電流載流量 的英文怎麼說

中文拼音 [diànliúzǎiliúliáng]
電流載流量 英文
ampacity
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Calculation of circuit cutting - off on cable in marine degaussing

    船舶消磁工作電纜載流量計算
  2. Standard procedure for the determination of the ampacity derating of fire protected cables

    防火電纜載流量額定降低測量定的標準程序
  3. The ampacities of cables are solved with dichotomy

    電纜的載流量採用二分法進行迭代求解。
  4. Here the conductance, carrier concentration and hall mobility ect parameters of er doped cdte films have been given. using seto model, we calculate the grain - boundary barrier of er doped cdte films and analyze the varing dose influence on the grain - boundary resistance

    討論了不同er離子注入量對硅基底上沉積的cdte薄膜結構和光電性能的影響，並具體給出了摻雜cdte多晶薄膜的電導、載流子濃度及遷移率等參數值。
  5. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  6. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  7. Secondly, their aims are made the investment of substations, feeders or running cost of electric power system minimum. but they do n ' t take into account of land utilization, street accessibility of right of way, etc., but demands of electric power system. generally, a straight line distance, namely, euclid distance, was used for calculating the distance between a load point and a substation, which is a straight forward but non - practical way for most planning techniques

    其次受研究工具的限制，這些模型以工程投資、運行費用等最小為目標，僅能考慮導線載流量、電壓降等電力系統技術約束條件，簡化略去了用地限制、街道可達性等重要的自然約束條件，且求解這些模型的前奏是計算負荷點到變電所的歐幾里得距離（直線距離） ，簡便但不切合實際（這一點在城市電網規劃中尤其重要） ，因此較難給出技術上可行的最優解。
  8. There is no air inside so as to quickly transpire the heat and bear the bigger carrent

    且無空氣隔層，能將導電排所產生的熱量迅速散發，載流量大。
  9. Transformer feeders shall have a capacity not less than the rating of the transformer

    變壓器饋電線的載流量不應低於變壓器的額定電流。
  10. Calculation of the current rating of electric cables. part 1 : current rating equations 100 % load factor and calculation of losses. section 2 : sheath eddy current loss factors for two circuits in flat formation

    電纜載流量計算.第1部分：載流量公式100 %負荷因數和損耗計算.第2節：雙迴路平面排列電纜金屬套渦流損耗因數
  11. Ampacities of cables installed in cable trays

    安裝在電纜管道中的電纜的載流量
  12. Power cable ampacity tables

    電力電纜的載流量表
  13. Numerical calculation of temperature field and current of underground cable

    地下埋設電纜溫度場和載流量的數值計算
  14. Calculation of the current rating of electric cables. part 1 : current rating equations 100 % load factor and calculation of losses. section 1 : general

    電纜載流量計算.第1部分：載流量公式100 %負荷因數和損耗計算.第1節：一般規定
  15. The choice and definition of mediator - heat transfer resistance and current capacity in the power cable designing

    電力電纜設計中媒質熱阻和載流量的選擇與確定
  16. Cable current carrying quantity was calculated under this special condition

    對此種特定條件下的電纜進行了載流量計算。
  17. The calculation guide of the drum reeling cable ' s current rating

    移動設備用卷繞電纜載流量計算導則
  18. And then, a method of load - flow low - pressure measurement was proposed in the light of the hydraulic - resistance theory of servo valve. the validity of the method was proved by the experimental results. therefore, the measurement of the characteristic of load - flow and no - load flow can be realized by using this method

    然後根據電液伺服閥的液橋理論提出了一種負載流量低壓測量方法，在所開發的測試系統上，利用電液比例閥模擬流量測量裝置對所提出的方法進行了試驗驗證，實現了利用低壓流量計和壓力傳感器進行電液伺服閥負載流量特性和空載流量特性的測量。
  19. Calculation of the current rating of electric cables. part 3 : sections on operating conditions. section 2 : economic optimization of power cable size

    電纜載流量計算.第3部分：有關運行條件的各節.第2節：電力電纜截面的經濟優化選擇
  20. Calculation of the current rating of electric cables. part 3 : sections on operating conditions. section 1 : reference operating conditions and selection of cable type

    電纜載流量計算.第3部分：有關運行條件的各節.第1節：基準運行條件和電纜選型
分享友人
分享到 Line

分享到臉書