電源接地 的英文怎麼說

中文拼音 [diànyuánjiēde]
電源接地 英文
pwrgnd power ground
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1. (水流起頭的地方) source (of a river); fountainhead 2. (來源) source; cause 3. (姓氏) a surname
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • 電源 : source; current source; electric source; power pack; power supply; power source; source of power ...
  • 接地 : [電學] landing; body; ground connection; electrical grounding; grounding; earthing; earth; ground...
  1. Being a method of time - domain electrical magnetic surveying, the transient electromagnetic method ( tem ) can transmit first pulse electromagnetic field to underground making use of loop or electrical source and receive secondary induction field during of the pulse intermission

    瞬變磁法是一種時間域磁測量方法,是利用不回線或下發送一次脈沖磁場,在一次脈沖磁場的間歇期間,採用不線圈收感應二次磁場。
  2. First, passive resistance network was selected as direct current biasing network, which offered direct voltage for base through the resistance voltage divider composed of two resistances, among them the upper resistance connected from the dc to base, the lower resistance connected from the base to ground. the collector connected with dc directly

    直流偏置網路採用無阻網路,通過由兩個阻組成的阻分壓器為基極提供直流壓,上偏阻從串聯到基極,下偏阻從基極到,集極直
  3. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、氣強度、絕緣阻、連續性、泄漏流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、機負載試驗、線彎折、線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  4. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型,用該模型較好描述了sicpmos器件閾值壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線;分析了漏寄生阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響;論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性,分別模擬了室溫下和300時sicpmos器件的輸出特性,分析了柵壓、阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  5. Resolution for ground connection and power supply problem of programme - controled exchange

    程式控制交換機與供問題及其解決措施
  6. With the advance of semiconductor manufacturing, circuits with increasingly higher speed are being integrated at an increasingly higher density, which makes analysis and verification of power grid integrity more important. power grid integrity includes four issues, namely, ir drop analysis, ground bounce analysis, ldi / dt from the pin inductance and em analysis

    隨著超大規模集成路集成度和工作頻率的不斷提高,網格完整性分析變得越來越重要,一般有四個關鍵問題: ir壓降分析、勢上升( groundbounce )分析、來自引腳感的ldi / dt分析和子遷移率em分析。
  7. It was found that the substrate floating potential changes a lot when the grounded state of arc source changed

    在實驗過程中還發現弧不同的方式對基片臺懸浮位有很大的影響。
  8. Under typical discharge condition, the substrate floating potential is - 5v as the arc source is floated to the ground, but drops to - 60v in the case of the anode being grounded

    在典型的放條件下,當陽極時,基片臺懸浮位最高達- 60v ,而當陰極或弧懸浮時,該位通常只有- 10v左右。
  9. A protective method based on voltage - frequency - converter and additional dc measuring the insulation between monitor wire and ground lines of hv double screen cable is developed and realized by analog and digital circuits

    通過分析6kv纜絕緣監視保護的特點,提出了在高壓纜監視線與線之間附加直流並利用v / f轉換實現監視保護的新方法,設計了相應的路。
  10. This project is applied to the control circuit of the frequency converter power source of for measuring ground resistance in an electric substation

    此方案成功應用於變阻測量變頻控制路中。
  11. Transmitting noise is main interfereing source of switch power supply which is coupled through lines of power supply, singal, interlinkage and grouding

    摘要傳導型噪聲是開關的主要騷擾,它可以通過線、信號線、互連線、導體等進行耦舍。
  12. The lightning resisting level of microelectronic device, the property of tvs diode and solid - state discharge triode, three grades protection for power source device, grounding and shield requirement for communication system to protect lightning and the lightning troubles in recent years at hubei electric power company were introduced

    摘要介紹了微子器件耐雷水平、新型防雷器件tvs管和固態放管的特性、裝置的三級保護、通信系統防雷與屏蔽的有關要求和湖北省力公司通信系統中近幾年雷害情況。
  13. By analyzing the inerference in power plant in view of dcs ( distrbuted control system ) used in power plant, the hardware technics of anti - interference, including isolating, screening, grounding, balance and power distribution and the software technics of anti - interference in microcomputer monitoring and control system of power plant are introduced simultaneously

    以分散控制系統為例,分析了火廠中的干擾,介紹了火廠微機監控系統中的抗干擾技術,包括隔離、屏蔽、干擾的抑制等,同時介紹了軟體抗干擾技術。
  14. Aircraft - connectors for ground electrical supplies - part 1 : design, performance and test requirements

    飛行器.器.第1部分:設計性能和試驗要求
  15. The research shows that the protection of the industrial control system are not only need the external lightning protection system such as air terminals, down conductors and grounding system, but also need the internal lightning protection system such as equipotential bonding, shielding and surge protection of information system and electrical system

    經研究,對工業控制系統的防雷保護不僅要做好閃器,引下線,體等基本的外部防護,還要做好等位聯結,屏蔽,信號系統和系統的涌保護等相關內部防雷措施。
  16. For the improvement of reliability and stability of the whole apparatus, meanwhile, for eliminating various electric - magnetic disturbance within the power supply and ground, measures such as filter, grounding, shielding are all taken in technique. the special methods are lc filter for power supply, bypass capacitor for suppressing voltage surge in printed circuit board, shielding layer wrapped in sensor head and overall grounded

    通過採用合理的濾波、、屏蔽等各種方法,尤其是採用lc濾波路、上加旁路容抑制線路板上的壓波動、傳感頭加屏蔽層、傳感頭總體結構等多種抗干擾辦法,減小了線上的各種磁干擾,保證了系統的穩定性和可靠性。
  17. At the same time, optical cables are needed between the corridor equipment and the community center equipment, so a large quantity of optical cables is to be laid in the community

    同時樓道設備與小區中心設備之間需要光纜溝通,要在小區布放大量的光纜。樓道設備的供也同樣存在問題,目前情況下大多數使用照明
  18. Also its equipment environment is poor, and the power supply and grounding conditions cannot even begin to compare with those in the machine room

    以太網入網路層次復雜,而且大部分設備靠近用戶,設備環境較差,都不能與機房相比。
  19. The principle of the fault distance measurement for small current grounding system by injecting dual frequency signal are discussed from many aspects such as the method and the characteristic of the signal, the test of the signal, the method of the line select, the algorithm of the fault distance measurement, and the method of the fault location, etc. the task adopts this kind of principle, in which the signal injection is completed by the coupling between the power source and the pt

    在詳細說明以上三種測距演算法的基本原理后,分析各種演算法的優缺點,從注入信號的方法、特徵,注入信號的檢測,選線的方法,故障測距的演算法,及故障定位的方法等多個方面,論述了本課題採用的應用於小系統的雙頻信號注入式測距原理。其中,信號的注入由功率通過壓互感器( pt )耦合來完成。
  20. Abstract : various measures for anti - interference for embedded control system are stated for enhancing the capability of the system. these include power supply, grounding, isolated input and output channels and circuit design

    文摘:主要對嵌入式控制系統在抗干擾方面提出了各種措施,包括、隔離輸入、輸出通道,以及在路設計上採取了措施,以求提高系統的抗干擾能力。
分享友人