電工器件 的英文怎麼說

中文拼音 [diàngōngqìjiàn]
電工器件 英文
electrical accessories
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 工 : Ⅰ名詞1 （工人和工人階級） worker; workman; the working class 2 （工作; 生產勞動） work; labour 3 ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 電工 : 1 （電工學） electrical engineering; electrotechnics2 （製造、安裝電氣設備的工人） electrician電...
  1. The paper analyses the principle of variable frequency source and brings forward that using electric electron technology make variable frequency output, and using high power dynatron that is parallel connection magnify power

    文中對該變頻電源的工作原理及主要硬體作了較詳細的介紹；提出利用電力電子器件實現輸出大功率。
  2. Determining pinhole density in photoresist films used in microelectronic device processing

    微電子器件加工過程用的光刻膜中針孔密度的測定
  3. However, in our nation, the research on gan - based microelectronic devices is in the early stage, and a great deal of vestigation is still needed to perform on separative processes of gan devices. due to the lack of algan / gan heterojunction materials in the country, a few researches on algan / gan were made, and the investigation on schottky rectifiers is much less

    在國內， gan基微電子器件的研究剛開始起步，制備gan分立器件的工藝尚處于探索研究階段，特別是受algan gan二維電子氣材料來源的限制，國內algan gan基的場效應晶體管的研究開展得較少，關于肖特基整流二極體的研究更少。
  4. This paper summarizes the present situation of modern microelectronic device is. with integrated degree of circuits increasing, and the characteristic sizes of technics minishing as well as the device sizes turning into sub - micron and deep sub - micron, there are many problems

    概述了現代微電子器件發展的現狀，電路集成度的不斷提高，加工工藝特徵尺寸的不斷減小，器件尺寸進入了亞微米、深亞微米階段，出現了許多不良效應。
  5. Vertical - cavity surface - emitting lasers ( vcsel ' s ) have distinct advantages over conventional edge emitting lasers, such as small divergence angle, single longitudinal mode operation and very low threshold current. they are especially suitable for making two - dimensional ( 2 - d ) arrays as well as vcsel ' s based integrate devices

    垂直腔面發射半導體激光器（ vcsel ）與傳統的邊發射半導體激光器相比，它具有發散角小、單縱模工作、非常低的閾值電流等優點，尤其它適於二維面陣集成和與其它光電子器件集成。
  6. It is a special unit to produce electric materials, apparatus and accessories of wires and cables. all of our products up to standard have been examined by the quality examining and testing centre for electric engineering material accessories of the state ministry of power industry

    1985年， 1994年改制為股份合作制， 2001年改制為有限責任公司，是專業生產電力金具電工器材電線電纜附件的單位，產品經電力工業部電力工程材料部件質量檢驗測試中心檢測為合格。
  7. Recently, electron component is being high speed and high frequency to result in increasing of heat productivity along with rapid development of electron technology

    近年來，隨著電子工業技術的迅猛發展，電子器件由於高速、高頻化，導致發熱量的增加。
  8. Basing on other researchers ’ work, this paper has put forward a novel type of icc ( induced current cancellation ) shielding layer for rfic / mmic performance improvement, to reduce high frequency loss, increase q value, and expand its application frequency range. and present how to realize rfic / mmic components such as i / o pad, inductors, baluns and so on by applying icc shielding layer structures. furthermore co - design methods of ic component structure and foundry process structure designs has been presented in this thesis

    在無線通信技術對cmos射頻/微波集成電路需求的大背景下，本論文提出了用於高頻集成電路（ rfic / mmic ）器件的各類新型icc （ inducedcurrentcancellation ，感應電流相消）屏蔽工藝結構，由此設計製造的ic部件解決了傳統半導體工藝無法實現射頻/微波集成電路的難題，以達到降低高頻集成電路器件的高頻損耗，提高器件q值以及擴寬器件應用頻帶的目的。
  9. Theory and experiments of bulk - wave acousto - electro - optical ( aeo ) device, involving one - dimension and multi - dimension, are systematically studied. the thesis includes the following contents : coupled - wave equation theory of aeo interaction, determination of the optimum operating mode of aeo device, geometrical relationships of the anisotropic acousto - optic interaction, design and experiment of the aeo device. finally, the optimum design of ao device with beam steering theory is also studied

    論文主要研究內容包括:一維和多維聲電光效應的耦合波方程及其衍射效率計算公式的建立、一維和多維聲電光器件最佳工作模式的選擇、聲電光晶體反常聲光互作用幾何關系的計算、 ln一維反常聲電光器件和kdp二維反常聲電光器件的設計製作以及實驗測試、正常與反常超聲跟蹤聲光偏轉器的優化設計。
  10. Receive supplier, guard a pass for the quality of company product, carry on an electronics spare part, equipments the purchase of various zero accessorieses etc. work

    接待供應商，為公司產品的質量把關，進行電子器件、設備各種零配件的采購檢驗等工作。
  11. 1. 20m - 60m mica powder is mainly used in electric welding ; 2. 60m - 325m is used in mica ceramics for its good performance in insulation, maintain uncarbonized under strong electric arc, long time performance in the heat of 350c. its heat expansion coefficient is adjustable as required

    工業上主要利用它的絕緣性和耐熱性，以及抗酸抗堿性抗壓和剝分性，用作電氣設備和電工器材的絕緣材料其次用於製造蒸汽鍋爐冶煉爐的爐窗和機械上的零件。
  12. Motor are widely used in industrial automation, office automation and household automation, most of which use electric power and computer control

    特別是在工業自動化、辦公自動化和家庭住宅自動化方面使用大量的控制電機，幾乎都採用電力電子器件進行微機控制。
  13. Flexibility, processability, low cost, interesting optical - electric properties and so on make organic materials be a good substitute for inorganic ones. modification of inorganics by organics can change surface properties of inorganics, for example, frictional, optical, electrical, chemical and biocompatible properties. on the other hand, many interests have been shown to integration of functional organics in si - base devices because of their great promise in optoelectronic, micro - electronic and sensor applications

    通過對無機半導體材料進行有機改性，可以改變無機材料的表面化學性質，生物相容性質，光電性質等等，因此，有機無機復合材料在光電器件、生物傳感、微電子器件的應用領域有著很好的應用前景，尤其是在微電子工業中廣泛使用的硅材料與有機光電材料的復合更是備受關注。
  14. Council, joint electronic device engineering jede

    電子器件工程聯合會
  15. In this paper, they are set forth at first that the kinds of computer - simulation of electronic devices, the development and the requirements of mosfet ' s model and the way of gain the models " parameters, the dc models have been bui it in chapter 2 and the models of big signals have been deduced in chapter 3, they are different from the equivalent circuit models in the traditional software pspice that they come from the numer i ca i - s i mu i at i on wh i ch is based on the essence equat i on, so the precision of simulation is enhanced ? mosfet ' s small signal models of low frequency, intermediate frequency and high frequency have been built in chapter 4 and chapter 5, although the equivalent circuit models in pspice are used for reference to bui id them, they have their own characteristics which are analyzed at a i i kinds of situations, so that the simulation software for mosfet can be written according them and it i s a i so benef i c i a i for us to catch the gen i us character i st i cs of mosfet and to d esign all kinds of applicable devices the correctness of the models is simply proved in chapter 6

    本文首先介紹了電子器件計算機模擬的分類、 mosfet的建模發展動態、對器件模型的要求以及模型參數的提取方法。在第二章中建立了mos晶體管在直流端電壓條件下的工作模型；第三章推導了mosfet的大信號模型，這兩類模型不同於傳統模擬軟體例如pspice中的等效電路模型，而是從模型方程出發，採用數值模擬的方法，提高了模擬的精度。第四章和第五章分別建立了mos晶體管低頻、中頻、高頻的小信號模型，雖然借鑒了pspice模擬軟體中用等效電路模型的方法，但是本文分別討論了準靜態和非準靜態時器件的本徵部分以及包含非本徵部分工作于低頻、中頻和高頻條件時的模型，可以根據這些模型編寫相應的模擬軟體，這樣在做器件的模擬分析與器件設計的時候，就可以利用模擬軟體逐步深入地分析器件在不同的條件下和器件的不同部分在工作時的各種小信號特性，有利於抓住器件工作的本質特性，設計出符合要求的各類通用和特殊器件。
  16. Along with silicon ulsi technology has seen an exponential improvement in virtually any figure of merit, as described by moore ’ s law ; the miniaturization of circuit elements down to the nanometer scale has resulted in structures which exhibt novel physical effects due to the emerging quantum mechanical nature of the electrons, the new devices take advantage of quantum mechanical phenomena that emerge on the nanometer scale, including the discreteness of electrons. laws of quantum mechanics and the limitations of fabrication may soon prevent further reduction in the size of today ’ s conventional field effect transistors ( fet ’ s )

    隨著超大規模集成電路的的發展，半導體硅技術非常好地遵循moore定理發展，電子器件的特徵尺寸越來越小;數字集成電路的晶元的集成度越來越高，電子器件由微米級進入納米級，量子效應對器件工作的影響變的越來越重要，尺寸小於10nm將出現一些如庫侖阻塞等新特性。量子效應將抑制傳統晶體管fet繼續按照以前的規律繼續減小。在這種情況下，宏觀的器件理論將被替代，可能需要採用新概念的晶體管結構。
  17. Test methods for microbiological monitoring of water used for processing electron and microelectronic devices by direct pressure tap sampling valve and by the presterilized plastic bag method

    用直接加壓分接抽樣閥和用預先消毒塑料包法對電子和微電子器件加工用水微生物監測的測試方法
  18. Based on this, the optimum operating mode of ln anisotropic one - dimension aeo device is determined as : light promulgates along z axis, ultrasonic wave promulgates along x axis, and direct current electric field is loaded along y axis

    經過計算，一維鈮酸鋰反常聲電光器件的最優化工作模式為:光沿著z軸方向，直流電場沿y方向，超聲波為沿著x軸方向的快切變波模式。
  19. Railway applications - electric equipment for rolling stock - part 2 : electrotechnical components - general rules

    鐵路應用機車車輛電氣設備第2部分：電工器件通用規則
  20. Railway applications - electric equipment for rolling stock - part 3 : electrotechnical components - rules for d. c. circuit - breakers

    鐵路應用.機車車輛電氣設備.第3部分:電工器件.直流斷路器規則
分享友人
分享到 Line

分享到臉書