電流轉移特性 的英文怎麼說

中文拼音 [diànliúzhuǎnxìng]
電流轉移特性 英文
current transfer characteristics
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 轉構詞成分。
  • : Ⅰ動詞1. (移動) move; remove; shift 2. (改變; 變動) change; alter Ⅱ名詞(姓氏) a surname
  • : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 轉移 : 1 (改換位置) shift; transfer; divert 2 (改變) change; transform 3 [醫學] (擴散) metastasis;...
  • 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
  1. Current transfer characteristic

    電流轉移特性
  2. Firstly, this paper proposes the mathematical model and finite - element analysis model of torque motor with mf and without mf. secondly, the electromagnetic field of torque motor is analyzed using the ansoft maxwell software ; static output torque of torque motor with mf and without mf is calculated. then the rotary angle of torque motor with different input electric current and mf is measured using three - coordinate measurement device

    本文首先給出了添加磁體和不添加磁體的力矩馬達磁路數學模型及有限元分析模型,其次,利用ansoft公司的maxwell磁場分析軟體進行了力矩馬達的二維和三維磁場有限元分析,對添加磁體和不添加磁體的力矩馬達靜態輸出力矩進行了計算,並採用三坐標位測量儀對不同輸入作用下、添加不同體時力矩馬達的角進行了測量,從而對輸出力矩進行了實驗研究。
  3. This thesis analyzes all kinds of throttle components, points out the advantage of adapting eev, and analyzes the start - up and the discharge characteristics of eev, and dynamic response of refrigeration systems when the opening degree of eev is changed, etc. eev is placed into a tumoff position while the unit starts up, and after being kept for a period of time it is placed into a bigger position, after some more time it is put into a basic control

    本文對比分析了冷藏箱製冷系統各種節元件的點,指出子膨脹閥應用的優勢,同時分析了子膨脹閥的啟動以及系統在閥開度變化時的動態響應。子膨脹閥在啟動時應先使子膨脹閥處于關閉位置,延時一段時間后,再將閥開至一個較大的位置,再延時一段時間后到基本的控制。
  4. Performance characteristics of non - transfer arc plasma spray torch

    弧等離子噴槍中弧的工作研究
  5. Abstract : through the analysis of the coordination characteristics between the switch and the fuses in combination, it is shown that the transfer current of combination can be decreased by reducing the prearcing time of fuses in the range of transfer current or by increasing the fuse - initiated opening time ( t0 ) of the switch. the ways to decrease the transfer current for present combinations are put forward

    文摘:本文通過對組合器中負荷開關與熔斷器之間的配合分析,認為減小熔斷器在區域內的弧前時間或適當增加熔斷器觸發的負荷開關分閘時間t0 ,均可降低組合器所需開斷的值,並針對現有組合器提出了減小的具體方案。
  6. The main works are organized as follows : based on the switching function method and time domain simulations, the small disturbance transfer a characteristic through the converter is analyzed. because of the modulation effect of the converter, the small disturbance in the shaft of turbine generator will induce ac voltage component with the same frequency as the disturbance on the dc side. and the resulted ac current on the dc side will have the similar frequency shift when transfers to the stator of the generator

    主要內容包括: ( 1 )基於開關函數法和模擬分析,研究了機組子上次同步頻率的小擾動,在hvdc交直兩側響應的頻率- - - -子上的小擾動經直器調制后,將會在系統直側感應出與擾動同頻率的壓分量;直擾動反映到交定子側,也將發生頻率偏
  7. This paper analyses the type, function and characteristics of usual proportional control valves and raises a new modificative version in the light of their drawback. that is, basing on the principle of flow amplification and electrical feedback and throughout calculation and analysis on flow closed loop control and pressure flow combination., determination of the minimum controlled pressure difference as well as flow controlling range and structure of main valve and research of the dynamic and static characteristic, the paper puts forward control principle of " flow - load pressure change - displacement revision " and pressure / flow double closed loop, and further expounds that using a proportional controller and a electric mechanical transducer can separately serve the control function of pressure or flow as well as flow pressure combination

    本論文分析了目前常用比例閥的類型、功能、,並針對其不足提出新的改進方案,即:以量放大,反饋兩個原理為基礎,通過對量閉環控制及壓力量復合的計算分析、確定上最小控制壓差及量控制范圍,確定主閥結構、功能研究等,提出了「量? ?負載壓力變化? ?位修正」的控制原理和壓力量雙閉環控制原理,並進一步論述了利用一個比例控制器和一個「?機械換器」就可完成獨立的壓力或量控制功能以及量壓力復合控制功能。
分享友人