電控轉換開關 的英文怎麼說

中文拼音 [diànkòngzhuǎnhuànkāiguān]
電控轉換開關 英文
electric control switch
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 轉 : 轉構詞成分。
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 電控 : drive-by-wire
  • 轉換 : change; transform; convert; switch
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上，考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面，主要完成對微處理器的選擇、時鐘頻率和a d轉換器的選用，閥位變送功能的實現，固態交流開關和顯示器的選擇等。
  3. Manufacturer of ce certified pilot lamps, push button switches, selector switches, cam switches, and terminal blocks

    -生產智能控制器，自動轉換開關器，機電連鎖裝置，智能雙電源自動切換開關產品。
  4. Series full - auto pipe expander with drawing device and program interface is used with extruding machine. it is also used solitarily, while expanding pipes, the machine adopts translation, the action is steady and corret, it does not damage pipe materical, the machine adoptes double - infrared heating oven type, each oven is equipped with heating cire, the shaping method adopts expanding - end shaping, the size of pipe mouth is correct. on its panel, there is a transfer swith of expanding solvent type pipe socket ( straigh port ) and expanding sealloop type pipe socket ( rport ). the choice of expanding pipe type is very convenient, the technologocal adaptability is strong, its main electric control elements are all imported. the syetem charecteristics are steady and reliable

    配有與主機配套的接料牽引裝置和相應的程序介面，既能與擠管主機聯線使用，又可以作單機使用；擴管時管材的移動均採用平移方式，動作平穩準確而且不易損傷管材；這種機型採用紅外線加熱方式且為雙加熱爐型，每個加熱爐都配有中心加熱爐芯；成型方式均採用擴管頭定型方式，管口成型尺寸準確；該機型在控制面板上設有擴溶劑型承介面（直口）和擴彈性密封圈型承介面（ r口）的轉換開關，擴管方式選擇十分方便，工藝適應性強；主要的電器控制元件均採用進口元件，系統性能穩定可靠。
  5. Switchgear - high - voltage air switches - rated control voltages and their ranges ; supplement

    轉換開關裝置.高電壓空氣轉換開關.額定控制電壓及其范圍：補充件
  6. Model gdl1, 2 compact low voltage complete switchgear is suitable for use in ac 50 - 60hz three - phase five - wire election net as power, lighting, electic energy changeover, protection and control in genegration, transmission and distribution systems. it also can be used in warship, oil prospecting and nuclear power stration

    2低壓成套開關設備適用於交流50 - 60hz ，三相互線制電網，用於發電、輸電、配電系統中最為動力、照明、電能轉換、保護控制之用，還可用於艦船及海上石油勘探和核電站。
  7. Firstly the paper summarized the methods of passing over of neutral section and its application status quo in the domestic and oversea. as the research object of the paper, the reason of over - voltage caused by the method of ground transfer by vacuum breaker is analyzed though simulation and experiment. and based on the analyze, a method of automatic passing over of neutral section using thyristor vale to controlling the phase of electric power is presents

    本文首先綜述了國內外自動過電分相的方式及應用研究現狀，並以地面開關轉換方式為本文的研究對象，通過模擬和實驗，分析了這種方式產生過電壓的機理，以此為基礎，提出了以晶閘管閥控制電網電源投入時刻的自動過分相方案。
  8. Electricity meters, tariff time switches and ripple control receivers ; connection diagrams, terminal marking, circuit diagrams

    電度表.計價定時轉換開關和波紋控制接收機.連接圖.端
  9. The relays may lack the high speed switching characteristic of the solid - state state switches used by other preamplifiers, but they also have none semiconductor distortions and noise which accompany analog gates and voltage controlled amplifiers

    與其他前級放大器所用的半導體開關相比，這些繼電器缺少高速轉換的特性，但它們沒有隨著模擬開關和電壓控制放大器所帶來的半導體失真和噪聲。
  10. Low - voltage switchgear and controlgear - part 5 - 10 : contactor relays and auxiliary contact for contactors and motor - starters

    低壓轉換開關裝置和控制裝置.第5 - 10部分:接觸器和馬達起動器的接觸繼電氣和輔助觸點
  11. The system selects micro control unit and programmable logic device as the core of controller, gsm terminal module as communication device, gps as position equipment, a / d sampling for voltage and current checking, solar battery as power supply, switch dc - dc as power voltage conversion, and so on

    以微處理單元與可編程邏輯器件為核心搭建系統控制器，選擇gsm無線通信模塊實現系統通信，全球定位系統實現水標燈定位， a d采樣與轉換實現電壓電流檢測，太陽能電池為系統供電，開關型dc - dc實現電源電壓轉換。
  12. Its control precision must fit a certain extent standard. now, proportional hydraulic valve which developed from the general hydraulic valve is applied in ali kind of control scopes. it uses proportional electromagnetic iron to change the electron signal into mechanical signal instead of the manual adjuster or general switch electromagnetic iron

    現在工業生產中得到廣泛應用的比例液壓閥多是在普通液壓閥的基礎上，採用廉價而可靠的比例電磁鐵作為電-機轉換元件，把電氣控制信號轉為機械信號，以代替原閥內的手動調節器或普通開關式電磁鐵。
  13. Low - voltage switchgear and controlgear - part 6 - 1 : multiple function equipment - automatic transfer switching equipment

    低壓開關設備和控制設備第6部分:多功能電器第1篇:自動轉換開關電器
  14. An automatic transfer switch monitors the condition of the sources and connects the load to the alternate source if the preferred source fails

    自動轉換開關能夠進行監控，如果首選電源供應失敗，就自動把負載連接到備用電源。
  15. This business is a global provider of power generation systems, components and services for a diversified customer base to meet the needs for standby power, distributed generation power, as well as auxiliary power needs in specialty mobile applications

    康明斯電力的產品線包括發電系統、機組用發動機、控制系統、交流發電機、轉換開關系統和開關櫃等。
  16. Sgk - b250 plastic pipe belling machine attribute semiautomatic opportunities for the single - use. such models use infrared heating, molding method adopts expand the headers to finalize the design, orifice size precise shape. the control panel don ' t have the conversion switch to control over the type of solvent for expansion socket ( vertical ) and ring - for flexibility expansion socket ( r ). expanding way is very easy choice and technics adaptability is strong, the main electrical control components are imported, system performance is stable and reliable

    B250塑料硬管擴口機，屬半自動型作單機使用，擴管時管材由人工搬至擴管工位：這種機型採用紅外線加熱方式：成型方式均採用擴管頭定型方式，管口成型尺寸準確：該機型在控制面板上沒有擴溶劑型承插口（直口）和擴彈性密封圈型承插口（ r口）的轉換開關，擴管方式選擇十分方便，工藝適應性強：主要的電器控制元件均採用進口元件，系統性能穩定可靠。
  17. The thesis analyzes and constructs the terminal system by separating the monitor task into several modules. the terminal system consists of controller, light check module, position module, radio communication module and power management module, which combine radio communication, satellite position, computer control, switch power and some other technologies

    本課題把監控要求與任務分成模塊進行分析與構建，系統分為控制器、燈檢測、定位裝置、通信模塊、電源轉換與管理等五大模塊，融合了無線通信、衛星定位、計算機控制技術、開關電源等技術。
  18. The theory mentioned in this paper is a kind of traveling wave method. it overcomes the limitations in theory and short - comings of big errors, realizes the fault ' s checking system by a pc bus industrial control computer, adopts swift a d translation. monitoring on - off switch, warning device when the fault appears

    本文所闡述的理論是一種行波法，它克服了理論上的局限性和誤差大的缺點，應用計算機進行電力系統暫態過程的數字模擬和計算程序，是分析電力系統故障的有力工具，採用pc總線工控機，選用快速a d轉換、開關量測量、出現故障聲光報警。
  19. Chapter five introduces simply the static switch and its control circuit. static switch is the bridge between electric power supply and accumulator supply

    第五章簡要介紹了靜態開關及其控制電路，靜態開關是ups市電供電和逆變器供電之間相互轉換的橋梁。
  20. A brief description of the operation of overhead traveling cranes for water power station and development of crane electric control technologies is given, and two practical combination operation systems of two overhead traveling cranes for water power station are presented in detail : switch and plc control systems

    摘要根據國內水電站機房用橋式起重機的工作特點，結合起重機電控技術的發展，介紹了2種切實可行的起重機並車作業電氣控制系統，即轉換開關並車系統和可編程序控制器（ plc ）通訊並車系統。
分享友人
分享到 Line

分享到臉書