電池電極 的英文怎麼說

中文拼音 [diànchídiànjí]
電池電極 英文
battery electrode
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電池 : [電學] cell; battery; element; electric battery
  • 電極 : electrode; pole
  1. More recently, the perovskite manganite compounds, la1 - xsrxmno3 have been used as the cathode of the solid oxide fuel cell ( sofc ) because of their electro - ion conductivity properties. in manganite perovskites, substitution of divalent ions ( alkaline earth metals viz

    近幾年來， la _ （ 1 - x ） sr _ xmno _ 3這類鈣鈦礦型結構的氧化物材料因為其具有混合電子-離子導電特性而被廣泛的應用於固體氧化物燃料電池陰極材料。
  2. Study on the preparation of layered lithium manganate used as anode material of li - ion battery

    鋰離子蓄電池正極材料層狀錳酸鋰的制備研究
  3. Recent studies on anode materials for lithium ion secondary battery are reviewed

    綜述了最近幾年來鋰離子二次電池負極材料的研究。
  4. The results show that lioh ? h2o and emd are better and cheaper materials which have no environmental pollution. it was found that the synthesis temperature were important factor. the spinel lithium manganese oxide,

    結果表明: lioh ? h _ 2o和emd是制備鋰離子電池正極材料摻鈷錳酸鋰較好的合成原料，同時也是廉價、環保的合成原料; 750 ， 20h為較好的合成溫度。
  5. In order to prepare ag - coated flake graphite used as filler of conductive adhesive or poles of the battery, the electroless plating procedure was investigated that plated the silver directly in alkaline solution without activation or sensitize treatment

    摘要為制備可用於高性能電池電極和導電膠的石墨填料，採用了不經過敏化、活化處理而直接在堿性鍍液中進行化學鍍銀的方法制備了鍍銀鱗片石墨。
  6. Use of an amorphous diamond film as dental material

    2催化熱處理中間相炭微球用作鋰離子電池負極材料
  7. The flow characteristics, distributions of current density and chemical components, and the performance of these two different designs are calculated and compared. the flow and mass transport characteristics are analyzed in detail, which indicate that strong forced convection is produced in the interdigitated flow field, which consist of dead - end gas channel that force the gases through the porous electrodes. results of comparison show that forced convection induced by the interdigitated flow field in the diffusion layer effectively enhances mass transport of reactants and products, thus leading to a higher cell performance and the limiting current density

    在傳統流道設計的pemfc中，反應物從流道到催化層的供應和生成物從催化層到流道的排出主要是以擴散為主，而在交叉梳狀流道設計中，以流動帶動的對流傳遞則占據了主導地位，而且這種以對流為主的傳遞機理大大提高了反應物和產物傳遞速率，從而有效地改善了電池的極限電流密度和極化性能等特性。
  8. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  9. Based on practical application conditions, half - cell potential method, concrete resistance measurement, linear polarization resistance method and etc. 3

    根據現場的實際應用情況，最常用的方法有半電池電位法、混凝土電阻率檢測法、直流線性極化電阻法、交流阻抗法以及地質雷達法等。
  10. 4. through the galvanostatic charge / discharge experiments with different schedules, it was found that mn ( ) / mn ( ) in acidic media as half - cell in a novel redox flow system is practically feasible in that it has such advantages as low cost, high open voltage, a certain coulombic efficiency with low charge / discharge current, and long cycling life. in the second part, cosn alloy and cu - sn samples were synthesized firstly by h2 - reduction following solid - state reaction between co ( ii ) 、 cu ( ii ) 、 sn ( iv ) 、 and naoh at ambient temperature

    並研究了其分別作為鋰離子電池陽極材料在1mol / llipf6 / ec + dmc電解液中的恆流充放電性能，各樣品均存在較大的首次不可逆容量損失； 10個循環內cu - sn可逆放電容量可保持在280mah / g以上，而第十周時cosn 、 cu6sn5的可逆放電容量分別為50mah / g和60mah / g 。
  11. Modeling of the cathode of proton exchange membrane fuel cell using interdigitated flow fields

    交指型極板的質子交換膜燃料電池陰極模擬
  12. Lifepo4 as the cathode active material for lithium ion battery

    鋰離子電池正極材料摻雜稀土的研究進展
  13. Recent development of lifepo4 cathode materials for lithium - ion batteries

    鋰離子蓄電池正極活性材料磷酸亞鐵鋰
  14. Preliminary study of structural stability of cathode material limn2o4 for lithium batteries

    4鋰離子電池正極材料結構穩定性的初步研究
  15. Progress anode modification techniques of dye - sensitized solar cell

    染料敏化太陽能電池陽極改性技術研究進展
  16. Research trend of li - mn - oxide cathode for li - ion cells

    鋰離子電池正極材料鋰錳氧化物的研究進展
  17. Exemplified with a number of representative systems which are highly valuable in industry and academically important, including electrode membranes of fuel cells, sesame seeds as well as hard bones and cartilages of marine fish, the extensive applications of microscopic mri images with various weighting approaches to the investigations of micro - structures and dynamics including the developmental processes of plants are demonstrated

    以具有高度產業價值及重要學術意義的幾個典型體系：燃料電池電極月莫、芝麻種子和海生魚骨為例，說明各類加權圖象在微結構和動態（包括植物生長過程）研究中的廣泛應用。
  18. A corrugated or perforated conducting plate in a storage battery

    極板網柵，蓄電池電極板蓄電池中呈波紋狀或有孔的導電板
  19. The properties and manufacturing methods of carbon nanotubes are briefly introduced, and the prospect of its potential application in several respects for automobiles are analyzed, including hydrogen storage material, supercapacitor, electrode material of lithium ion batteries, et al

    本文簡單地介紹了碳納米管的性能和制備方法，分析了碳納米管在汽車中潛在的若干方面的應用前景，包括儲氫材料、超級電容器、鋰離子電池電極材料等。
  20. These innovative materials promise new application in many fields, such as microelectronics, biosensors, photonics, battery cathodes, etc

    這些性質或許可應用在一些新領域中，例如微電子、生物感測器、光子、電池電極上等等。
分享友人
分享到 Line

分享到臉書