電子擴散長度 的英文怎麼說

中文拼音 [diànzikuòsǎnzhǎngdù]
電子擴散長度 英文
electron diffusion length
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 擴 : 動詞（擴大） expand; enlarge; extend
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 電子 : [物理學] [電學] electron
  • 長度 : length; longitude; size; extent; footage
  1. The result is a rapidly growing proliferation of pointless emails that can increase to such an extent that they overload systems

    結果，該等無意義的電子郵件迅速擴散，其增長程度足以令系統負荷過重。
  2. For adapting to the need of industrialization and improving the properties of materials, the method of mechanical activation has introduced on the basis of traditional calcinations at high temperature. the stardard spinel limn204 is prepared by the mechanical activation - high temperature solid synthesis method. the thermodynamic property, the physical - chemistry performance and the producing techniques of. battery have been studied by means of thermogravimetry ( tg ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), scanning electric microscopy ( sem ) as well as various electrochemical analysis methods. studies show that synthesis temperature, calcinations time, recipe of raw materials, heat treatment and particle size of products are main factors affecting the performances of limn204 cathode materials. with the increment of synthesis temperature and time, the structure and crystal of products are getting to perfect

    隨著合成溫度和時間的增加，產物的結構和晶型越趨于完善，但在1100得到的產物有燒結和晶粒增大的現象，恆溫時間超過24h后對材料的性能影響不是很大； li mn比在0 . 95 1 . 05 2的條件下都可得到標準的尖晶石limn _ 2o _ 4 ，尤其當li mn比為1 . 05 2時，所合成的材料具有較好的電化學性能；通過兩段合成法制備的產物性能要比一段合成法法制備的產物性能好，而兩段間隔合成法比兩段連續合成法處理的材料性能更佳；顆粒的粒度隨著球磨時間的延長而減小，比表面昆明理工大學碩士學位論文摘要卻增大，粒度小且分佈范圍窄的材料有利於鏗離子的擴散。
  3. Generally the minority carriers accumulated by the cell are generated either directly from the p - n junction or the distance between the generated minority carriers and the junction is less than the diffusion length of the minority carriers

    通常的太陽電池收集的少數載流子要麼是產生於p - n結，要麼是少數載流子距離結的距離必須小於其擴散長度。
  4. The transfer of the carrier in photoconductor is anisotropy owing to the column structure of the film is anisotropy. on the basis of the new concept suggested in this paper, the maximum diffusion length in the lateral direction of the photo - carrier in the photoconductor ( which is related to the resolution of lclv directly ) as function of conductivities of both in lateral and normal directions in the film can be obtained as the expression as following. the nc - si / a - si : h photoconductor of lclv deposited and crystallized at low temperature of exactly 250 c stack column structure by al inducing a - si : h

    本文根據柱狀結構存在各向異性的特點，並根據半導體物理知識，推出光導層光生載流子橫向最大擴散長度（該擴散長度與液晶光閥光導層解析度直接相關）與薄膜橫向和縱向電導率關系的表達式為：由於a - si ： h在al金屬的誘導作用下在不高於250的溫度下即開始晶化，本文對用金屬al誘導非晶硅晶化制備的nc - si a - si ： h薄膜進行研究。
  5. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
分享友人
分享到 Line

分享到臉書