電偏轉 的英文怎麼說

中文拼音 [diànpiānzhuǎn]
電偏轉 英文
electric deflection
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : 轉構詞成分。
  1. Defection distortion test chart of transparencies for television

    透射式畸變測試圖
  2. The compass needle if not deflected is no current flows in the wire.

    在導線中如果沒有流,指南針就不會
  3. The corresponding electric currents are used to deflect an electron beam in a cathode-ray tube.

    相應的流就用來使陰極射線管里的子束
  4. On the way they will be deflected by the electric field due to the charges within the atoms.

    它們沿途由於受到原子內部荷的場作用而發生
  5. There are two innovated points in this paper. the first is that we abandoned mechanical apparatus in deflexion, and this is good for signal ’ s disposal. the second is that we adopted nlc facility and this will largely lighten apt systerm ’ s size, weight and power consumption

    本論文的創新主要在於兩個方面: ( 1 )摒棄了機械式的控制,便於其後的信號處理。且該器件驅動壓低(約3伏) ,功耗小(毫瓦級/平方厘米) 。
  6. Lc apparatus almost meet all the needs of space optical communication such as weight, size, power consume, life, cost, driving voltage, intergration of optics and electricity, programe, optically take ? over aperture, beam scanning, deflexional range and so on. switches, deflexional facilities and scanning equipments which made with lc have been used in the system of labor in space communication. the only bug of lc apparatus is that their answer speed only get microsecond rate or submicrosecond rate. but it is practical for them to be used in special beam capture, scan, deflexion controling which don ’ t concerned with code rate and code type

    液晶器件幾乎滿足空間光通信的所有大的指標要求如重量、尺寸、功耗、壽命、成本、驅動壓、光集成、可編程性、光學接收孔徑、光束掃描和范圍等等。液晶光開關、光器、光掃描器已經開始應用於光纖通信的實驗系統中。液晶類器件應用於光通信的唯一重大缺陷,是其響應速度目前只能達到微秒級或亞微秒級,不過,在不涉及到碼型碼率的空間光束捕獲、掃描、、控制方面,液晶器件完全可能進入實用化。
  7. Influence of multipole deflection field on electron beam defocus

    多極場對子束散焦的影響分析
  8. Part 2 analyses beam landing shifts made by thermal deformations of a shadow mask and vibration of a new type of shadow mask - aperture grille. an automatic measurement system for cpt decolorization and a vibration measurement system for aperture grille are established. part 3 analyses the difference of perception and discrimination to color between the human eyes and ccd system, and develops a new method based on ccd technology to evaluate the screen white - balance

    主要內容分為三部分: ( 1 )分析著屏子束分佈與子槍、系統及蔭罩之間的關系,研製自動測試裝置,為設計和改進相關結構提供依據; ( 2 )分析蔭罩熱變形和振動對顯示屏色純度影響,建立了色純漂移自動測試裝置和張緊式蔭罩振動測試系統; ( 3 )分析了人眼與ccd對彩色刺激的不同響應,建立了基於ccd的顯示器全屏色純均勻性測試方法。
  9. Aberration of electronic lens made by electron gun and aberration of magnetic deflection system made by dy are comprehensively investigated, so is the shadow mask ' s effect on electron beam landing screen error. the conclusion can be get that, because the distribution of electron beam landing screen ( distribution of luminance ) is affected by many kinds of factors, it cannot get the correct function by calculation, and should be get by measurement instead

    全面分析了cpt子槍發射系統形成的子透鏡像差與磁系統形成的像差;分析了蔭罩的自身厚度與位移對子束著屏的影響,並由此得出結論,著屏子束分佈(即亮度分佈)受著許多因素的影響,理論分析是半定量的,著屏子束分佈需要用精確的測量儀器來測量。
  10. The effect on display characteristic made by thermal deformations of the shadow mask is comprehensively investigated. by using the electron beam distribution automatic measurement system with a micro - deflective coil, a concave spot in luminance distribution can be get. it changes its position when the shadow mask changes its form

    本文系統全面地分析了傳統蔭罩的各類熱變形對顯示屏特性的影響,利用本文研製的子束亮度分佈自動測試系統,附加一個微磁場,使相鄰兩子束打在同一顏色的熒光粉條,並形成一個亮度凹點,當蔭罩變形時,凹點位置作相應的位移,以此原理跟蹤測量凹點位移量,即可得到色純漂移動態變化曲線。
  11. The shadow mask is the critical component of the colour picture tube and the important component for the choice of colour, its function concentrates on the limitation of electronics bound diameter and the screening direction, the electronics bound which is sent by the electronics gun goes scanning, during the scanning process, we should guarantee every bound gathering into the small holes situated on the screen, then these bounds will point to the regularized position through the small holes on the flat mask, and then three basic colours will be produced, at the same time, those useless electronics will be blocked by the mask board

    平板蔭罩是彩色顯像管的關鍵部件之一,是一個重要選色元件,其作用是限制子束直徑和上屏方向,由子槍發射的子束在磁場的作用下進行掃描,掃描過程中必須使每個子束只能射中熒光屏上的為該束指定的那些小孔上會聚,並通過蔭罩上諸多的小孔分別打到各自對應的熒光質點上,發出三種基色(紅,綠,藍) ,而無用的子則被蔭罩板截獲。
  12. Special features for copying inputting originals auto paper select, auto scaling select, vertical horizontal independent anemographic magnification, final scale adjustment, copy density adjustment 7 degrees, scan start position adjustment, and copy position adjustment, top bottom bottom margin setting, mirror image, trimming, negative positive inversion, header, reference input, rotate image, sharpness, contrast, additional copy, scanning speed change

    自動用紙選擇,自動倍率選擇,縱向或橫向獨立縮放,倍率微調,復印濃度調整,掃描起始位置選擇,復印位置選擇,前後端空白選擇,消除框線,鏡像,正負片反,頁眉,參照列印,畫面,明兩度,對比度,追加復印,掃描速度選擇,子分頁可選配置
  13. According to results of calculations and experiments, main causes that contribute to vibration are founded, then puts forward improving measures of adding deflexed supporting and suspending nogs and making pipelines shunt - wound, finally completes improvement tasks following is the main works completed in this thesis : ( 1 ) this thesis sets up a mathematic model of steam pipelines, using ansys5. 6 limited - unit analyzing software, calculates the ten phase inherent frequency and the foregoing eight phases vibration types of four steam pipelines of the unit before dealt with

    為了解決八零三廠2號汽輪機四根主蒸汽導汽管道振動的問題,本文建立了相應的計算模型,並根據計算和實測結果,找出了振動的主要原因,提出了加裝支吊架和管道並聯的改進措施,完成了改造工作。本文主要工作是:建立導汽管計算模型,並應用ansys5 . 6有限元分析軟體,對機組四根導汽管治理前的10階固有頻率和前8階振型進行計算。
  14. Cable feathering angle

    纜水平
  15. Theory and experiments of bulk - wave acousto - electro - optical ( aeo ) device, involving one - dimension and multi - dimension, are systematically studied. the thesis includes the following contents : coupled - wave equation theory of aeo interaction, determination of the optimum operating mode of aeo device, geometrical relationships of the anisotropic acousto - optic interaction, design and experiment of the aeo device. finally, the optimum design of ao device with beam steering theory is also studied

    論文主要研究內容包括:一維和多維聲光效應的耦合波方程及其衍射效率計算公式的建立、一維和多維聲光器件最佳工作模式的選擇、聲光晶體反常聲光互作用幾何關系的計算、 ln一維反常聲光器件和kdp二維反常聲光器件的設計製作以及實驗測試、正常與反常超聲跟蹤聲光器的優化設計。
  16. Numerical simulation of electrostatic deflection spraying based rapid prototyping

    電偏轉拋射式快速成型工藝的模擬
  17. Finally, the paper presents the lyapunov - based decentralized control system because the piezo - electric steering system is complex dynamics and can ’ t know status of controlled plant

    最後,針對壓電偏轉系統系統動力學復雜和無法得到系統狀態量的問題,提出了分散式李亞普諾夫控制系統,設計了分散式自適應控制器。
  18. Development of csr injection and extraction deflector

    注入引出高壓靜電偏轉板設計
  19. Methods for the designation of electrostatic deflecting electrodes of cathode - ray tubes

    陰極射線管靜電偏轉極的命名方法
  20. The experiment was performed at the accelerator mass spectrometer ( ams ) beam line on hi - 13 tandem accelerator of ciae using the 64cu off - line rnb, so the beam can be analysed and identified by static deflection technique of ams. limited by the deflection capacity of the electrostatic analyser of ams, the maximum incident energy of 64cu beam had to be restricted to 80 mev in the coulex experiment of 64cu off - line rnb

    實驗是在中國原子能科學研究院hil串列加速器加速器質譜( ams )管道上完成的,利用ams靜電偏轉技術來分析鑒別束流成份,但是受ams管道靜分析器能力的限制,在離線放射性核束中最高只能使用入射能量為80mev的的cu束。
分享友人