電動勢平衡 的英文怎麼說

中文拼音 [diàndòngshìpínghéng]
電動勢平衡 英文
electromotive equilibrium
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 勢 : 名詞1 （勢力） power; force; influence 2 （一切事物力量表現出來的趨向） momentum; tendency 3 （自...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  1. By making some assumptions, collision frequency were presented. then the the flocculation kinetics model was established through population balance equation. comparison of experimental data and modeling results indicate that there are the same trend between the two. so the model can predict floes number and size during flocculation of yellow river ' s loess particles without using empirical parameters. the tem and sem were used to obsever floes in the study of floe structure. the flocculation was divided as flocculi, floc and floe aggregate. the floes structure model was established by assumption that particles position in floe accords with tetrahedron. the fractal dimension of model and experimental floes was found to be coincidentso the model can reflect the structure of flocs formed in flocculation of yellow river ' s loess particles by macromolecule flocculant at a certain extent

    最後，本文還對絮凝動力學和絮體結構進行了研究，在前人研究的基礎上，針對高分子絮凝黃河泥沙，對絮凝過程作了一些符合試驗條件的假設，建立了顆粒碰撞頻率表達式，應用了顆粒數量平衡方程，從而建立了絮凝過程的動力學生長模型，模型計算結果與試驗數據對比表明，二者趨勢一致，在沒有使用經驗參數的情況下基本上能夠描述黃河泥沙絮凝過程中絮體數量和尺寸分佈的變化過程；對絮體結構的研究中，應用掃描電子顯微鏡和透射電子顯微鏡對絮體進行了觀察，將絮體分為絮粒、絮團和絮網三個不同的生長階段，通過假設顆粒結合位置符西安建築科技大學博士學位論文合正四面體，建立了絮體結構模型，計算得到的模型絮體分形維數基本與試驗中的實際絮體相符，在一定程度上能夠反映高分子絮凝黃河泥沙生成的絮體結構。
  2. Static and dynamic trial experiments indicate that the system, not only can well simulate the prime governor and self _ equilibrium characteristics of a prime mover with its simple hardware line, small size and versatility, but also can highly improve the whole system ' s control precision, reliability and stability when compared with the system design of the analogy circuits

    靜態、動態測試實驗表明：該控制系統，不僅硬體線路大為簡化、體積小、通用性強，能夠很好地實現對原型調速器及原動機自平衡特性的模擬，而且與模擬電路的設計方案相比，整個系統的控制精度、可靠性和穩定性等大幅度提高，具有明顯的優勢。
  3. On the basis of the engage efficiency and lubricious conditions, theoretical transmission efficiency with the different drive ratios ( 1 / 50 and 6 / 31 ) of involute cylinder worm gears is analyzed. at the same time, the change trend of engage efficiency and transmission efficiency with different design parameters is discussed. the experimental investigation on transmission efficiency

    從漸開線蝸輪蝸桿傳動的嚙合效率和潤滑條件兩個方面對不同傳動比的漸開線圓柱蝸桿的傳動效率進行理論分析，並通過傳動比分別為1 / 50和6 / 31的漸開線圓柱蝸桿設計參數得到蝸桿潤滑條件的理論分析結果和蝸桿嚙合效率、傳動效率的變化趨勢，同時利用電測法對蝸桿傳動的傳動效率、潤滑油平衡溫度進行測試，將測試數據與理論計算結果進行對比分析，得出理論分析結果的正確性。
  4. In this paper, we at fist analyse the distribution of magnetic field in the permanent magnet synchronous motor which rate power is 800w and calculate parameters of this motor on the basis of the traditional approach to ca1culating armature reactance, we put forward a new method which is based on the iteration of the electromotive force equation, and name it after " electromotive oprce method "

    本論文運用有限元方法分析一臺800w稀土永磁同步電動機內部電磁場的分佈情況，計算出相應的電機參數。並在傳統的計算電樞反應電抗的基礎上提出了一種基於電勢平衡方程式的計算方法，本論文稱之為「電勢法」 。
分享友人
分享到 Line

分享到臉書