電抗接地 的英文怎麼說

中文拼音 [diànkàngjiēde]
電抗接地 英文
reactance grounded
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 接地 : [電學] landing; body; ground connection; electrical grounding; grounding; earthing; earth; ground...
  1. Furthermore, problems easy to make mistake are demonstrated, for instance, grounding resistance of large grounding grid is impedance

    研究論證了被一些研究者錯誤理解的關于大型地網接地電阻是阻抗、四極法及其倒相法測量結果為阻抗等問題。
  2. This bus wire connect the long - distance equipments in system and control equipment of other manufacturer. especially, the adoption of control word used in communication and control reduced the quantity of control cable, also. the good treatments of grand and protection has a every strong capability of anti - jamming

    該總線通過相應的通訊模塊，與系統內的遠程控制設備以及其他廠商的單機控制設備相連，採用控制字的方式進行通訊和控制，可節約大量控制電纜，並且通過良好的接地處理和保護，具有極高的抗干擾能力。
  3. Electrical safety in low voltage distribution systems up to 1000 v a. c. and 1500 v d. c. equipment for testing, measuring or monitoring of protective measures - resistance of earth connection and equipotential bonding

    不超過交流1000v和直流1500v的低壓配電系統電氣安全性.防護測試測量或監測設備.接地和等勢屏蔽接地阻抗
  4. The characteristics : the unit is composed of high voltage parallel capacitor, serial reactor, switch ( disconnector, grounding switch, breaker etc. ), lightning arrestor, fuse, discharging coil, current transformer, insulator, busbar and steel bracket, includes two kinds of structure : frame type and cabinet type

    產品特點：裝置由高壓並聯電容器、串聯電抗器、開關（隔離開關、接地開關、斷路器等） 、避雷器、熔斷器、放電線圈、電流互感器、絕緣子、母排和鋼架組成，裝置有框架和櫃式兩種結構。
  5. The model considers peak value of lightning current, tower grounding resistance, tower style, line surge impedance, power frequency voltage and distance between towers

    模型中考慮了雷電流幅值、桿塔沖擊接地電阻、桿塔具體形狀、尺寸、桿塔波阻抗、工頻電壓及檔距等因素的影響。
  6. Manufacturer of high voltage resistors, power and precision resistors, high voltage dividers, hybrid circuits, resistor networks, pressure and force sensors and load cells

    -生產ai - 6000自動抗干擾精密介質損耗測量儀，氧化鋅避雷器測試儀，地網接地電阻測試儀，油介損電阻率測量儀。
  7. By analyzing the inerference in power plant in view of dcs ( distrbuted control system ) used in power plant, the hardware technics of anti - interference, including isolating, screening, grounding, balance and power distribution and the software technics of anti - interference in microcomputer monitoring and control system of power plant are introduced simultaneously

    以分散控制系統為例，分析了火電廠中的干擾，介紹了火電廠微機監控系統中的抗干擾技術，包括隔離、屏蔽、接地及電源干擾的抑制等，同時介紹了軟體抗干擾技術。
  8. Guide for measuring earth resistivity, ground impedance, and earth surface potentials of a ground system

    接地系統的接地電阻率，接地阻抗及地表電位的測量指南
  9. Designers and registered electrical workers may be uncertain whether conductive parts such as metallic bathroom accessories, metallic windows or metallic door handles are extraneous conductive parts. when difficulties are encountered, you may carry out a measurement as illustrated in figures 4 and 5. in figure 4, a is an exposed conductive part with a resistance rcpc to main earthing terminal

    附圖四載列外露非帶電金屬部分a及懷疑為非電氣裝置金屬部分b （例如是金屬水喉管或木門的金屬手柄） ， a對總接地終端的阻抗為rcpc ， b對地的阻抗為rx 。
  10. For the improvement of reliability and stability of the whole apparatus, meanwhile, for eliminating various electric - magnetic disturbance within the power supply and ground, measures such as filter, grounding, shielding are all taken in technique. the special methods are lc filter for power supply, bypass capacitor for suppressing voltage surge in printed circuit board, shielding layer wrapped in sensor head and overall grounded

    通過採用合理的濾波、接地、屏蔽等各種方法，尤其是採用電源lc濾波電路、電源上加旁路電容抑制線路板上的電壓波動、傳感頭加屏蔽層、傳感頭總體接地結構等多種抗干擾辦法，減小了電源和地線上的各種電磁干擾，保證了系統的穩定性和可靠性。
  11. Guide for measuring earth resistivity, ground impedance, and earth surface potentials of a ground system part 1 : normal measurements

    接地系統的土壤電阻率接地阻抗和地面電位測量導則第1部分:常規測量
  12. At last, we analyze the primary disturbance, we adopted some measures to obtain high stability and to enhance the system ' s anti - jamming ability. at the end of the thesis, there are some test results of the system

    又分析了機車內的主要干擾源，並提出了設計中應用到的一些抗干擾措施，如良好接地，信號光電隔離，電容濾波，隔離電源等以增加了系統的工作可靠性。
  13. Have studied generator ground model mostly used in detail for middle and big domestic generator units. calculates and deduces fault current as grounding of single phase and third harmonic fault protection schemes. first time contributes overall knowledge about generator neutral grounding of distribution transformer with secondary resistor, in which considered inductance of the transformer to people

    針對大中型發電機的兩種主要接地方式進行了分析，進行了接地故障電流、三次諧波保護的計算推導，首次在接地變高阻接地方式有關公式推導中計入接地變感抗，從而使人們對接地變高阻接地認識更為全面。
  14. A pulldown resistor to the negative rail will allow the output to approach that rail ( provided the load impedance is high enough, or is also grounded to that rail ), but only slowly

    一個下拉電阻器將允許輸出迫近迫近該電源軌（所提供的負載阻抗足夠高，或負載也是接地的） ，但這樣速度較慢。
  15. Both ends of the shield are a " floating " ground in most cases, and this creates a complex circuit network consisting of the complex impedance to ground of the output circuit at one end, the complex input circuit impedance at the other end, and the resistance, capacitance, and inductance of the cable in between

    大多數情況下屏蔽線兩端是「漂移」的接地端，這就形成了復雜的電路，這個電路的一端相對輸出端的接地點有復雜的阻抗，另一端又有復雜的輸入阻抗以及連接線的電阻，電容和電感。
  16. Application of zgtd automatic arc - suppressing reactor and single phase earth selecting device

    自動跟蹤消弧電抗器及單相接地選線裝置的應用
  17. By analyzing the refraction 、 reflection process of fault transient current traveling wave of high voltage and characteristics of refraction 、 reflection coefficient systematically, a new fault location method of single ended traveling wave is presented. it can not only identify the reflection wave for fault location efficiently, but also not be affected by the structure and length of line. fault earthed resistance 、 fault type 、 system impedance and can locate fault in adjacent areas accurately

    論文深入地分析了高壓線路故障暫態電流行波的波折、反射過程以及折、反射系數的特點，提出了新的單端行波故障測距方法，它不僅能夠有效地識別出測距所用的反射波，而且幾乎不受線路結構、長短、故障接地電阻、故障類型、系統阻抗的影響，在近區仍可以準確地進行測距；同時模擬阻波器的特徵，設計了低通數字濾波器，對通過了低通數字濾波器的暫態故障電流行波再次進行小波分析，並利用本文提出的單端行波故障測距方法進行故障定位，結論是所提出的測距方法在實際應用中仍是有效的。
  18. Abstract : some ways of antiinterference about microcomputer test system for motor is presented, such as electricity supply, shield, ground connection, information connection, information passageway in hardware and the fault - tolerant techniques and digital filtering methods in system software. so the system has stable performance and safe work to strengthen antiinterference ability

    文摘:對電機微機測試系統提出幾種抗干擾措施.通過對供電、屏蔽與接地及信息通道等硬體的抗干擾設計和在系統軟體中採用數字濾波及容錯技術，使原系統性能穩定，運行安全，以增強其抗干擾能力
  19. The machine contain main functions of four testing apparatus, it can automatic test leaking current, grounding electric resistance, dielectric intensity, resting voltage and print testing data

    詳細說明具備四種測試儀的全部主要技術性能，可連續自動測試漏電流、接地阻抗、電介質強度、剩餘電壓。可列印測試數據。
  20. Abstract : various measures for anti - interference for embedded control system are stated for enhancing the capability of the system. these include power supply, grounding, isolated input and output channels and circuit design

    文摘:主要對嵌入式控制系統在抗干擾方面提出了各種措施，包括電源、接地、隔離輸入、輸出通道，以及在電路設計上採取了措施，以求提高系統的抗干擾能力。
分享友人
分享到 Line

分享到臉書