電位調節器 的英文怎麼說

中文拼音 [diànwèidiàojiéqì]
電位調節器 英文
cathode potential regulator
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  2. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  3. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  4. Multiferroelectric magnetoelectri materials have a spontaneous polarization that can be reoriented by an applied electric field, a spontaneous magnetization that can be reoriented by an applied magnetic field. these materials have been exploited as transducer, waveguides, switches, phase inverters, modulators, etc. which also find a lot of technological applications in radioelectronics, optoelectronics, microwave electronics in instrumentation

    這類材料同時具有鐵電和鐵磁材料的性能可以應用到傳感器，波導器件，轉換器，相位倒相器，變頻器，調節器等，在無線電電子學，光電子學，微波電子學等領域的發展具有重要意義。
  5. Interference between myopotentials and pacemakers is well recognized, especially in a unipolar pacing system

    摘要骨骼肌收縮所產生的肌電位可能會對心律調節器產生干擾，尤其是在單極性之心律調節器。
  6. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  7. A memorial rearview mirror and chair control rout is studied, which can adjust, memorize and resume the position of rearview mirror and chair

    摘要研究了一種能電動調節后視鏡和座椅位置，並能記憶存儲和調用位置信息的記憶存儲式后視鏡和座椅控制器。
  8. This paper firstly introduces the control principle of magnetically controlled reactor, presents a retifier ' s monitor and control system of high potential based photoelectric convert according the demand of the electric reactor ' s system, the design and the implementation of the hardware and the software is given

    介紹了磁控式可控電抗器的控制調節機理，並根據其系統的需求提出了一種基於光電轉換的高電位整流器的監控系統，並給出了其硬體和軟體的設計和實現。
  9. For a class of shunt - wound active power line conditioner, based on analysis of mathematical model of system and target of control, the algorithm of fuzzy variable structure sliding mode control is presented. the control algorithm can avoid complicated calculation of harmonic electric current in traditional control algorithm, and realize the feedback control of electric current. the algorithm is simple and easily implemented

    針對一類並聯型有源電網調節器在分析系統數學模型和控制目標的基礎浙江大學博士學位論文上，提出了模糊滑模控制策略，避免了傳統控制方法中復雜的諧波電流計算，實現對電源電流的閉環控制，該演算法簡單、易於實現，模擬結果證實了變結構滑模控制的有效性。
  10. Electrical zero uster

    電零位調節器
  11. The signal strength necessary for the switching operation and thus the switching point can be adjusted precisely via adjustments in the electronics ; in principle the switching and reset point can be adjusted separately

    開關操作所需的信號強度換句話說開關點可以通過電子調節器精確校準開關點和復位點可以分別進行調較。
  12. When the level of the mic input is too big, and can ' t be controled by the mic input level adjustmeng potentiometer, push down this button

    話筒輸入衰減按鍵:當話筒輸入電平太大，話筒輸入電平調節電位器已無法控制時，按下此鍵
  13. Due to the component of natural gas is very complex in different zone of our country, the product has taked on special design, it set up moore component factor of thirteen kinds, which offer user to select and setup, so as to satisfy measurement for contains various component natural gas, at the same time established many take - pressure way in order to suit to different measure device, and have automatic calculate and display super - compression factor function

    A q型操作器輸出svout ： 010ma 420ma 05v 15v信號，可直接驅動執行機構變頻器或再由伺服放大器去驅動電動調節閥門或由電氣轉換器和閥門定位器去驅動氣動薄膜閥。操作器處于自動工作狀態時，其信號輸入svin和操作輸出信號相當於是直通的。以實現dcs系統或調節器對執行機構的自動控制。
  14. The main module of sensorless pmsm vector control such as voltage sensing, current sensing, smo rotor position estimation, speed calculation, generation of sine and cosine, vector coordinate transformation, pi regulators, svpwm vector modulation are all accomplished in the pwm interrupt service routines

    永磁同步電機無位置傳感器矢量控制的主要模塊如電壓采樣、電流采樣、滑模轉子位置估算、速度計算、正餘弦值生成、矢量坐標變換、比例積分調節器、空間電壓矢量脈寬調制等都是在pwm中斷服務子程序中完成。
  15. Specification for electrically operated automatic gas shut - off valves fitted with throughput adjusters, proof of closure switches, closed position indicator switches or gas flow control

    裝有流量調節器閉路開關檢驗閉合位置指示開關或氣流量控制器電動式氣體自動關閉閥規范
  16. Cathode potential regulator

    陰極電位調節器
  17. Two patients with dilated cardiomyopathy and persistent atrial fibrillation ( af ) underwent successful electrical cardioversion and atrioventricular ( av ) junction ablation, followed by implantation of a cardiac resynchronization therapy ( crt ) pacemaker with a biventricular pacing system

    摘要有兩位患有擴張性心肌病變合併持續性心房顫動的病患在經過電擊整流術，房室結電燒術，及放置心臟再同步化心律調節器后，得到有效的治療。
  18. In this paper, in order to solve the economic production of run - of - river hydropower plant, the new control mode of regulating the water - level of the forebay is introduced into the hydraulic turbine governor

    本文針對帶有前池的引水式電站經濟運行的需要，在水輪機調節器運行方式中引入前池水位調節這一新型控制方式。
  19. Note : if special features are required for actuators such as modulating positioners either for electric or pneumatic actuators, consult factory

    注意：如果要求執行機構具備特別的性能，如用於電動或氣動執行機構的調制位置調節器，請咨詢工廠。
  20. Three - phase full bridge controlled rectifier, filter circuit and the common loads " mathematics models are built and analyzed. according to the rate of the transition process, the controlled rectification power supply can be classified into fast response and slow response. based on identification of the transition processes using the slope method, the different fuzzy control strategy is adopted. the control method can meet the requirements of real time control and non - error regulation. the simulation results verify its practibility. after that. the design scheme based on dsp is introduced including the design of hardware and software flow chart. emc is an important aspect which can not neglected, so the designs of emc are summarized including hardware and software

    根據過渡過程的快慢將可控整流電源系統分為快響應過程和慢響應過程，本文在利用響應曲線斜率法辨以過渡過程的基礎上，分別針對快響應過程和慢響應過程採取了相應的模糊控制策略，以滿足快響應過程要求實時控制，快速跟蹤誤差變化，慢響應過程要求精確定位，無差調節的要求，模擬結果驗證了該方法的有效性，進而分析了用dsp實現該調節器的硬體電路和軟體流程的設計思路。
分享友人
分享到 Line

分享到臉書