電流荷載 的英文怎麼說

中文拼音 [diànliúhézǎi]
電流荷載 英文
current load
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 荷 : 荷名詞（蓮） lotus
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  2. The stresses and nonlinear deformations of thin strip - plate with two simply supported edges under the coupled action of the electromagnetic field arid mechanical load are calculated, the magneto - elastic effects on thin current - carrying strip - plate by the side current and electromagnetic induction density are studied

    由此計算分析兩邊簡支條形薄板在電磁場和機械載荷耦合作用下的應力與變形，研究側向電流和外磁場強度對載流條形薄板的磁彈性效應。
  3. Fluid experiment ; buff body aerodynamics ; wind engineering ; wind loading on buildings and structures ; modeling wind in an atmospheric boundary wind tunnel ; pedestrian - level wind environment ; wind effects on the efficiency of air - cooled condenser in a large power plant

    實驗流體力學，鈍體空氣動力學，風工程， 、建築物和結構物的風荷載研究，大氣邊界層風洞模擬，行人高度風環境，大型電站空冷系統風效應風洞模擬。
  4. In chapter 3, the subgrid eddy - viscosity model for large eddy simulation is applied to calculate the three dimensions unsteady periodic turbulent flow in yantan francis turbine. the pulsating characteristics of some main physical parameters in flow field are found. the calculated axial water thrust of hydraulic turbine agrees with the model - test value

    第三章採用大渦模擬亞格子渦粘模型，對巖灘混流式水輪機的流場進行三維非定常湍流分析，得到了流場中各物理量的脈動特性，計算出ms的軸向水推力與模型試驗值大小相當；同時論證了對于下機架承重的混流式水輪發電機組可採用其推力軸承負荷作為水電站廠房振動的最大垂直激振荷載。
  5. The large concrete structures, such as bridges, safety hull of nuclear power plants, sea oil plateforms et al. are subjected to not only static loads, but also dynamic loadings such as vehicles, nuclear power, wind, wave, water flow and violence earthquake

    許多大型的混凝土結構工程，如橋梁、核電站安全殼、壓力殼、海上採油下臺等，不僅受到靜載荷的作用，還要受到諸如車輛、核動力、風、浪、水流和強烈地震等動荷載的作用。
  6. Based on the vibration test in yantan hydropower house, in this paper the author adopt les method which belong to three dimensions unsteady turbulent flow numerical analysis to simulate vibration resource characteristics of hydrogenerator set, a harmonic vibration model of powerhouse substructure is put forward to carry out firstly a precise modal analysis and dynamic response analysis for generator floor. the numerical calculation results agree well with the surveyed data in situ

    本文結合巖灘水電站廠房振動的試驗研究，採用非定常湍流數值分析的大渦模擬方法進行混流機組水力振動振源模擬；提出一種水電站廠房下部結構簡諧振動模型，首次進行了發電機層樓板結構的精確模態分析和水力激振荷載下的動力響應分析，各項計算結果與實測數據吻合良好。
  7. Charge carrier density gradient

    電荷載流子密度梯度
  8. Charge carrier distribution

    電荷載流子分佈
  9. Application of high - voltage explosion fuses is very abroad. in addition to protecting the electrical equipment by melting itself, disjunction or close of its tube can also be manipulated by a high - voltage insulative stick under some circumstance, for example, to switch on or off no - load overhead transmission line, no - load transformer and little burden current

    跌落式高壓熔斷器的應用極為廣泛，不僅能保護電氣裝置，在一定條件下還能直接用高壓絕緣鉤棒來操作熔管的分合，以斷開和接通空載的架空線路、小容量空載變壓器和小負荷電流。
  10. For aspecial example, the steady current was analyzed for circular section of straight conductor, then the distribution of the current, charge and field quantity were discussed

    通過分析載流圓截面直導線中穩恆電流這一特例，討論了電流、電荷與場量的分佈問題。
  11. D finite element local analysis is done for hv porcelain post insulator by abaqus finite element software. the stress distribution of one - piece structure under dead weight, erection deviation, temperature change, wind load and short - circuited load is analyzed, which provides the scientific basis for security assessment of post insulator

    以高壓瓷瓶支柱絕緣子為研究對象，採用abaqus有限元軟體進行三維有限元局部分析，分析了整體結構在自重、安裝偏差、溫度變化、風載以及短路電流載荷作用下的應力分佈，為支柱絕緣子的安全性評定提供了科學的依據。
  12. ( 2 ) the method of finite element discrete and optimal parameter back analysis is adopted. ( 3 ) concentrated on the question of high external water pressure of the deep - lying tunnel, the basic theory and method calculating external water pressure are systematically studied. ( 4 ) based on jinping cascade 2 hydropower station, numerical simulation rain infiltration of seepage field under different drainage pattern and grouting pattern are studied, also, the high external water pressure is analyzed and studied and some seepage control measures are put forward

    （ 2 ）採用有限元離散?優化法進行參數的反演分析； （ 3 ）針對深埋隧洞的高外水壓力問題，進一步分析和研究了襯砌水荷載及外水壓力的作用機理和計算方法； （ 4 ）以錦屏二級水電站深埋長引水隧洞作為本文的主要研究對象，採用考慮降雨入滲滲流場分析的方法對排水方案和灌漿封堵方案不同情況下的滲流場的水頭分佈進行了數值模擬，並對其外水壓力進行了分析和研究，提出了滲流控制的具體措施。
  13. Specifications : power input : standard 220vac, 50hz power output : standard 12vdc, 5a control electric locks or bolts directly. reduce the load of access controller lower potential trouble nc no output, control all kinds of electric locks delay control circuit unlock delay time in 0 10s auto protection dimension : 180x77x77mm weight : 1540g

    功能特性：交流輸入：標準220vac ， 50hz直流輸出：空載輸出14vdc ，負載輸出12vdc ，標準輸出電流： 5a直接控制電鎖：可減小門禁控制器的負荷，節省工程布線，減少故障隱患。
  14. Under a constant applied load and sliding speed, the wear rate of cu - nanosized tib2 in - situ composites was increased with increasing the electric current. the predominant electric wear mechanisms of the cu - nanosized tib2 in - situ composites are abrasive wear and arc erosion

    在一定載荷和滑動速度下，隨電流的增加， cu -納米tib2原位復合材料的磨損率增加， cu -納米tib2原位復合材料的電接觸滑動磨損機制主要為磨粒磨損和電侵蝕磨損。
  15. After the discussion of the numerical simulation method based on the fdtd method and the pml technique, the motions of the charges and the electrical field lines were first employed to describe the radiation procedures of the pulse electromagnetic waves. then the causes of how the charges are accelerated and how the motion status of the charges are maintained were further studied from the angle of interaction of charge and field. after these analyses, it was pointed out that the pulse radiation is due to the suddenly occurred time - varying electrical field ( displacement current ) in the open space. this view was further evidenced by two examples : one is the partly resistance loaded antenna, the other is the partly curved antenna. the radiation procedures of the pulse electromagnetic waves of many different situations were simulated throughout this paper with the contours and waveforms of electric field given. these figures are very helpful to the understanding of the radiation mechanism of the pulse electromagnetic waves

    在討論了基於時域有限差分法和完全匹配層技術的數值模擬方法之後，首先從運動電荷和電力線的角度直觀地描述了脈沖電磁波的輻射過程，然後進一步從場與電荷相互作用的角度分析了天線上電荷是如何被加速以及如何維持其運動狀態的，指出了開放空間中突然出現的時變電場（位移電流）是脈沖電磁波輻射的根本原因.文中還對局部電阻加載的天線和局部彎曲的天線進行了研究，以進一步說明上述觀點.對多種情況下的脈沖輻射過程進行了數值模擬，並給出了電場的等高線和空間波形圖，這些圖形對理解脈沖電磁波的輻射機理非常有益
  16. The testing principle and the performing method of testing items such as speed, range, load, discharge voltage and current for electro - hybrid bicycle are described based on deciding the items

    分析和確定了電動助力車主要性能的檢測項目，並對車速、續行里程、載荷、蓄電池的放電電壓和放電電流等被測項目的檢測原理及實現方法進行了探討。
  17. The design of cable dome is divided into three parts : pre - stressed calculation, static load applied calculation and variation load applied calculation. ansys software was adopted to compute the structure. the ansys program has many analysis capabilities, ranging from structural analysis, thermal analysis, electromagnetic field analysis to cfd flotran analysis

    索穹頂結構分下述三個狀態進行計算：預張拉狀態、施加屋面恆載時的計算和屋面活荷載作用下的計算；本文對索穹頂結構進行計算時所選用的計算軟體為ansys軟體，它是融結構、熱、流體、電磁、聲學於一體的大型通用有限元分析軟體，可廣泛應用於核工業、土木工程、地礦、水利等一般工業的計算及科學研究。
  18. Contacts 3 - 4, 5 - 6 and 7 - 8 are available for load duty, and if required, must be wired in series with the load device or devices, and that series branch circuit connected across a power source compatible with the load

    接線端子3和4 ， 5和6 ， 7和8適用於電負荷，如果需要，應與負荷裝置或其它裝置進行串聯連接，這些串聯支路電流將兼容電源與負載相連。
  19. Therefore, a four - phase charge pump circuit is invented to surmount this problem, but the current loading capability of this circuit is unfavorable and the driving clocks must have four - phase non - overlapped " signals

    針對這個問題，四相位的電荷泵電路由此產生，但是這個電路的電流負載能力不太好並且它的驅動時鐘信號必須是四相位且不重疊。
  20. When the triggering light goes, the avalanche impact ionization and recombination radiation in the domain result in the formation of the carriers " conductive channel in the body of the devices and control the current of the lock - on switching

    當觸發光脈沖消失后，單極電荷疇內雪崩電離和輻射復合在開關體內形成了載流子高導電通道，成為了載流子倍增的源泉，控制著lock - on電流。
分享友人
分享到 Line

分享到臉書