電壓強度 的英文怎麼說

中文拼音 [diànyāqiángdù]
電壓強度 英文
voltage strength
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 電壓 : voltage; electric tension; electric voltage
  1. The magnetostriction of bonded tb03dy07fe2 rod composites is 580x 10 " 6 at a field of 200 ka / m, and the magneto - mechanical coupling coefficient is 0. 40 at a bias field of 118 ka / m

    相對而言制備工藝參數對合金的電阻率和抗壓強度影響較小，其電阻率等於熔煉法制備的材料的電阻率的10000倍左右，抗壓強度約為150mpa 。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  3. Space charge properties of frp rod materials are influenced by temperature, field strength and high voltage application duration

    結果表明，在高壓直流電場作用下，芯棒材料內部積累的空間電荷的極性和密度受到溫度、電場強度和電場作用時間等因素的影響。
  4. The influence of burning system on the properties and structure of the ceramic capacitors has been studied under the certain temperature system, the optimum sintering temperature of the ceramics was primarily decided by the content of bi2o3 ? 3tio2. the sintering temperature dropped with the adding of bi2o3 ? 3tio2. at the range of suitable sintering temperature, slow heating and low temperature sintering can obtain fine grain and dense structure. it results in the improving of the breakdown voltage for the middle - high voltage ceramic capacitors

    研究了燒成工藝制度對電容器陶瓷性能和結構的影響，結果表明：在一定的升溫保溫時間下，瓷料的最佳燒結溫度主要取決于組成中bi _ 2o _ 3 ? 3tio _ 2的含量， bi _ 2o _ 3 ? 3tio _ 2含量的增加將降低燒結溫度；在合理的燒結溫度范圍內，慢速升溫和低溫燒結將有利於得到細晶緻密結構，從而改善中高壓陶瓷電容器的耐壓強度。
  5. Test method for physical - chemical properties of electrical carbon product. compressive strength

    電炭製品物理化學性能試驗方法.抗壓強度
  6. Test method for physical - chemical properties of electrical carbon product. radial mechanical strength

    電炭製品物理化學性能試驗方法.徑向抗壓強度
  7. This experiment studies the relation of ionic current signals and a / f ratio on different premixed pressure

    通過控制預混壓力和空燃比兩個參數變化，消除了由於發動機循環變動對燃燒狀態和離子電流強度的不穩定影響。
  8. In addition, electric field distribution of arc - quenching chamber is calculated in adopting anasys software and the largest electric field intention is analyzed under the impulsion voltage and infrequency voltage, then the size of insulation porcelain cover is determined

    採用anasys軟體計算了滅弧室電場分佈，並對沖擊電壓和工頻電壓下的最大電場強度進行了分析，確定了絕緣瓷套的尺寸。
  9. Based on the theories of hybrid / mixed finite element method, the generalized energy functional including stress, mechanical displacement, electric displacement, electric field and electric potential is used, with the electric - potential relations and the constitutive equations of piezoelectric materials constrained, hybrid energy functional including mechanical displacement, electric potential and stress is gained. moreover, splitting in - plane components and transverse components, the mixed energy functional in which mechanical displacement, transverse stresses and electric potential as basic variables is derived. with the use of surface stress parameters of sub - elements, the continuity of transverse stress at interfaces between layers is obtained

    在回顧雜交混合有限元理論的基礎上，從包括位移、應力、應變、電勢、電位移、電場強度六個未知量的廣義壓電材料能量泛函出發，通過約束電場強度?電勢關系、應力與應變及電場強度的關系，得到僅包括位移、電勢、應力三個未知量的雜交變分泛函，利用一般層合板的雜交混合變分原理，分離面內分量和橫向分量，導出以位移、橫向應力、電勢為未知量的壓電層合板的修正變分泛函，作為壓電層合板的雜交元列式的理論基礎。
  10. Aerospace series - elements of electrical and optical connection - test methods - part 219 : voltage strength for insulated terminal lugs and in - line splices

    航空航天系列.光電連接件.試驗方法.第219部分:絕緣終端電插片和內連接件電壓強度
  11. All the transmission lines of west - east electricity transmitting project are inevitable to crossing the high altitude and icing areas. for the reducing of the air pressure and the absolute humidity, the electricity strength of insulators will drop obviously. therefore, it must be considered the effect on the insulators " flashover voltage caused by the change of altitude and ice when the insulation cooperation of transmission lines are being designed

    「西電東送」工程的所有輸電線路都不可避免的要經過高海拔和覆冰地區，由於大氣壓力和絕對濕度的降低會使絕緣子的電氣強度顯著下降，因此在進行輸電線路的絕緣配合設計時必須考慮到海拔高度和覆冰的變化對絕緣子的閃絡電壓影響。
  12. Elements of electrical and optical connection - test methods - voltage strength for insulated terminal lugs and in - line splices

    電器和光學連接元件.試驗方法.絕緣終端接線片和連機拼合接頭的電壓強度
  13. Multifunction of testing voltage value, current value, rf value and transient current strength

    多用途測試電壓值，電流值，射頻值及瞬變電流強度等。
  14. However, when the applied bias voltage is located within negative slope regions of u - i curve, the superlattice will undergo a very fast dynamic process, changing from one stable state to another stable state. the superlattice exhibits temporal current oscillations in the negative differential conductivity region at fixed d. c

    當外加電壓使電流處于正微分電導區變動時，超晶格的高低電場疇之間的疇邊界不發生移動，只是相應的電場強度作些調整；當外加電壓使電流處于負阻區域時，超晶格將經歷一個穩態到另外一個穩態的動力學轉變。
  15. As the partial pressure of o2 increases the cathode voltage of the target increases in order to maintain the same current intensity and the sedimentation rate gradually decreases

    氧氣分壓的增大，維持同樣濺射電流強度的靶陰極電壓增大，薄膜的沉積速率逐漸減小。
  16. The displayer based on pic16f877 mcu, expanded the can communication circuit, the keyboard and the led. in the part of the software design, the intensity signal processing algorithm, the frequency signal processing algorithm and the keyboard program are conducted

    在二次儀表硬體電路設計中，詳細介紹了輸入電流電壓轉換電路、強度信號處理電路、頻率信號處理電路以及電源電路，數字電路部分以pic16f877為核心，擴展了can通訊介面，鍵盤及顯示部分。
  17. Match ratio tests are done by using cement and fly - ash as curing agent, which include making soft clay with different water content into different mixing ratio cement - stabilised clay, and mixing cement and fly ash to make different cement - fly ash stengthened clay to soft clay with ascertaining water content. afterwards unconfined compression strength is tested at different curing age. the microstructures and mechanisms of cement soil and cement - fly ash soil are studied by mean ", of x - ray and scanning electron microscope ( sem ) technology

    採用水泥和粉煤灰為固化劑在室內進行其配合比試驗，對含水量不同的軟粘土製成不同摻入比的水泥土以及對含水量值固定的軟粘土製成水泥、粉煤灰摻入量分別不同的水泥-粉煤灰加固土，並在不同齡期時進行無側限抗壓強度試驗；運用x射線衍射和掃描電子顯微鏡技術，對水泥土及水泥-粉煤灰加固軟土的微觀結構和機理進行分析。
  18. Transient overvoltage strength

    瞬間超電壓強度
  19. Rubber, vulcanized - determination of electrical breakdown strength and voltage resistant at commercial power frequency

    硫化橡膠工頻擊穿電壓強度利耐電壓的測定方法
  20. Aerospace series - elements of electrical and optical connection ; test methods - part 207 : voltage proof test ; german version en 2591 - 207 : 1996

    航空航天.光電連接件.試驗方法.第207部分:耐電壓強度
分享友人
分享到 Line

分享到臉書