings, used non - equilibrium wall functions to deal with the problem which come from the near wall, used realizable k - turbulent model to simulate the steady flow around 3d high - rise buildings, we can get the distribution of mean wind pressure coefficient of the surface of jin ’ ao mansion and five aerodynamics components. they were compared with the data from the wind tunnel test, we found out the distance between the result of the wind tunnel test and numerical simulation in the acceptable range

    本文以fluent軟體為平臺，建立金奧大廈及其周邊建築的計算幾何模型，近壁區採用非平衡壁面函數法處理，運用基於雷諾時均的realizablek -湍流模型進行高層建築三維定常風場數值模擬，獲得金奧大廈表面時均風壓系數分佈及基底五分量氣動力，並和風洞測壓試驗的結果及風壓系數積分計算的基底五分量氣動力相比較，發現兩者之間的差異在可接受的范圍之內。
  6. A novel strip - coil - baffle structure used to enhance heat transfer and support the tube bundle for a tube - shell heat exchanger is proposed. the new structure can sleeve the tubes in bundle alternatively to create a vortex flow in a heat exchanger. the numerical simulation on the flow and heat transfer characteristics for this new structure heat exchanger is conducted. the computational domain consists of two strip - coil sleeved tubes and two bare tubes oppositely placed at each corner of a square. the velocity and temperature fields in such strip - coil - baffled channel are simulated using fluent software. the effects of the strip - coil - baffles on heat transfer enhancement and flow resistance in relation to the reynolds number are analyzed. the results show that this new structure bundle can enhance the heat transfer coefficient up to a range of 40 ? to 55 ? in comparison with a bare tube bundle ; meanwhile, higher flow resistance is also accompanied. it is believe that the strip - coil - baffled heat exchanger should have promising applications in many industry fields

    介紹了一種用於強化管殼式換熱器殼側傳熱和支撐管束的螺旋折流片新型結構，該結構是對換熱器管子相間地套上螺旋折流片以產生旋渦流動.研究模型是在正方形布置的4個管子中的2個對角管子套上螺旋折流片后形成的通道，利用fluent軟體對該上述四管通道模型的流場和溫度分佈情況進行了數值模擬;分析了四管通道模型中螺旋折流片對強化傳熱和流動阻力隨雷諾數的變化關系的影響.算例結果顯示該新型結構可比相同尺寸的光管通道中的情形傳熱系數提高約40 ? 55 ? ，同時也將伴隨較高的流動阻力.可以相信螺旋折流片式換熱器將會在許多工業領域有良好的應用前景
  7. Abstract : a novel strip - coil - baffle structure used to enhance heat transfer and support the tube bundle for a tube - shell heat exchanger is proposed. the new structure can sleeve the tubes in bundle alternatively to create a vortex flow in a heat exchanger. the numerical simulation on the flow and heat transfer characteristics for this new structure heat exchanger is conducted. the computational domain consists of two strip - coil sleeved tubes and two bare tubes oppositely placed at each corner of a square. the velocity and temperature fields in such strip - coil - baffled channel are simulated using fluent software. the effects of the strip - coil - baffles on heat transfer enhancement and flow resistance in relation to the reynolds number are analyzed. the results show that this new structure bundle can enhance the heat transfer coefficient up to a range of 40 ? to 55 ? in comparison with a bare tube bundle ; meanwhile, higher flow resistance is also accompanied. it is believe that the strip - coil - baffled heat exchanger should have promising applications in many industry fields

    文摘:介紹了一種用於強化管殼式換熱器殼側傳熱和支撐管束的螺旋折流片新型結構，該結構是對換熱器管子相間地套上螺旋折流片以產生旋渦流動.研究模型是在正方形布置的4個管子中的2個對角管子套上螺旋折流片后形成的通道，利用fluent軟體對該上述四管通道模型的流場和溫度分佈情況進行了數值模擬;分析了四管通道模型中螺旋折流片對強化傳熱和流動阻力隨雷諾數的變化關系的影響.算例結果顯示該新型結構可比相同尺寸的光管通道中的情形傳熱系數提高約40 ? 55 ? ，同時也將伴隨較高的流動阻力.可以相信螺旋折流片式換熱器將會在許多工業領域有良好的應用前景
  8. The results of 3d viscous numerical simulation show that the efficiency of new lpt decreases 2. 3 percent under the low reynolds number condition, which was compared with that of design point

    三維粘性數值模擬的結果顯示新低壓渦輪效率在高空低雷諾數情況下比設計點下降2 . 3個百分點。
  9. As to the gas phase flow field, author chooses the standard k - model, the realizable k - model and the reynolds stress model to make simulation and comparison

    對于氣相流場，本文作者針對k -雙方程模型，可實現性k -雙方程模型以及雷諾應力模型進行了模擬比較。
  10. In this thesis, the strongly swirling turbulent flow in gas - solid cyclone separators is simulated using the standard k - ? rng k - and reynolds stress equation models ( dsm ). it is demonstrated via comparison between the simulation results with experimental data that the dsm model is superior to the other models

    針對分離器內部的這種復雜氣-固兩相湍流運動，本文採用了標準k -模型、 rngk -模型和雷諾應力模型（ ssg ） ，利用貼體網格技術，模擬計算了分離器內部流動，並將計算結果與實驗數據進行分析、比較。
分享友人
分享到 Line

分享到臉書