電弧變流器 的英文怎麼說

中文拼音 [diànhúbiànliúqì]
電弧變流器 英文
arc converter
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 弧 : 名詞1. [數學] （圓周的任意一段） arc2. （古代指弓） bow
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Analyzing the variation of the nozzle arc parameters at current zero, in addition, analyzing the breaking property of the studied circuit breaker on the basis of the theory

    分析了電流過零時噴口內電弧參數變化的原因，此外，從理論上對所研究的斷路器的開斷性能進行了分析。
  2. The tap - changer is made with solid state relay as its working mechanism and controlled by microprocessor. this switch has totally cancelled the mechanical drive organization, by the microprocessor according to the voltage of second side microprocessor decide the working condition of solid state rely, high regulation speed, need not transition resistor, rush current is low. operating frequently ; there is no electric arc to produce, can put in the fuel tank of the voltage transformer directly ; the structure is simple, the fabrication cost is low, benefit and use widely among the voltages transformer of distribution

    其中的有載調壓分接開關，它是一種完全由固態繼電器作為分接開關執行機構，由單片機控制的有載自動調壓的變壓器分接開關。該開關完全取消了機械傳動機構，由單片機根據變壓器二次側電壓的高低，決定與變壓器各分接頭聯接的固態繼電器的工作狀態。調節速度快，改變分接頭時不需過渡電阻，沖擊電流小，可頻繁操作；無電弧產生，可以直接放在變壓器油箱中；結構簡單，造價低，便於在配電變壓器中推廣使用。
  3. An principle analysis to parallel connection circuit of output rectification circuits of arc welding inverter

    弧焊逆變器輸出整流電路的並聯問題及分析
  4. This machine adopts high - level siemens plc concentration control, set up with computer controlled gear shifting vacuum gauge, and a three - flow controller, one set of contra - variant bias power and four - route contra - variant arc power supply, four side - installed heating tubes, computer pid automatic temperature control device, 60 and 100 two kinds versatile arc supply

    該設備採用先進的西門子plc集中控制，裝有電腦自動換檔真空計和三路流量控制器，一套逆變偏壓和四路逆變弧電源，邊裝式加熱管四支，電腦pid自動控溫， 60和100兩種弧源通用。
  5. This machine adopts japanese pro - face touch screen and mitsubishi plc control technology. in addition, it is set with automatic gear - shifting vacuum gauge, a two - flow controller, side - installed heating tube, computer pid automatic temperature control, and 32 sets contra - variant arc power supply and contra - variant bias power. they are widely used in plating different thick film layers of mono - metal and many compound film layers

    該設備採用日本pro - face觸摸屏和三菱plc集中控制裝有電腦自動換檔真空計，兩路流量控制器，邊裝式加熱管，電腦pid自動控溫，配備32隻逆變式弧電源和逆變偏壓，適用於鍍制各種特種單金屬厚膜層或多鐘金屬復合膜層。
  6. In recent years, current rectifiers, frequency converters, arc furnaces and other power electronic devices etc have been increasingly used in power network. with nonlinear, impactive, unbalanced characteristics, they generate lots of harmonics and cause distortion in power network current or voltage

    近年來，配電網中整流器、變頻裝置、電弧爐以及其它電力電子設備等的應用不斷增加，由於這些負荷具有非線性、沖擊性和不平衡的用電特性，引起供電網中的電流（電壓）畸變，產生大量諧波。
  7. As technique of power electronics develops, the load with nonlinear, impactive, unbalanced characteristics such as current rectifiers, frequency converters, arc furnaces have been increasingly used in power network in recent years. they generate lots of harmonics and cause distortion in power electrical network current ( voltage )

    隨著電力電子技術的發展，近年來電網中象整流器、變頻器、電弧爐這樣具有非線性、沖擊性和不平衡用電特性的負荷不斷增加，引起供電網中的電流（電壓）畸變，產生大量諧波。
  8. And based on the simulation of dynamic arc characteristics during the interrupting process, the interactive mechanism of the arc and high velocity gas flow has been deeply analyzed, the variation of the gas flow parameters under the condition of arc clogging and interaction of arc and shock wave have been studied

    在斷路器開斷過程動態電弧特性模擬的基礎上，深入解析了電弧與高速氣流的相互作用機理，研究了電弧堵塞情況下噴口氣流參數的變化，電弧與激波的沈陽工業大學博士學位論文摘要相互作用等。
  9. In this thesis, an arc sensor based on fuzzy control is designed. through the change of welding current in waving, the arc sensor judges the excursion and provides the adjusting output, meanwhile, it transmits the data acquired to a personal computer to be displayed and analyzed

    本文介紹了短路過渡的co _ 2氣體保護焊電弧傳感器，通過對擺動過程中焊接電流的變化來判別焊縫偏移情況，採用模糊控制得到控制輸出，並將數據經串口通信傳送到pc機上加以顯示和分析。
  10. Design of peak - current control circuit for high - power soft - switch inverter

    大功率弧焊逆變器峰值電流控制電路設計
  11. Numerical computation of the dynamic variation of the arc have been completed in the process of before current zero, after current zero and approaching zero to simulate the arc dynamic variation during the interruption process for the high voltage sf6 circuit breaker

    對電流零前、過零期間以及零后的電弧動態變化進行數值求解，實現了高壓sf _ 6斷路器開斷過程電弧動態變化的模擬模擬。
分享友人
分享到 Line

分享到臉書