電梁載 的英文怎麼說

中文拼音 [diànliángzǎi]
電梁載 英文
current load
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 梁 : 名詞1 （屋架中架在柱子上的長木） beam 2 （通常也指檁） purlin 3 （橋） bridge4 （物體中間條狀隆起...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  1. Analytical solution of the bending problem of piezoelectricity cantilever beam under uniformly distributed loading

    均勻分佈荷載作用下壓電懸臂梁彎曲問題解析解
  2. Considering special form of the boiler frame, the reconstruction and enforcement method, in addition dynamic analysis are given by particular steps : establishment of the model of boiler steel frame, determination of earthquake loads and distribution form, and anti - side force system for the frame to model and analyze, involving loads on the frame and above it, earthquake loads, damping, sway control installation, hanging bar and plate beam

    考慮鍋爐構架鋼結構的特殊形式，研究並提出了電站鍋爐鋼結構改造加固研究方法，及動力分析的具體步驟：建立了鍋爐鋼結構動力分析模型、地震荷載分析方法、建立了鍋爐鋼結構布置型式、及整個鍋爐鋼構架抗側力體系模擬分析方法。具體包括：鋼構架本體及構架上荷載、地震載荷與阻尼系數確定、制晃裝置確定、吊桿與大板梁簡化。
  3. Problems occured in the anchoring of overhung tourist hall on top of the tv tower and tower drum due to construction mistakes. it was introduced in this paper that two non - binding prestressed girder beams are respectively set in corresponding locations as the anchor beam of overhung radial support beam of tourist hall, thus the integrity of the tower drum and transmission of the load were guaranteed

    由於施工失誤，作為電視塔頂的外懸游覽廳和塔筒間的錨固發生了問題，本文介紹了採用在相應位置設置兩根無粘結預應力大樑分別作為游覽廳屋面和樓面徑向懸挑支承梁的錨固梁，確保了它和塔筒的整體性和荷載的傳遞。
  4. This article discuss the method to measure distortion of truss by means of ccd device. the distortion can be measured with many kind of displacement transducer, but it must be placed on stable base. when the huge truss is moving through some tunnel, it is difficult to find a stable base, especially there is no enough space for someone to operate. it is hardly to measure the distortion by touching. on the contrary, this can be achieved by means of ccd device

    桁架在自重或載荷的作用下產生的撓度可以用多種位移傳感器測得，這些測量方法需要有良好的基礎，在大型桁架梁測量現場，由於桁架的變形，難于找到這種基準，如果加上測量環境惡劣，人無法操作情況，則會給撓度測量帶來極大的困難，而採用光電荷耦合器件，並利用激光進行遠程實時撓度測量，即可以解決這個難題。
  5. The large concrete structures, such as bridges, safety hull of nuclear power plants, sea oil plateforms et al. are subjected to not only static loads, but also dynamic loadings such as vehicles, nuclear power, wind, wave, water flow and violence earthquake

    許多大型的混凝土結構工程，如橋梁、核電站安全殼、壓力殼、海上採油下臺等，不僅受到靜載荷的作用，還要受到諸如車輛、核動力、風、浪、水流和強烈地震等動荷載的作用。
  6. Mr wong said : " i remember a motorbike driving up to us. on the back sat a cameraman facing backwards so that he could continuously take pictures of the car carrying godber

    黃國梁說：當時的記者，一個駕著電單車，另一個轉身坐在後座，不停拍攝載著葛柏的房車，可謂險象環生。
  7. On the basis of 3d modeling and virtual prototyping technology and energy saving transformation method for parameterized simulation moving beam typed oil suction pump, and using the eccentric gear reducer to replace the ordinary gear reducer to let the driving radius of eccentric gear be kept a variation of similar tendency with the load of crank in order to improve load property of the motor, thus raised the working efficiency of the entire oil suction pump and achieved the effect of energy saving

    摘要基於三維建模和虛擬樣機技術，參數化模擬游梁式抽油機節能改造方法，用偏心齒輪減速器代替普通齒輪減速器，使偏心齒輪驅動半徑和曲柄負載保持同趨勢變化，以改善電機負載特性，提高整個抽油機的工作效率，達到了節能的效果。
  8. The test for simulating load spectrum of bridge was done, comparison of the infered load spectrum by means of the electrical resistance changes of two fatigue life gage with the simulated load spectrum showed reasonably good agreement

    進行了模擬橋梁荷載譜加載試驗，用雙疲勞壽命計電阻變化所推算荷載譜和模擬荷載譜基本一致，證明了方法的可行性。
  9. Abstract : in the light of the problems of high power consumption and low working efficiency in a beam pumping unit, a new method for power saving of the unit is proposed, that is, adopting an optimum structure of the unit and decreasing the periodic load coefficient of the pumping unit by changing the performance characteristics of the electric motor and by increasing the rotary inertia of the unit

    文摘:針對游梁式抽油機能耗大，工作效率低的問題，提出遊梁式抽油機節能的新方法，即在採用優化抽油機結構的基礎上，通過改變電動機的工作特性和增加抽油機轉動慣量的辦法降低抽油機周期載荷系數。
  10. The nonlinear deformations of simply supported, fixed supported and cantilever piezoelectric laminated beams were studied under strong electric field and mechanical force

    摘要本文研究簡支，固支和懸臂壓電層合梁在強電場和機械荷載聯合作用下的非線性變形。
  11. Analytical solution to magneto - electro - elastic cantilever beam under uniform load

    均布荷載作用下懸臂磁電彈性梁的解析解
  12. Analytical solution of simply supported magnetoelectroelastic beam under uniform load

    均布荷載作用下簡支磁電彈性梁的解析解
  13. Then the penalty finite element formula can be derived through galerkin weighted residual method. to test the model, the paper calculate a cantilever sample and a four point bending beam under near static load and sinusoidal load

    針對浸泡在液體中的懸臂梁試件和四點彎曲試件，計算了在受躍階載荷和正弦載荷作用時的變形、流動以及流動電場分佈。
  14. Analytical solution of a simply supported piezoelectric beam subjected to a uniformly - distributed loading

    均布荷載作用下壓電材料簡支梁的解析解
  15. Piezoelectric cantilever actuator subjected to a linearly distributed loading

    線性分佈荷載作用下梯度功能壓電懸臂梁的解
分享友人
分享到 Line

分享到臉書