電抗負載 的英文怎麼說

中文拼音 [diànkàngfùzǎi]
電抗負載 英文
load, reactive
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. Moreover, we mensurate the reactances of the experimental motor by the way of direct joad method, and verify the vaiidity of " electromotive force method "

    文章還運用直接負載法測定出樣機在不同負載下的電抗參數，驗證了「電勢法」的正確性。
  2. Great intermittent noise, wide variety of impendence along with the load and great attenuation of signals have restricted the further utilization of power line

    但是，電力線通信通道存在間歇性噪聲大、阻抗隨負載變化大、信號衰減大等缺點，嚴重製約了它的有效利用。
  3. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽柵pmosfet性能的影響進行了分析，對所得結果從器件內部物理機制上進行了討論，最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深（凹槽深度）的增大，槽柵器件的閾值電壓升高，亞閾斜率退化，漏極驅動能力減弱，器件短溝道效應的抑制更為有效，抗熱載流子性能的提高較大，且器件的漏極驅動能力的退化要比改變結深小.因此，改變槽深加大負結深更有利於器件性能的提高
  4. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  5. The results show that the electron mean drift velocity is affected by the cathode radius, the impedance of the load diode, the inner radius of vanes and the input voltage

    結果表明電子平均漂移速度決定於陰極桿半徑、負載二極體阻抗、陽極慢波葉片內徑和輸入電壓。
  6. To explain this, we ' re going to avoid the idea of impedance ( which has resistive, capacitive and inductive components, some of which vary in effect by frequency, thus varying the actual loading ) and use pure resistance to describe the concept

    為了便於解釋，我們準備暫時避免使用阻抗這一概念，因為它有電阻性、電容性和電感性成分，而其中一部分會隨著頻率的變化而變化，從而改變了實際的負載。
  7. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  8. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  9. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  10. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  11. The possible factors including the deviation of temperature in length and breadth of rod, the changes of transfiguration resisting force under the changes of temperature, the adjustment of roll gap, the variation of rolling pressure, the changes of roller speed during dynamic adjusting press, the unmatched of seconds - flux under the dimension fluctuation of the coming sample and so on. the whole system was a closed loop which factors in it interacts each other

    可能的影響因素有:沿軋件縱橫向溫度變化、由溫度引起的軋件變形抗力變化、軋機輥縫值變化、負載變化、電機調節系統由不穩定向穩定過渡過程中軋輥轉速的變化（如咬鋼過程中的動態速降后的回復階段） 、來料尺寸波動造成秒流量不匹配等，整個模擬系統是各個因素相互影響關聯的一個閉環系統。
  12. The product has good over load - proof and con corona - proof features, it is widely used in windings of electric machines and appliances

    該產品具有抗電暈、過負載等特點，廣泛用於電機電器的繞組。
  13. The product has good over load - proof and con corona - proof festurs. it is widely used in windings of electric machine and appliances

    該產品具有抗電暈、過負載等特點，廣泛用於電機、電器等繞組。
  14. It balls up well in ac welding and has a more stable arc than pure tungsten. especially with excellent performance in high load ac welding, it is not replacable by any other electrodes. it also resists contamination well in ac welding

    尤其在高負載電流的情況下，鋯鎢電極表現出來的優越性能，是其他電極不可替代的，在焊接時，鋯鎢電極的端部能保持成圓球狀而減少滲鎢現象，並具有良好的抗腐蝕性。
  15. Assuming the loop is known to be only a single straight segment of 26awg cable, there is no additive loop or afe noise, and the remote - end is terminated by a high - impedance load for all frequencies, figure 5 shows the resulting selt performance

    假定已知環路只有一個單個的直段26awg電纜，沒有附加的環路或者afe噪聲，對所有的頻率遠端通過一個高祖抗負載終止，圖5給出了selt的性能結果。
  16. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  17. Pic simulations are performed to determine gap scaling in a high density pegs. comparisons of simulation results with simply theory results and experiment results, indicate that the pegs gap is always equal to the critical gap for magnetic insulted electron flow. it is important to note that, the vacuum electron flow to the anode causes current loss and the

    另外，根據模擬結果還得到了兩個重要結論：電流損失是由真空漂移電子的出現所造成的，電流損失的大小與負載阻抗成近似正比關系；負載阻抗等於peos的流阻抗時，負載獲得功率最大。
  18. The power angle characteristics are acquired and compared with the unsaturated curves. it is concluded that the stability limit of the power angle is less than 90 degree. reactive power regulating curves are calculated and compared with those curves when saturation effect is not considered, the result is that u type curves are deviated to the right

    通過對同步發電機各種運行曲線的計算，在已有文獻的基礎上更進一步分析了鐵磁材料飽和以及磁場畸變對同步發電機運行特性和參數的影響；求出了空載特性曲線和零功率負載特性曲線，在不同的電樞電流下計算得到的波梯電抗不同；求出了功角特性曲線，與不計飽和時的功角特性曲線相比較，功角穩定極限小於90 ；求出無功調節曲線，與不計飽和時相比較， u型曲線向右偏移。
  19. A pulldown resistor to the negative rail will allow the output to approach that rail ( provided the load impedance is high enough, or is also grounded to that rail ), but only slowly

    一個下拉電阻器將允許輸出迫近迫近該電源軌（所提供的負載阻抗足夠高，或負載也是接地的） ，但這樣速度較慢。
  20. The current in the dac ’ s output can drive the load, and the structure can save a buffer consisted of operational amplifier, so the structure can achieve high speed with no close - loop and feedback in this circuit

    該10位分段式電流舵型數模轉換器的輸出端可直接用電流輸出來驅動負載阻抗，省去運算放大器構成的輸出緩沖，整個電路中沒有形成閉環和反饋，因此這種電路結構可以達到很高的速度。
分享友人
分享到 Line

分享到臉書