電動記錄儀 的英文怎麼說
中文拼音 [diàndòngjìlùyí]
電動記錄儀
英文
electric recorder- 電 : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
- 記 : Ⅰ動詞1 (把印象保持在腦子里) remember; bear in mind; commit to memory 2 (記錄; 記載;登記) writ...
- 錄 : Ⅰ名1 (用做記載物的名稱) record; register; collection; selections 2 (姓氏) a surname Ⅱ動詞1 (...
- 儀 : 名詞1 (人的外表) appearance; bearing 2 (禮節; 儀式) ceremony; rite 3 (禮物)present; gift 4 ...
- 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
- 記錄儀 : chart recorder
- 記錄 : 1 (寫下來) take notes; keep the minutes; record; write down; log; enter; read in 2 (當場記錄下...
-
2. practical meteorology : making weather observations ; encoding and decoding of codes in normal use ; manual and computerized plotting of weather charts ; preparation and dissemination of weather bulletins by microcomputers ; principles and exposure requirements of meteorological instruments ; simple fault detection and adjustment of instruments and autographic recorders ; upper - air sounding ; wmo and aftn aeronautical fixed telecommunications network message formats and telecommunications procedures ; handling telephone enquiries
2 .實用氣象學:天氣觀測編制與翻譯常用電碼以人手及電腦繪畫天氣圖使用微型電腦編排及傳送天氣報告氣象儀器原理及安裝條件儀器及自動記錄器的簡單故障檢查與校正高空探測,世界氣象組織及航空專用電信網電報格式及電信程序接聽電話詢問。The design of dynamic cardiogram record and data playback system
便攜式動態心電記錄儀及數據回放系統設計It is a professional manufacturer of series of linear motion bearings, flange linear bearings, lengthened flange linear bearings, linear slippers, linear guides linear shaft chromeplate non - chromeplate, precise linear guides aluminium support guides, spherical plain bearings rod ends, spherical plain radial bearings, bolt type roller and needle roller bearings. we also can make other nonstandard bearings at any time. our products are used widely in various industrial machineries of weaving, printing, medical, precise machine tool, packing, metallurgy, spaceflight, automatic recording instrument, etc
麗水市豪滾軸承製造有限公司座落在浙江麗水市水閣工業區,是一家專業生產:直線運動球軸承系列法蘭直線軸承系列加長型法蘭直線軸承系列直線滑塊系列直線導軌光軸鍍鉻不鍍鉻精密直線導軌系列鋁支撐導軌桿端關節軸承系列向心關節軸承系列螺栓型滾輪滾針軸承系列,隨時可訂做各種非標型軸承,產品廣泛用於紡織機械印刷機械電動工具醫藥機械精密機床包裝冶金航天自動記錄儀等各種工業機械的配套。Siemens vdo serves in the local china market covering the products of ems ( engine management system ), diesel system, tcu ( transmission control unit ), fuel rail, injector, sensor, fuel supply system, engine actuator, acu ( airbag control unit ), bcm ( carbody control module ), window lift motor, engine cooling module, abs motor, rke, instrument panel, audio system ( radio / cassette / cd ), navigation system, vdr ( commercial vehicle data recorder ), etc
在中國市場上,西門子威迪歐汽車電子中國的產品系列包括ems (發動機電噴管理系統) 、柴油機系統、發動機執行器、 tcu (自動變速箱控制單元) 、油軌、燃油噴嘴、傳感器、油泵、 acu (安全氣囊控制單元) 、 bcm (車身控制模塊) 、搖窗電機、發動機冷卻模塊、 abs電機、駕駛臺儀表、音響、導航和vdr (商用車行車記錄儀)等。Is a computer networks and automation technology provider, whose primary focus is in the marine and auto - control industry. we cooperate with east china shipbuilding institute ecsi, design and manufacture marine electrical equipment, ship automation networks. we are agent of most famous automation products and industry software, and provide a whole solution system to you
比太系統工程有限公司立足於開發生產和銷售自有品牌的自動化產品,同時與江蘇科技大學原華東船舶工業學院積極合作,共同開發船舶自動化監控系統電站管理系統軸溫測量與報警系統液位遙測船載航行數據記錄儀vdr等產品。The research of this thesis has the following characteristics : ( 1 ) the holter developed in this thesis can sample ecg data with high accuracy, high sampling rates, and also can sample several channels simultaneously, therefore the performance has been improved greatly. ( 2 ) this holter can analyze ecg data in real - time
本論文的工作有如下特點: ( 1 )研製的動態心電記錄儀可對心電數據進行高精度、高采樣率、多同道同步采樣,性能得到了很大提高; ( 2 )該記錄儀能夠對心電信號進行實時分析。Direct acting electrical measuring recorders
直接動作電測量記錄儀In this thesis, the development of a kind of new - type holter has been completed, and this holter has been put into practical application. this thesis also provides a good foundation for next development
本論文基本完成了一種新型多通道動態心電記錄儀的研製工作,為該型記錄儀投入到實際應用中奠定良好的基礎,也為下一步的研製工作做了很好的鋪墊。A new model about measuring harmonics on - line is proposed in this paper. after band pass filtering, sampling storage and the monitoring on - line with artificial neural network ( ann ), we can obtain the harmonics signal, which is used to compensate harmonics. using the basic principle of analog parallel harmonics measurement and a special multi - layer feedforward neural network, a corresponding harmonics measurement on - line is built
在本文中提出了一種新型電網諧波監測系統模型,通過帶通濾波器,采樣存儲器以及神經網路組成的監測系統可以實時監測電網諧波,當電網中的3次、 5次、 7次諧波超過容許值時,給出控制信號啟動以記錄儀記錄諧波,並可以控制諧波補償,最終達到監督電網,抑制諧波、減小諧波的目的。At present the identification signal of rolling bearing is based on analog monitoring system composed of analog instrument such as fft analyzer, amplitude analyzer and so on. the system has the shortcoming as follows : not enough friendly user interface, unitary function, under abundant analytical contents, poor generality, long developing period, high cost and so forth
目前對滾動軸承信號識別主要採用模擬監測系統,系統均由模擬量儀器組成,如fft分析儀、幅值分析儀電平記錄儀等,系統存在操作界面不夠友好,功能單一,分析內容欠豐富、通用性差、開發周期長、成本高等缺點。Specifications of self - balance recorders and indicators with electric contacts for industrial - process measurement and control systems
工業過程測量和控制用帶電接點控制裝置的自動平衡式記錄儀和指示儀技術條件This system is utilized the programmable controller ( plc ) bearing of substitution rule ( the figure is apparent the form, writing instrument, individual loop controller, the hand is holded the utensil and is reached to assist the bearing unit and await ), achieve the 29mw ' s cycle stream of water warmhearted water boiler, oxygen remover, warmhearted net system control system together with monitoring voluntarily of electric section together with control being living, the rule to call off greats quantity displays the bearing in that system, boiler, oxygen remover, the warmhearted net operation is achieved crt and is supervised completely, manipulates personnel staff is living inner place the control cabin completely completees failure - free operation and trouble removal operation. the predictive target of putting ino production queen is the boiler, oxygen remover, the warmhearted net is achieved comprehensive self - regulation, moreover be able to be over a long period of time, steady secure operation
本系統利用可編程式控制制器( plc )替代常規的儀表(數顯表、記錄儀、單迴路控制器、手操器及輔助儀表裝置等) ,實現29mw循環流化床熱水鍋爐、除氧器、熱網系統控制系統與電氣部分的自動監測與控制。在該系統中取消大量的常規顯示儀表,鍋爐、除氧器、熱網的運行實現crt全面監控,操作人員在控制室內全部完成正常運行及事故處理操作。投產后的預期目標是鍋爐、除氧器、熱網實現全面自動調節,並能長期、穩定、安全運行。Methods of evaluating the performance of electrical and pneumatic analog recorders and indicators for industrial - process measurement and control systems
工業過程測量和控制系統用電動和氣動模擬記錄儀和指示儀性能評定方法Electrical and pneumatic analogue chart recorders for use in industrial - process control systems - methods for performance evaluation
工業過程式控制制系統用電動和氣動模似圖表記錄儀.性能評定方法Methods of evaluating the performance of electrical and pneumatic analogue chart recorders for use in industrial - process control systems
工業過程式控制制系統用電動和氣動模擬圖表記錄儀性能的評定方法Electrical and pneumatic analogue chart recorders for use in industrial process control systems - guidance for inspection and routine testing
工業過程式控制制系統用電動和氣動模似圖表記錄儀.檢查和常規試驗指南Electrical and pneumatic analogue chart recorders for use in industrial - process control systems - part 1 : methods for performance evaluation
工業過程式控制制系統用電動和氣動模擬圖表記錄儀.第1部分:性能評定方法Electrical and pneumatic analogue chart recorders for use in industrial process control systems - part 2 : guidance for inspection and routine testing
工業過程式控制制系統用電動和氣動模擬圖表記錄儀.第2部分:檢查和常規試驗指南( 3 ) has solved two key techniques : ecg data record technology of the large capacity and low power consumption technology. ( 4 ) has realized present popular usb bus interface, and the liquid crystal of the large screen has been used as the display interfaces of holter. ( 5 ) has proposed the conceive of setting up the developing platform of holter
採用的演算法運算量不大,相對適用於低速嵌入式系統; ( 3 )很好的解決了兩項關鍵技術:大容量的心電數據記錄技術和低功耗技術; ( 4 )實現了當前流行的usb總線介面,並且使用大屏幕的液晶作為記錄儀的顯示界面; ( 5 )提出了建立動態心電記錄儀開發平臺的設想。The test signals are given by the signal generator and the characteristic curves are drawn by the x - y recorder. before the test, the coordinates of the x - y recorder are demarcated and the shifts of the test oil circuit are done manually. the parameters of the characteristics are also computed manually
在每次測量前需要手動標定x - y記錄儀的坐標以及切換測試項目間的油路,測試曲線繪制完成後也需要手動計算電液伺服閥的各項性能參數。分享友人