電測溫法 的英文怎麼說

中文拼音 [diàncèwēnfǎ]
電測溫法 英文
electric thermometry
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 溫法 : therapy by warming
  1. Abstract : radiate thermometer uses a high definitive operation circuit in the modulation and linerization of weak optical signals. the theory of colorimetry was used in measuring the temperature. analogic channel and digital interfaces were added in order to expand the instrument. a kind of double channel ' s photocolorimeter including its hardware and software is introduced

    文摘:輻射測溫計採用高精度運算電路，對光弱信號進行調制和線性化處理，運用比色法原理對溫度進行檢測.為了便於儀器擴展，增加了模擬量輸出和數字介面，並對光纖式雙通道比色高溫儀的硬體與軟體的關鍵部分作了簡要介紹
  2. Abstract : a 16 - channel temperature detection apparatus with platinic resistance is presented. the method of the down - lead elimination of the platinic resistance and nonlinear correction with positive feedback are discussed

    文摘:介紹了一種經濟實用的16通道鉑熱電阻測溫巡檢顯示儀，並論述了鉑熱電阻的引線消除和用正反饋實現非線性校正的方法。
  3. Method of improving the measurement accuracy of prt

    提高鉑電阻溫度計測量精度的方法研究
  4. Based on the verification regulation of prt, this paper studies the temperature characteristics of prt, suggests a method of improving the accuracy of measurement and supplies the uncertainty of calibration point

    摘要分析了檢定規程對鉑電阻溫度計的要求，通過研究鉑電阻溫度計的測溫特性，提出了提高鉑電阻溫度計測量精度的方法，並給出了在溫度校準點的測量不確定度。
  5. Electrical measurement method of optical pyrometer

    光學高溫計電測法
  6. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  7. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  8. After the temperature measurement system is scaled by the black body furnace, we use least square method and neural network to calculate the temperature respectively according to the images taken from both the black body furnace and the common coal furnace. through comparison the calculation data with the result of thermocouple, an improved method of neural network is proposed. this method is more practical and precise

    根據標定結果，本文用最小二乘和神經網路兩種方法分別對黑體爐和普通煤爐的圖像進行了溫度計算；通過比較熱電偶輸出的溫度值和計算的結果，提出了一種改進的神經網路方法，該方法更適用於工程實際，其測溫精度較高。
  9. Longitudinal and transverse metallographic specimens for microscopic observation were prepared using conventional techniques. the morphology evolution was observed with neophot - 1 metaloscope and amray100b sem

    利用熱電偶測溫方法，對定向凝固過程中固液界面溫度梯度及影響因素進行測試和分析。
  10. On the basis of the engage efficiency and lubricious conditions, theoretical transmission efficiency with the different drive ratios ( 1 / 50 and 6 / 31 ) of involute cylinder worm gears is analyzed. at the same time, the change trend of engage efficiency and transmission efficiency with different design parameters is discussed. the experimental investigation on transmission efficiency

    從漸開線蝸輪蝸桿傳動的嚙合效率和潤滑條件兩個方面對不同傳動比的漸開線圓柱蝸桿的傳動效率進行理論分析，並通過傳動比分別為1 / 50和6 / 31的漸開線圓柱蝸桿設計參數得到蝸桿潤滑條件的理論分析結果和蝸桿嚙合效率、傳動效率的變化趨勢，同時利用電測法對蝸桿傳動的傳動效率、潤滑油平衡溫度進行測試，將測試數據與理論計算結果進行對比分析，得出理論分析結果的正確性。
  11. The system hardware circuits of tipct and the measures for improving the quality of original thermal image are mainly discussed. the primary research content and innovation are as follows : the innovation is that some methods have been proposed to impove the quality of orginal thermal image, such as controlling excitation time, increasing temperature, reducing noise and enhancing emissivity, and so on

    本文主要圍繞電路故障檢測儀的系統硬體電路和熱圖像質量改善方法進行闡述，主要的創新點和研究內容如下:本文主要的創新點是:提出了改善熱圖像質量的幾種方法，如激勵時間控制、增溫法、降噪法和提高發射率法等。
  12. Temperature coefficient measuring methods of output voltage and output current for crystalline solar cells and modules

    晶狀太陽能電池和模塊的輸出電壓和輸出電流溫度系數的測量方法
  13. Measuring methods of photocell - dark current temperature characteristic

    光電池測量方法暗電流溫度特性
  14. Conductivity is a important chemical quantum. in the method of electrod conductivity measure, the measure electrode behave as a complicated electrochemistry system during measure. the factors that infect the precise measure of conductivity is polarization effect, capacitance effect and temperature

    電導率是一種很重要的化學量。在電極電導率測量法中，測量電極表現為一個復雜的電化學系統，影響電導率準確測量的因素主要有三方面：極化效應、電容效應和溫度。
  15. This paper uses general sensing system made of temperature sensors, pressure sensors and liquid level sensors with no directly power supply to realize optically powered measurement of oil tanks liquid level, thus solve the problem that general electricity method applied to the flammability and explosive environments

    本課題以實現油罐液位的光推動測量為目的，利用常規溫度、壓力、液位等電測敏感元件組成的傳感系統在無需直接供電的光推動模式下工作，使其解決了常規電測方法難于在易燃易爆場合下應用的問題。
  16. Measuring method of equivalent cell temperature for crystalline solar cells by the open - circuit voltage

    採用空載電壓的晶體太陽能電池等效電池溫度的測量方法
  17. A device of measuring the crystallization temperature of mold slag based on single thermocouple wire was introdued

    筆者以保護渣結晶溫度為出發點，提出了一種將雙鉑銠熱電偶絲既作為加熱元件，又作測溫元件的熱絲法技術。
  18. Based on analyzing causes of formation of system error, random error and gross error, together with their influences to observation values, method that examine whether there is system error in apparatus by using temperature values of unbonded elastic wire resistance type meters is studied

    在對系統誤差、隨機誤差、過失誤差成因及對監測數據的影響分析基礎上，研究了利用差動電阻式儀器的伴測溫度測值來檢驗儀器是否存在系統誤差的方法。
  19. This paper presents a method to measure the battery capacity based on an ampere - hour method, and discusses the compensation for temperature and battery aging along with the sysytem design and its implementation

    摘要根據安時法提出了一種電池電量的檢測方法，討論了溫度、電池老化的補償措施，並給出了系統的軟硬體設計方法。
  20. In this system, high temperature tvs are used to collect images, digital image processing technology is applied to process images, thermal radiation theory and plane surface array ccd ' s chroma theory are introduced and the three - colour method is discussed detailedly to detect the temperature

    本文旨在以全爐膛看火電視為圖像採集前端設備，以數字圖象處理技術為手段，運用熱輻射學和彩色面陣ccd色度學理論，採用三色測溫法來檢測爐膛火焰溫度。
分享友人
分享到 Line

分享到臉書