電子轉換開關 的英文怎麼說

中文拼音 [diànzizhuǎnhuànkāiguān]
電子轉換開關 英文
electronic change-over switch
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : 轉構詞成分。
  • : 動詞1. (給人東西同時從他那裡取得別的東西) exchange; barter; trade 2. (變換; 更換) change 3. (兌換) exchange; cash
  • : Ⅰ動詞1 (使開著的物體合攏) close; shut 2 (圈起來) shut in; lock up 3 (倒閉; 歇業) close down...
  • 電子 : [物理學] [電學] electron
  • 轉換 : change; transform; convert; switch
  1. This thesis firstly introduces new demands of aerial product logistics support under high - tech war and some defects of traditional logistics support, and puts forward a kind of system model of aerial product logistics support following data - sharing of cals, and emphasizes detm. secondly it sets forth application of step and xml in the ietm, researchs conversion of xml schema and relation schema, and simply researchs mapping of xml and express. afterword, a based - xml framework of info - transfer between different platform are presented, according to this framework, the author establish a archetypal system of helicopter information query system based xml and dbms

    本文首先介紹了現代高科技戰爭條件下對航空產品維修保障的新要求,概述了傳統的後勤保障技術的不足,遵循cals的數據共享的理念,提出了航空產品維修保障系統模型,重點研究了互動式技術手冊;接著分析了step標準和xml技術在製作互動式技術手冊中的應用,重點研究了肌模式和系模式之間的相互,初步研究了xml和express語言之間的映射系;然後,提出了基於xml的一種解決航空產品信息跨平臺傳遞的解決方案,給出了該方案的具體實現流程和詳細的通訊協議,並發了基於xul和數據庫的某型號直升飛機的信息查詢原型系統。
  2. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    路設計中,作者比較深入分析的內容有:基準路的原理及低壓下基準路的設計;振蕩器和控制路中尖峰脈沖噪聲抑制、兩分頻路及死區時間設定;驅動及模式選擇路中管的寬長比的選擇及模式點的設計。
  3. After analyzing the switching characteristic of mosfet, the object function of optimizing curve of the output capacitance coss is confirmed according to the switching loss caused by output capacitance coss, then the optimized curve of the output capacitance coss is ascertained by applying zoutendijk to seek the optimized value with constraint ; the simulation of switching circuitry and dc - dc circuitry is tested at different frequency in pspice, then the least square method is adopted to fit simulation curves to calculate corresponding energy data

    線路模擬軟體pspice中進行了mosfet路以及典型dc dc線路模擬測試,針對不同頻段的測試結果,採用最小二乘擬合法對模擬曲線進行擬合,計算出相應的能量數據,最後綜合模擬結果確定出減小器件損耗,提高dc0c線路效率的器件輸出容cob優化曲線。
  4. Secondly, the pressure sensor made by motorola co. ltd. in usa is chosen as the key part of the pneumatic - electric transducer. thirdly, the signal processing system of the pneumatic - electric is developed

    第三,研製了氣器的信號處理系統,設計有調零、增益調整、擴展量程等功能。
  5. With the development of electronic technology in the field of high - frequency and high - power, power mosfet is gradually enhancing its important status in semiconductor apparatus and is being widely applied in power converters as switch. with the increasing of the operating frequency ( > 200khz ), the energy loss caused by parasitic capacitance will affect the efficiency of power transforming in converters. especially in the applications of high frequency power supply using mosfet as main devices ( the unit of frequency is mhz ), the energy loss caused by the switch process will badly affect its efficiency

    隨著技術進一步向高頻的大功率用領域發展,功率mosfet在各種力半導體器件中的重要地位日益顯著,使用功率mosfet作為器件的功率路也日益增多,但隨著器件頻率的提高(大於200khz ) ,由器件極間容引起的能量損耗將會影響到功率路的能量傳輸效率,特別是在以mosfet作為器件的高頻感應加熱源中(工作頻率可達兆赫) , mosfet在過程中的能量損耗嚴重影響到源的效率,因此如何減小器件的損耗提高高頻功率線路的效率成為技術領域的重要研究課題之一。
  6. Harmonized system of quality assessment for electronic components. integrated analogue switching circuits. blank detail specification

    元件統一質量評審體系.集成模擬路.空白詳細規范
  7. As a new kind of motor, switched reluctance motor ( srm ) has a doubly salient structure, and its windings are only mounted on the stators. these characteristics bring srm lots of virtues : solid structure, high reliability and efficiency, good fault - tolerance, low cost etc. switched reluctance driver ( srd ) combined srm with modern power electronic technology and control technology

    磁阻機( srm )作為調速動機的新品種,採用定、雙凸極鐵心結構,並且只在定上裝有集中繞組,上無繞組或永磁體,具有結構簡單堅固、運行可靠、效率高、功率變簡單、容錯性好和成本低等優點。
  8. Si9979cs can directly transform the motor rotor magnetic poles ’ displacements detected by hall groupware into the on - off signals of the 6 mosfets to realize electronical switch

    Si9979cs可直接將由霍爾組件檢測到的磁極位置成為6個mosfet功率管的信號,實現向。
  9. Based on researches and developments of ec _ iscm ( integrated chain management ), we use method of component oriented software development, analyse good qualities and shortcoming of uml, acme and xml, present integrated method of these three languages, and focus on the application of translation from uml to xml in software of electron customs

    本文以集成供應鏈管理( iscm )軟體發項目為研究背景,採用面向構件的軟體發方法,分析了uml 、 acme和xml三種語言在發過程中的優缺點,並且提出了三者相互集成的方法,重點闡述uml到xml的軟體中的應用問題。
  10. Yet, most existing high speed on / off valves use electromagnet as their electicity - mechanism conversion element, and good performant electromagnets have to be imported from other countries, in such situation, it is difficity to make excelent high speed electromagnet valve made in our country, even if we can make good performant high speed electromagnet valve in our country, it still has the shortcoming of not high enough respond speed, too small placket and big volumeo in this thesis, a new high speed on / off valve is developed based on two types of existing valves, this new valve has higher respond speed, a little big placket and little volume o for the new valve, several main task was made out as below : a ) several types of high speed on / off were first analyzed, then the basic performance of the actuator of the new valve was analyzed

    高速閥是20世紀80年代發展起來的一種具有響應速度快、抗污染能力強、與路配合好等特點的一個良好的動力放大元件。但是現有的高速閥基本上採用磁鐵為?機元件,高性能的磁鐵又基本為進口,難以滿足高性能高速閥國產化的要求,即使是高性能的磁鐵式高速閥,仍存在著響應速度不夠大、口過小、體積較大的缺點。本文在現有兩種高速閥的基礎上,設計了一種新穎的高速閥,在提高其動態性能的同時,增大了閥的口,減小了閥的體積。
  11. Electronic switches, electronic changeover switches and electronic time switches for appliances and cord electronic switches

    、器具用電子轉換開關時間,以及拉線
  12. Key technologies and its mechanism for improving crystalline silicon solar cells in the scale manufacture have been researched in this thesis. after sioa surface passivation and forming gas treatment utilization in the scale manufacture, the surface recombination and series resistance of solar cells have been reduced while their open - circuit voltage, fill factor and efficiency improved

    本論文研究了提高晶體硅太陽池效率規模化生產工藝技術的主要環節和相機理,將sio _ 2表面鈍化、 forminggas處理用於規模化生產,降低了太陽池的表面復合速度和串聯阻,提高了壓、填充因效率。
  13. These results provide basal information and theories data for increasing the solar cell conversion, developing and exploiting the miniature photoelectron switching apparatus

    這為提高太陽能的與利用以及微型光器件的研製、發提供了基礎材料和理論數據。
  14. The main works are organized as follows : based on the switching function method and time domain simulations, the small disturbance transfer a characteristic through the converter is analyzed. because of the modulation effect of the converter, the small disturbance in the shaft of turbine generator will induce ac voltage component with the same frequency as the disturbance on the dc side. and the resulted ac current on the dc side will have the similar frequency shift when transfers to the stator of the generator

    主要內容包括: ( 1 )基於函數法和模擬分析,研究了機組上次同步頻率的小擾動,在hvdc交直流兩側響應的頻率特性- - - -上的小擾動經直流流器調制后,將會在系統直流側感應出與擾動同頻率的壓分量;直流側流擾動反映到交流定側,也將發生頻率偏移。
  15. Post insulators for switchgears and substation with nominal voltages greater than 1000 v ; co - ordination of the definitions for mechanical bending strength

    公稱壓1kv以上設備和變站用柱形絕緣
  16. Millimeter wave single pole multiple throw switch is one of the most important device in multi - channel system, widely applied to multi - beam radar, phase array radar system, electronic warfare system, and so on

    毫米波單刀多擲是毫米波多通道的重要部件,廣泛應用於多波束雷達、相控陣雷達、對抗技術等方面。
  17. The typical performance characteristics include : load transient response, efficiency, output voltage ripple, output voltage vs. load current, switching waveform, and soft - start time. the simulation results indicate that the ic has achieved the expectation, both function target and electrical characteristics. although there are unavoidable disadvantages of the project, it is a worthwhile and valuable experience

    在完成系統原理分析、總體架構設計及路設計的基礎之上,還應用hspice對各個路和整體路進行了模擬驗證,其中,整體模擬指標包括:軟啟動時間、瞬態響應時間、效率、輸出壓與負載的系、輸出壓紋波、波形。
  18. Testing methods of surface mounting switches for use in electronic equipment

    設備用表面安裝的試驗方法
分享友人