電桿檢查 的英文怎麼說

中文拼音 [diàngǎnjiǎnzhā]
電桿檢查 英文
pole inspection
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 桿名詞(桿子) pole; staff
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : 查名詞1. [植物學] (山查) hawthorn; haw2. (姓氏) a surname
  • 電桿 : (electrical) pole
  • 檢查 : 1 (用心查看) check up; inspect; examine; censor; survey rummage; review; jerque; docimasia 2 (...
  1. Sufficient or not of the battery on the device should be carefully examined before every flying, so do the every pole, helm and gemel, whether or not is the receiving antenna drew out of the body and in straight, examine the ground effective distance for remote control without the drawing out the antenna, ensure it nomal in rang of 30 - 50 meters

    1 .仔細測試設備每次飛行前都應該仔細設備量是否充足,飛機各個拉舵角鉸鏈是否正常,接收機天線是否拉出機身並拉直,在不拉出發射機天線的情況下測試地面有效遙控距離,確定30 - 50米內不發生跳舵情況。
  2. Equipped with electronic controller fini tronic and preset for remote control for two or more compressors. it offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging lashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure end indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制,有工作壓力和油氣分離器罐內壓指示,分離器過濾器阻塞報警,機溫控,螺總成溫控,壓力端空氣溫度指示,機轉向,維護周期油,油過濾器,空氣過濾器,分離器過濾器,總運行時間和負載運行時間,記錄上五個報警故障等。
  3. Examine the plunger joint ring of electric hydraulic draw stem and pneumatic draw stem in order to ensure the normal operation of transmission device

    定期液推、氣動推的活塞密封圈,以保證傳動裝置正常運行。
  4. The dj - a gynecological examination bed is uses the electrically operated lead screw to make the surface of bed fluctuation the power supply, when use so long as inserts the power source, controls the surface of bed with the foot the fluctuation, the seat back cushion and the cushion adjustment is uses was mad the spring makes the poweruses the electrically operated lead screw is the power supply, surface of bed fluctuation, the seat back cushion and ( manually controlled ) sits the board the angle adjustment the switch to control by the foot control, easy to operateif must cause to inspect the bed to move the position, blooms a base four feet turn of slightly tight pine, transfers to needs the position afternoon tight foot turn then the foot pad is the add - on component, may conveniently install according to the surgery need or dismount

    型婦科床是採用動絲作床面升降的動力源,使用時只要插上源,用腳控制床面的升降,靠背和坐墊的調節是採用氣彈簧作動力.採用動絲為動力源,床面的升降,靠背和坐板的角度調節均由腳控(手控)開關控制,使用方便.如果要使床移動位置,將底部四個腳輪的稍緊松開,移到所需位置后稍緊腳輪即可.腳墊是附加裝置,根據手術的需要可方便地裝上或卸下。
  5. Check the operating condition of electric draw stem and electricity parts. check the electric hydraulic parts and pipe joints

    定期動推氣部分的運行情況,液部分的運行情況及管接頭處是否有泄漏現象。
分享友人