電抗測量 的英文怎麼說

中文拼音 [diànkàngcèliáng]
電抗測量 英文
reactance measurement
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Measurement and analysis of multi - frequency electrical impedance in crus after long time seawater immersion

    長時間海水浸泡下小腿多頻電阻抗測量與分析
  2. A new measurement system for electrical conductivity in an yj - 3000t press fitted with a wedge - type cubic anvil was set up on the basis of the old one. a solartron 1260 impedance / gain phase analyzer was used in the new system ; mo electrodes and a mo shield were also used to keep oxygen fugacity close to the mo - moo2, which is similar to that of iron - wustite ( iw )

    在yj ?緊裝式六面頂壓機上，對原有的礦物、巖石電性測量系統進行了進一步的改進：建立了一套以solartron1260阻抗增益?相位分析儀為測試儀器，使用mo電極和mo盾來控制樣品氧逸度的測量系統，該系統的氧逸度環境為mo ? moo _ 2 ，接近iw緩沖對。
  3. It combained potentiostat, potentiostatic circuit instrument and ac impedance measurement organticace, which can measure usual dynamic potentio - scan, experiment of dynamic potentio - scan, but also unique measurement of ac impedance measurement, also, this new type electrochemical workstation can carry on complex experiment, sucn as potentio / current scan ac impedance measurement procedural measurment, life - span - circle ac impedance measurement procedural measurement in order to fullfill the goal of track and analysis of parameter in various electrochemical conditions. this graduation thesis indicate the structure, function of the multifunct - ional electrochemical workstation

    它把恆電位儀，恆電流儀和電化學交流阻抗分析儀有機地結合到一起，既可以做常規的基本測試如動電位掃描、動電流掃描試驗和電化學交流阻抗測量，也可以做基於這三種基本試驗的程式化試驗，如恆電流充電-電化學交流阻抗測量，電池壽命循環試驗-電化學交流阻抗測量試驗，從而完成多種狀態下電化學體系的參數跟蹤和分析。
  4. Cosmic ray test was carried out to choose and optimize working parameters of full - length prototype and its data acquisition system, verify the electronics system about dynamic range, drift time measurement search window, charge measurement integral width, work stability and electronics grounding and noise. in experiment, acquired abundant experience with the solution of actual problem and verified their reliability of physical design. this lays the foundations for the successful construction of the besiii drift chamber and electrical system

    測試過程中我們調整了電子學的動態范圍、漂移時間和電荷測量參數驗證了電子學系統工作的穩定性、抗干擾能力及噪聲水平等並成功解決了實驗過程中遇到了問題。通過長時間的取數進一步檢驗了全長模型和電子學系統工作穩定性，驗證了全長模型及其數據獲取系統物理設計的可靠性，為漂移室和電子學系統的成功研製奠定了基礎。
  5. We have designed different measurement instruments according to the methods. the instrument used to measure electrode is a high precision multi - channel system constructed with a iaadc as the core and high input impedance amplifier and low input current multiplexer

    對于硫屬玻璃電極，我們設計了以高精度的adc為核心，配以高輸入阻抗低噪聲的前置放大器和低漏電流多路模擬開關的多路精密電極測量系統。
  6. The main works are listed as follows : ( 1 ) the small capacitance measuring circuit for ect based on the charge amplification principle was deeply analyzed and improved. the stray - immunity and the charge injection effect of this circuit were deeply analyzed. the influence of the charge injection effect was eliminated by practical time sequences and circuit structure differential

    本文的主要工作和創新點如下： （ 1 ）對基於電荷放大原理的微弱電容測量電路進行了深入的分析和改進，深入分析了該電路的抗雜散電容性能及電荷注入效應問題，通過時序的合理設計消除了電荷注入效應等因素對測量結果的影響，改進了該電路的數學模型。
  7. Electrical relays - electrical disturbance tests for measuring relays and protection equipment - power frequency immunity tests

    電氣繼電器.測量繼電器和保護設備的電干擾試驗.工頻抗擾試驗
  8. The input impedance of the interdigital saw transducer is measured by the equivalent circuit method. the experimental results show that the synchronized frequency of 9. 586 mhz, the acoustic radiation resistance of 44. 6 and the static electrode capacity of 194pf all agree with those design values

    用自行設計的等效電路測量方案，測量了表面彈性波馬達換能器的輸入阻抗，實驗結果顯示表面彈性波換能器的共振頻率為9 . 586mhz ，輻射聲電阻為44 . 6 ，叉指電極靜電容為194pf 。
  9. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  10. Guide for measuring earth resistivity, ground impedance, and earth surface potentials of a ground system part 1 : normal measurements

    接地系統的土壤電阻率接地阻抗和地面電位測量導則第1部分:常規測量
  11. Thermocouple and thermal resistance in power station suit to measure temperature of electric generator groups and auxiliary machine correspond to 300000 and 600000 kilowatt, which can substitute one from import with many advantages as shock - proof, pressure - resistant, long in service, and convenience in maintain etc. the protective tube is processed in a special construction by deep - blind hole technology whose end not be welded to enhance the strength and prolong service life. thermocouple or thermal resistance

    本公司生產的電站專用熱電偶阻，適用於我國30萬60萬千瓦等發電機組及輔機的測溫需要，產品安全可替代進口，具有防震耐壓使用壽命長，維修方便，保護管是採用深盲孔技術加工而成，端部不用焊接，提高了保護管的強度和使用壽命，鎧裝熱電偶熱電阻採用彈簧壓著式結構，在運行中保護管與鎧裝熱電偶熱電阻測量端始終保持著良好的接觸，抗震動，減少熱響應時間，鎧裝熱電偶測量端採用絕緣形式，能防止電磁干憂。
  12. The system makes impedance measurements using an array of 32 electrodes on the surface of the body, and reconstructs the images using a veighted backprojection algorithm

    該系統採用32體表電極進行阻抗測量，用加權反投影演算法進行圖象重構。
  13. A kind of impedance measurement is proposed with piezo - electric element which drives the beam and engender dynamic impedance data

    摘要提出了利用壓電陶瓷的阻抗測量法的概念，即用壓電陶瓷作為驅動源產生動態阻抗信息。
  14. Test method of measuring specific resistivity of electronic grade solvents

    電子級溶劑比阻抗測量試驗方法
  15. A circuit measures the resistance of the thermistor and provides an output voltage proportional to the temperature

    一種電路，測量電熱調節器的抗性，提供與溫度成比例的輸出電壓。
  16. Apart from that, it also anlagse the basic princple of ac impedance measurement, and introduce the design and experiment of handware of the workstation in terms of basic princple of ac impedance measurement. the study of this graduation thesis includs the aspects as follwos : ( 1 ) design of measuring circuit diagram. it is designed for the measurment of usual dynamic potentio - scan, experiment of dynamic potentio - scan

    介紹了電化學工作站的三種基本功能和性能指標，電化學交流阻抗測量的原理，並進而提出了電化學工作站的硬體系統結構，構建了電化學工作站的硬體結構設計; （ 2 ）下位機的介面電路板和測量電路板設計，在設計中力圖提高系統精度、靈活性。
  17. Input impedance for dc voltage measurement

    電壓測量輸入阻抗
  18. Then, based on the estimation algorithm decomposing the measurement of voltage scope and power scope, the problems of the location of transformation tap settings and the tide current estimation of zero - impedance branches in state estimation are solved ; and detection and identification of bad data in state estimation are deduced and stimulated, also a hybrid method of detection and identification is brought forward

    隨后，在基於分解電壓測量量和功率測量量的估計演算法的基礎上，對狀態估計中經常出現的變壓器抽頭位置問題和零阻抗支路潮流估計問題進行了分析和處理；對狀態估計的不良數據檢測與識別方法進行了推導和模擬，並提出了一種混合檢測方法。
  19. The effects of the error of ct and vt, hysteresis and load variation to short - circuit reactances are discussed also. by using error analysis and simulation analysis, this paper discussed the feasibility in engineering

    論文分析了互感器誤差在幾種情況下對短路電抗測量結果的影響；通過變壓器建模，分析了磁滯特性和負載變化量大小對短路電抗測量結果的影響，驗證了該方法在工程應用上的可行性。
  20. Verification of algorithm and equipment for electrochemical impedance measurements

    電化學阻抗測量用演算法和設備的驗證
分享友人
分享到 Line

分享到臉書