電熔的 的英文怎麼說
中文拼音 [diànróngde]
電熔的
英文
electrically melted-
First to heat pvc and sulfur together at a certain temperature, where the melted sulfur being a fine dehydrogenating agent, captured hydrogen from pvc bone chain and led to an electrially conductive polymer with conjugated electrons
採用聚氯乙烯與單質硫在一定的溫度下加熱處理,在熔融狀態下的單質硫作為良好的脫氫氧化試劑,使聚氯乙烯主鏈脫氫形成具有共軛電子的導電聚合物。Silica tamping material of the electric furnace used for melting cast iron
鑄鐵熔煉電爐的硅砂打結料Melting characteristics amp; amp; operational proceeding of mf induction furnace
中頻感應電爐的熔煉特性及操作High voltage shunt capacitor installation is comp - rised of capacitor cabinets or steel racks capacitor, special fuses for capacitor overload protection, capaci - tor discharge device, air - cored reactor which is applied to restrain surge current and high frequency harmonic, zno arrester without gaps for overvoltage - limiting and high voltage vacuum switch etc. capacitor cabinet is
高壓並聯電容器成套裝置主要由電容器櫃或鋼架電容器電容器過負荷保護專用熔斷器放電裝置專用放電線圈或電壓互感器,抑制涌流限制高次諧波的空芯電抗器和限制過電壓的無間隙氧化鋅避雷器及高壓真空開關Plastics pipes and fittings crushing decohesion test for polyethylene electrofusion assemblies
塑料管材和管件聚乙烯電熔組件的擠壓剝離試驗Specification for electrofusion type polyethylene fittings for outside diameter controlled polyethylene pipe and tubing
控制外徑的聚乙烯管和管路用電熔型聚乙烯配件規范Plastics pipes and fittings preparation of test piece assemblies between a polyethylene pipe and an electrofusion fitting
塑料管材和管件聚乙烯管材和電熔管件組合試件的制備Standard specification for electrofusion type polyethylene fittings for outside diameter controlled polyethylene pipe and tubing
外徑受控的聚乙烯管路用電熔型聚乙烯配件標準規范Available standard ma - spinel bricks differ mainly in the type of magnesia and in the amount and type of their alumina carrier ( sintered and fused ma - spinel , calc. alumina , white fused alumina , etc
目前各種標準的鎂鋁尖晶石磚主要在氧化鎂的數量、種類和它們鋁載體的種類(燒結和電熔鎂尖晶石、鈣,氧化鋁,白電熔等)方面有很大的不同。Rapid repairing mass for converter ismade of electro baked magnesite and high - quality synthetic sandand manufactured by adding high fluidity recarburizer ( beveloped by ourselves ) as addition agent withspecial technique. lt has the characteristics of well fluidity, well rapid fluidityand rpid sintering etc. it is applied to hot patching of large area before or after the converter as rapping hole patching and other parts for converter
轉爐快速補爐料是以電熔鎂砂和優質合成砂為主要原料,配以自行研製的高流動性的增碳劑為添加劑,以特殊工藝生產製成,具有流動性好、快速燒結等特點,適合於轉爐的前後大面的熱修補及出鋼口等部位的修補Much work has been done to prompt the rapid establishment of fuel cell technology in china. with the help of the visiting scholar, p. j. van den enden, the standard performance test of single mcfc has been done smoothly
重建了荷蘭delft大學熔融碳酸鹽燃料電池單電池試驗系統,並以標準氣體、水煤氣、甲烷等氣體作為燃料氣體,獲得了單電池的性能。Our factory adopted high pure electric smelting mullite as main material, which is produced new size the best refuactory throught heat pressure and tem - - perature burning, it is suital ble for steel and ion, metallurgy and ceramics and is special suitable for stove top. stove wall and heat temper ature posmon of hot wind stove
我廠採用高純電熔莫來石做主要原料經高壓成型和高溫燒成而制得的低蠕變磚是一種新型的高級耐火材料,適用於鋼鐵,冶金和陶瓷等行業,特別適用於熱風爐的頂爐墻及各高溫部位。The product is manufactured by taking high purity fused magnesia as raw material and adding a special binder, sintering agent and coagutant through a special production process
該產品是以優質高純電熔鎂砂為主要原料,外加特殊結合劑、燒結劑、促凝劑,經過特殊的生產工藝加工而成。As plasma, welding arc has well electric character. exterior magnetic field can affect shape and movement of welding arc. and the welding bead and drops transfer can also be changed to improve the welding process and advanced the productivity
電弧作為一種等離子體,具有優良的導電性,用外部磁場可以改變電弧的形態和運動特性,影響焊縫熔池和熔滴過渡形式,大大改善焊接工藝,提高焊接生產效率。Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead
通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點,發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下,通過調節焊接迴路中的電感量和電源電壓,可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行,並且熄弧時間最短時,短路過渡頻率最高,在這種情況下,飛濺小,焊道成型好,焊接過程穩定It is applied in manufacturing the automatic structural parts, especially higher environment protective auto inner parts ; low - volt electric insulation parts which need higher impact strength higher wearable properties better heat - resistance colorful and must be made from thermosetting plastic ; low - volt electric structural parts which need no corrosion to free ammonia and formaldehyde mainly preventing the insulation material to corrode the silver electrode ; accessory of dishware and kitchenware which need functionality demand including no melting no dissolving and affording high temperature, and ornamental demand which has colorful performance. the appearance of the product submits granular shape
本產品適用於製造汽車零件,特別是有環保要求的高級轎車的內飾件低壓電器的絕緣結構件,尤其是要求沖擊性能較高耐磨性好耐熱性好和顏色鮮艷的又必須是由熱固性塑料製造的低壓電器絕緣結構件,也適用於對游離氨和游離甲醛含量主要是防止絕緣材料對銀觸頭的腐蝕有要求的低壓電器絕緣結構件餐具和廚房用具等日用品配件,特別是既有不熔化不溶解經得起高溫烘烤的功能性要求,又有色澤艷麗的裝飾性要求的高檔日用品。Using the traits of arc adjust itself of the co _ 2 welding, adopting slow - descending feature or even feature of electrical source equipping with system that delivering the welding rod at the invariable speed, then, the arc burning steadily is realized, and the quality of welding is improved
利用co _ 2氣體保護焊電弧的自身調節特性,採用緩降或平硬特性的電源配等速送絲系統,通過改變電源空載電壓來調節電弧電壓,再利用電弧電壓和熔化速度之間的關系調節焊絲熔化速度使之等於送絲速度,最終實現電弧的穩定燃燒。Output - voltage m odeling of molten carbonate fuel cell st ack
熔融碳酸鹽燃料電池電堆的輸出電壓模型The quality is a burnt magnesia spinel brick made from fused magnesia , low iron sintered magnesia and fused hercynite. this synthetic hercynite is a patent by rhi refractories
它由電熔鎂砂、低鐵燒結鎂砂和電熔鐵鋁尖晶石製成的燒結鎂鐵尖晶石磚,這種人工合成的鐵鋁尖晶石是rhi奧鎂公司的專利。The material of electro - fused magnesia sinter is selected from special grade a natural magnesite or high - purity caustic calcined magnesite, which is fused in arc furnace to finish the products. the products possess high purity, crystal with and compact texture, have high heat - vibration steady and cinder corrosion resistant, it is used for making high quality magnesite bricks, magnesia - carbon bricks
電熔鎂砂是用精選的特a級天然菱鎂石,在電弧爐中熔融制得,該產品具有純度高,結晶緻密,抗渣性強熱震穩定性好,是製作高檔鎂磚,鎂碳磚及不定形耐火材料的重要原料。分享友人