電導耦合器 的英文怎麼說

中文拼音 [diàndǎoǒugěqì]
電導耦合器 英文
conductive coupler
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. Semiconductor devices. harmonized system of quality assessment for electronic components. ambient rated photocouplers with phototransistor output. blank detail specification

    半導體器件.電子器件質量評估協調體系.帶光電晶體管輸出的特定環境溫度光電耦合器.空白詳細規范
  2. In some military application such as aviation 、 space flight 、 missile 、 radar and so on, the 10kv isolation voltage is needed, on the basis of it, linearity, capacity of driving load capacitance and reliability are presented

    同時，在航空航天、導彈、雷達等軍事應用上，對光電耦合器提出了10kv以上的隔離電壓的要求，在此基礎上，對線性度、驅動容性負載的能力以及可靠性都有很高的要求。
  3. 3. after the parameters of the array structure are got, simulation software, such as cst microwave studio, cts design studio and ansoft hfss, are used to design the power dividers for the radiation units in the horizontally polarized direction of the array. these power dividers adopt structure of coupling slots in the narrow side of main rectangular waveguides, in which the narrow side of the main waveguide and the broadside of secondary waveguides are crossed at locations of each slot

    3 .在得到滿足指標要求的陣列結構參數后，採用cstmicrowavestudio 、 ctsdesignstudio和ansofthfss等電磁模擬軟體對陣列在水平極化方向的行饋功分器進行模擬設計，該陣列的行饋功分器採用波導窄邊單縫耦合饋電結構。
  4. On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed

    本文在透鏡成像理論的基礎上，系統、深入地分析了共焦掃描顯微成像的機理，論述了應用單模光纖的激光共焦掃描顯微成像系統的優點；進行了總體方案的論證，並設計確定了單模光纖激光共焦掃描顯微成像系統的總體方案；從理論上推導分析了解析度要求與試驗系統中相關器件主要參數之間的關系，分析了系統耦合效率和漸暈現象對光學系統的設計要求；完成了方案中光學系統和二維掃描控制電路的設計，並在電路設計中採用了用軟體解決檢流計式光學掃描器（振鏡）非線性問題的新方法，能夠實現較為理想的二維模擬掃描；完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。
  5. The principles of laser technology, photo - electronic transformation technology and photo - electronic signal gathering technology were discussed in this paper, a new imaging laser threat warning device used in antagonizing laser - guiding weapon was designed and its main parts and circuit were described in detail

    本文闡述了激光技術、光電轉化技術以及光電信號採集技術的基本原理。根據來自激光制導武器的威脅，採用較為先進的光敏電荷耦合器件（ ccd ）和廣角遠心魚眼型透鏡的探測技術，以及幀存儲和幀減法技術。
  6. The research is focused on the influence of the size of the coupling port, coupling line and the capacitive metal rods in cutoff waveguide on the gap impedance

    研究結果表明：模雙間隙腔連接截止波導段的耦合口的尺寸主要影響輸出腔的外觀品質因數，而耦合接頭的粗細和電容性銷釘的大小和插人深度對截止波導濾波器的調諧具有重要影響。
  7. Characteristics analysis of electrical couplings between cylindrical combline resonators

    圓柱形波導梳狀線諧振器間電耦合特性分析
  8. In the case of thin slot, taking the effect of wall thickness into account, the coupler is analyzed with the slots replaced by equivalence magnetic current using the equivalence principle. the integral equation system is fonned and calculated by the moment method

    對于細長縫隙的情況，考慮了波導壁厚，利用等效原理將縫隙等效為磁流源在主波導和耦合波導中的作用，根據電磁場連續性條件建立積分方程，並用矩量法求解，進而求出耦合器的散射參數。
  9. A analysis of these effect to the pattern is presented. in the mean time, the method of correcting the phase errors is given by shortening or lengthening the section of sinuous feed line between couplers from the normal value. 6. the reflection characteristic of a serpentine is analyzed where the coupler is replaced by the equivalent of two ports loss network

    提出了用有耗二埠網路來等效波導耦合器的方法，對由耦合器、饋電波導和波導彎頭級聯的慢波線系統的駐波特性進行了分析計算，針對慢波線在設計測射頻率上大反射問題，討論了多種解決辦法。
  10. In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )

    與張瑞英博士一起，首次利用該種有源區結構制備出偏振不靈敏半導體光放大器，並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬，在不同信號波長，不同信號功率0 - 200ma的注入電流范圍內，偏振相關損耗均《 0 . 9db ，在耦合差損為7db / facet的條件下，最大fiber - to - fiher增益達10db ，無損操作電流為50 - 70ma ，消光比達50db以上，而噪聲指數則低於8db ，最小可達4 . 6db 。
  11. Plugs, socket - outlets, vehicle couplers and vehicle inlets - conductive charging of electric vehicles - part 1 : charging of electric vehicles up to 250 a a. c. and 400 a d. c

    插頭插座車輛耦合器和車輛進氣口.電動車輛的傳導充電.第1部分: 250 a交流及以下和400 a直流的電動車輛的充電
  12. The change of transformer ’ s output voltage with coupling coefficient is analyzed. the calculated formulas for parameters of air - core and part - magnetic - core pulse transformer are deduced based on electromagnetic theory. comparing with past formulas for calculated the parameters of the transformer, this formulas is more accurate to reckon the parameters of transformer

    首先從理論上分析了提高耦合系數對變壓器輸出電壓的影響，推導了高功率帶繞式空芯和部分磁芯脈沖變壓器的電感及耦合系數的計算公式，並與已有的方法進行比較，經實驗驗證，本文推導的方法能夠較準確地計算帶繞式空芯脈沖變壓器的參數。
  13. The author ? major contributions are as follows. 1. with the performance requirement ( the pattern of the antenna, the rang of scanning angle, the maximal sidelcbe level and the beam ~ vidth ) givcn, a method is presented to determine the basic parameters of a serpentine feed, which includes the distance and ~ vaveguide length bet ~ veeii t ~ vo couplers, the size of the arrays and the number of components

    根據天線的工作頻帶、掃描范圍、副瓣電平、半功率寬度等技術指標要求，給出了確定波導慢波線基本結構尺寸的計算公式，即對相鄰單元之間的空間距離、耦合器之間的饋線波導長度、陣列的大小和單元數的計算。
  14. First the mechanism how the imaging guided missile works is revealed secondly the atmospheric propagation of laser beam is studied thirdly the structure and damage mechanism of irccd is analyzed, finally we utilize the dynamic generating system to simulate the cdricm

    通過對成像制導導彈工作原理的分析，激光傳輸中遇到的各種大氣效應和紅外電荷耦合器件（ irccd ）激光干擾機理的分析，闡明了cdircm系統干擾成像制導導彈的機理，並利用動態場景生成系統對cdircm干擾進行了模擬。
  15. Abstract : optocoupler is also called optoisolator, it is a semiconductor device which allows electric signal transfers between circuits or systems, meanwhile it can ensure the electric insulation between the circuits or systems each other

    光耦合器也稱為光隔離器，它是允許電信號在電路或系統之間傳輸的半導體器件，同時確保這些電路或系統彼此之間電絕緣。
  16. The high - voltage isolation optocoupler has been developed successfully, and its characteristics have been analyzed, it has some excellent merits, such as simple structure, working on stable status and high speed and so on. it will be extensive applied in high - voltage working environment extensively. 3 ) adopt hollow taper cavity to conduct the light in order to improve the stability and reliability of the high - voltage isolation and linearity optocoupler that can ’ t run very well

    3 、針對高壓隔離線性光電耦合器的穩定性、可靠性不佳的狀況進行研究，提出了解決辦法，設計了空心錐腔進行導光，研製出了高穩定性、高可靠性的高壓隔離線性光電耦合器，對該器件的性能進行了分析，與改進前相比，穩定性、可靠性都有較大提高。
  17. Ccd ( charge coupled devices ) is a semiconductor photoelectric device with particular performance, which is applied widely in some fields such as camera and industry measurement and so on recently

    Ccd （電荷耦合器件）是一種性能獨特的半導體光電器件，近年來在攝像、工業檢測等科技領域里得到了廣泛的應用。
  18. Charge coupled devices ( ccd ) is a photoelectric device with high performance, which is widely applied in many areas, including astronomical imaging, entertainment and manufacturing, etc. the geometrical measure with ccd has an advantage on achieving high accuracy, dynamic detection and non - contact measurement

    電荷耦合器件（ ccd ）是一種高性能的半導體光電器件，近年來在天文攝像、消費電子、工業檢測等領域里得到了廣泛的應用。將ccd技術應用於幾何量測量可以實現高精度、在線動態檢測和非接觸測量等要求。
  19. Semiconductor opto - electronic module detail specification for type gh83 opto - couplers

    半導體光電模塊gh83型光耦合器詳細規范
  20. The device is a synthetical applicating example of phase modulator, intensity modulator and directional coupler theory. the characters and fabricating process of linbo _ 3 optical waveguide, electrodes design principle, the influence of sio _ 2 dielectric buffer layer on the performance of the device and design principle of tapped power ( ratio ) are analyzed

    該器件是相位調制、強度調制和定向耦合器理論綜合應用的典型，文章從理論上分析了linbo _ 3光波導的特點、製作工藝、電極設計原理、 sio _ 2介質緩沖層對器件性能的影響和抽頭功率的設計原理等。
分享友人
分享到 Line

分享到臉書