電場強計 的英文怎麼說

中文拼音 [diànchǎngqiángjì]
電場強計 英文
electric-field meter
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 場 : 場Ⅰ名詞1 （平坦的空地 多用來翻曬糧食 碾軋穀物） a level open space; threshing ground 2 [方言] （...
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. The experimental results showed that the extraction rate and mass transfer flux increased with the field strength increasing

    在自行設計的連續電泳萃取池內實驗研究了電場強度、兩相流速等因素對丁醇萃取率及傳質通量的影響。
  2. This paper discusses the most suitable design of the homocentric ball capacitor on the condition that the maximum pressure endurance is limited and the puncture field is strong

    摘要討論了在限定最大耐壓值及介質的擊穿場強的情況下，同心球形電容器的最佳尺寸設計。
  3. Next, in order to comprehand the electromagnetic characteristics and the dynamic characteristics of the new type of magnetic micromotors, the dissertation applied the concept of the magnetic scarlar potential of the irrotational magnetic fields and set up the mathmatic model for the inner magnetic field of the new type of motors from the basic equations and the boundary conditions of the motor magnetic field. oh the basis of the mathmatic model, the dissertation analized the various qualities of the magnetic field of the air gap between the rotor and the stator and gave a detailed calculation of the air gap ' s magnetic potential, magnetic field intensity, magnetic induction, the shape of the magnetic scarlar potential level surface, the distribution of the magnetic circuit, the magnetic induction the self - inductance and the mutual inductance of the coils

    其次，為全面了解這種新型電磁電機的電磁特性和動力特性，本文從電機磁場的基本方程及其邊界條件出發，應用無旋磁場的標量磁位概念，建立了端面搖擺式電磁微電機內部磁場的數學模型，並以此為基礎，詳細分析了電機氣隙磁場的各方面性質，對氣隙磁場的磁標位、磁場強度、磁感應強度、等磁位面形狀、電機工作磁路的分佈、電機的工作磁通量以及激勵繞組的自感和相互之間的互感進行了詳細的分析計算。
  4. The stresses and nonlinear deformations of thin strip - plate with two simply supported edges under the coupled action of the electromagnetic field arid mechanical load are calculated, the magneto - elastic effects on thin current - carrying strip - plate by the side current and electromagnetic induction density are studied

    由此計算分析兩邊簡支條形薄板在電磁場和機械載荷耦合作用下的應力與變形，研究側向電流和外磁場強度對載流條形薄板的磁彈性效應。
  5. While carrying out the scheme, at first, the basic theory of antenna, array antenna and electromagnetic absorption, the performance parameter of antenna and parabolic antenna are deeply researched. in conformity, the characteristic and calculation of aperture field and near - to - far - field transformation for radiation pattern are detailed analyzed. second, the factors such as, the amount of the antenna elements, mutual coupling between each element, ground and the buildings on earth ' s surface, which affect the performance of array antennas ’ resultant field are stressed discussed

    在系統實現過程中，課題首先從天線、陣列天線，以及電磁場計算方法的基本理論著手，分析了天線與拋物面天線的各項性能參數，以及天線的口面場和近-遠區輻射場的特點和計算;進而，更加深入的討論和研究影響天線陣列合成場強的各項因素，包括系統所使用的天線單元個數對陣列合成場的影響、天線單元之間由於互耦造成的影響、傳播過程中地面和/或地面建築物的影響等。
  6. The axial magnetic field distribution on center surface of contact gap and contact piece are calculated when the current is at peak. it can be found that the intensity of axial magnetic field and radial magnetic field uniformity are strengthened after the iron core is put into, this helps to improve the stability of the vacuum arc

    計算了電流峰值時觸頭間隙中心平面和觸頭片上的縱向磁場分佈，可以看出加入鐵芯后縱向磁場強度和徑向磁場均勻性增強，這有利於提高真空電弧的穩定性。
  7. In addition, electric field distribution of arc - quenching chamber is calculated in adopting anasys software and the largest electric field intention is analyzed under the impulsion voltage and infrequency voltage, then the size of insulation porcelain cover is determined

    採用anasys軟體計算了滅弧室電場分佈，並對沖擊電壓和工頻電壓下的最大電場強度進行了分析，確定了絕緣瓷套的尺寸。
  8. For special example, the closed form solutions for complex potentials in matrix and inhmogeneity regions are derived explicitly when interface containing single crack or rigid line, and the appropriate expressions of the electro - elastic field intensity factors at the tip of crack or rigid line are examined

    作為特例，求出了界面含一條裂紋或剛性線夾雜時基體和夾雜區域復勢的封閉形式解；同時計算了界面裂紋和剛性線尖端應力和電位移場強度因子。
  9. Basic standard for the calculation and measurement of electromagnetic field strength and sar related to human exposure from radio base stations and fixed terminal stations for wireless telecommunication systems 110 mhz - 40 ghz

    與人體暴露于無線通信系統110 mhz 40 ghz基地電臺和終端電臺相關的電磁場強度及sar的計算和測量基本標準
  10. Abstract : it is shown in this paper that distributions of electric fields in five measuring slots of uster evenness tester, and the errors caused by uneven electric fields were analysed. according to the results of measuring and analysing electric fields, a set of tests were made, and several estimation to the errors were given. at last, notices of operation were given

    文摘:實測了烏斯特紗線均勻度試驗儀上5個電容測量槽的電場強度分佈，分析了由測量槽不均勻電場所引入的誤差.系統地測試分析了第5號槽誤差，獲得了幾種誤差的定量估計.最後給出了正確使用儀器，避免測量誤差所應注意的幾點結論
  11. Through the analyzes of electromagnetic system of a axial symmetry by the method of electromagnetic vector potential, an eddy current field math model is build by triangle cell, this article has researched the effect of power frequency to eddy current density, penetration depth and the skin effect

    本文以電磁場矢量位有限元法為基礎對二維軸對稱場的磁場強度、渦流密度進行了計算求解，採用三角形單元和六面體單元建立了渦流場數學模型，研究了電源頻率對渦流密度、透入深度及集膚效應等場量的作用影響。
  12. Based on mastering the application of the finite element method and the engineering soft ansys applied to the electric field, the electric field intensity of different models are calculated, the optimization dimensions and improved measures are described in this paper. also, summarizing the electric field distributing character of every important part of the insulation structure when changed the size or shape. moreover, the calculation result is consistent with the test of a bushing sample

    在掌握有限元法在靜電場中的應用和深入研究工程軟體ansys用於電場模塊的基礎上，採用電場數值計算方法，計算出該套管在不同結構尺寸下的電場分佈及場強最大值點，設計出電場最優化方案，總結對絕緣結構各個部位進行優化時的電場分佈規律。
  13. But due to the difficulties of the theoretical calculation and the limitation of the technique of image display, only some two - dimensional graphs of electromagnetic field of a planar set of point charges or symmetrically and uniformly charged bodies, which ignores the boundary effect, are introduced in the present electromagnetics teaching materials, which brings much incovenience for the acquaintance of the electrostatic field

    然而，由於受理論計算和圖象顯示技術等因素的限制，目前的電磁學教材中，通常只能給出平面分佈的點電荷系或具有較強對稱性、忽略邊界效應的帶電體的電力線和等勢線的二維平面圖，這給靜電場分佈的感性認識帶來了一定不便。
  14. Recommended practice for instrumentation for magnetic flux density and electric field strength meters - 10hz to 3khz

    10hz - 3khz磁通密度檢測儀表和電場強度計的推薦實施規程
  15. Chapter one of the thesis introduces the vacuum structure, operation principle and electric arc characteristic of the vacuum killing arc room concisely, and retrospected the development of the vacuum killing arc room briefly, and indicated the research purpose and meaning of thesis at the same time. chapter two introduces the design process and manufacturing technology of the vacuum killing arc room possessing cup form horizontal magnetism touch head structure. electric magnetic field finite element, an analytical soft of ansoft company, and msc non - linear finite element, an analytical soft of marc of company, have been adopted to analyze the distribution state of the horizontal magnetic field between the touch heads, electric field intensity distribute state and temperature rise situation which the touch head produced

    論文的第一章首先是對真空滅弧室的結構、工作原理和電弧特性進行了簡明的闡述，同時對真空滅弧室的發展做了一個簡要的回顧，並表明了本論文的研究目的和意義;第二章介紹了杯狀橫磁真空滅弧室的設計過程和製造工藝;採用ansoft公司電磁場有限元分析軟體和msc公司marc非線性有限元分析軟體分析了觸頭結構產生的橫向磁場在觸頭間的分佈狀況、電場強度分佈狀況以及溫升情況。
  16. Specifications for magnetic flux density and electric field strength meters - 10 hz to 3 khz

    磁通量密度和電場強計的規格. 10hz - 30khz
  17. The electric field distribution at the cross is simulated and analyzing using the soft of ansys5. 7. then the electrophoretic method has been optimized. the electrophoresis and the volume of injection have been significantly controlled using this method

    設計了微通道電泳晶元的電泳操作方法，並用有限元分析軟體對在進樣和分離條件下，進樣口處的電場強度分佈進行了模擬分析，在此基礎上對電泳操作方法進行了優化，實現了進樣量和電泳過程的有效控制； 6
  18. Choose the good vacuum characteristic insulator, reduce the probable weakness ; 2. reduce the electrical field in the triple junction as possible 3. make the electrical field distributing along the surface more uniform

    總結提出了絕緣子設計的三點基本考慮： 1 、選擇真空性能好的絕緣子，減少可能存在的弱點； 2 、盡量降低三結合點電場強度； 3 、使電場沿絕緣子表面分佈盡量均勻。
  19. Some numerical results about the relations between the ground state energy and the coulomb binding parameter, the parabolicity parameter, and electric field strength are obtained

    通過數值計算方法，我們得到了基態能量和coulomb束縛參數，拋物線參數以及電場強度參數的關系。
  20. The simulation and experiment result indicate that the dual pole tool weakens the electric field at the side wall of the machined hole and hence leads to the reduction of hole taper and the improvement of the machining accuracy

    模擬計算和加工試驗表明，輔助陽極可以顯著減弱孔側面間隙區域的電場強度，從而有效地抑制發生在側壁的雜散腐蝕，減小孔錐度，提高加工精度。
分享友人
分享到 Line

分享到臉書