電爐法 的英文怎麼說

中文拼音 [diànlúfǎ]
電爐法 英文
electric furnace method
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. The wet method of building lining in medium frequency electric furnace is that the lining materials is tamped after a certain proportion of water is added into the refractory materials and then mixed evenly

    摘要中頻電爐濕法築爐是在築爐材料中加入一定量的水，混合均勻后，用濕法打結爐襯。
  2. Abstract : the paper shows the design concept, operation onsite, problemscaused and relative solutions to solve the problems for the automatic carburetting device in electric steelmaking in xi ning steel works

    文摘:闡述了西寧鋼鐵廠電爐煉鋼自動增碳設備的設計思想，介紹了現場使用情況、出現的問題及具體解決辦法。
  3. Direct heating in an electric furnace is the dominant commercial practice.

    在電爐內進行直接加熱成了在商業上獨占的方法。
  4. Basic environmental testing procedures. test methods. fire behaviour. analysis and titrations of gases evolved during pyrolysis or combustion of materials used in electrotechnics. exposure to abnormal heat or fire. tube furnace method

    基本環境試驗程序.試驗方法.火災特性.氣體在高溫分解過程中的分析和滴定或電工用材料的燃燒.異常熱力或火災輻照.管式爐法
  5. Test method for ductility of oriented electrical steel

    定向電爐鋼的延展性試驗方法
  6. Use natural hard clay as raw material, melt in electric furnace in the temperature of above 2000 and become into fiber by air blowing

    硅酸鋁耐火纖維（陶瓷棉） ，以天然硬質粘土或配合料為原料，在2000以上的電爐中熔化，用氣流噴吹法成纖。
  7. Based on the theory of piecewise - linear, the paper carries through the research of model self - adaptive control to electric arc - furnace electrode regulator system ( eafers ), and the digital self - adaptive control law of reference model is deduced. then, we designed the software simulation system of eafers according to the law, though which we studied the character of eafers. finally, a set of physical model of eafers, which is realized by hardware circuit, is designed according to the former research

    本文首先應用分段線性化理論，對電弧爐電極調節系統的模型參考自適應控制演算法進行了研究，推導出全數字化的模型參考自適應律；然後根據推導出的自適應律成功的設計出了的軟體模擬系統，用軟體對電弧爐電極控制進行了模擬研究；最後利用電子電路構造出一套完整的電爐煉鋼電極控制硬體模擬系統，對電爐電極調節進行了實驗室電路模擬研究。
  8. The discharge into the atmosphere of converter gas, acetylene, yellow phosphoric tail gas engendered by the electric furnace process, and organic hydrocarbon tail gas must be reported to the local administrative department of environmental protection for approval

    向大氣排放轉爐氣、電石氣、電爐法黃磷尾氣、有機烴類尾氣的，須報經當地環境保護行政主管部門批準。
  9. Sampling and analysis of nickel, ferronickel and nickel alloys - method for determination of sulphur in nickel, ferronickel and nickel alloys by iodimetric titration after induction furnace combustion

    鎳鎳鐵和鎳合金的取樣與分析.第8部分:感應電爐燃燒後用碘滴定法測定鎳鎳鐵和鎳合金中硫的方法
  10. The consumption of electrical energy of electrically calcined furnace during calcining anthracite is studied by adjusting the length of the top electrode, the flue damper and changing the release direction of removed dust produced from charging system of electrically calcined furnace

    摘要根據電?爐?燒無煙煤的工藝原理，通過調整上部電極長度、煙道閘板及改變電?無煙煤前上料系統通風除塵灰的排放方向等工藝控制方法，對電?無煙煤電耗進行研究。
  11. Determination of 8 elements in blast - furnace slag and electric - frunace slag by xrf

    射線熒光光譜法測定高爐渣和電爐渣中8種常見元素
  12. Sampling and analysis of nickel, ferronickel and nickel alloys - method for determination of sulphur in nickel, ferronickel and nickel alloys by infra - red absorption after induction furnace combustion

    鎳鎳鐵和鎳合金的取樣與分析.第7部分:感應電爐燃燒後用紅外測定鎳鎳鐵和鎳合金中硫的方法
  13. Practice heating test of spread sample has been underway and contrasted with traditional electric furnace. production technology, structure and property of the coating have been studied in order to search for a. new technology method with not only enhancing thermal conductivity of coating but also dropping its electrical conductivity and reducing its production cost

    對試樣進行了關鍵熱學性能、電學性能的測試，並進行掃描電鏡分析，對塗覆樣品進行實際加熱測試，並和傳統意義上的電爐進行對比，通過對耐火塗層生產工藝、組織及性能的關系的研究，以探求一種既能提高塗層的導熱性能又能降低導電性能和生產成本的工藝方法。
  14. Abstract : a new method of collecting and cleaning gas and dust for 30 telectric arc furnace was described. the purposes of air environment pollution reduction, the resources recovery and the reuse were acheived

    文摘:敘述了新的除塵方法在石鋼公司電爐煙氣治理上的應用，達到了減少空氣污染及粉塵回收利用的目的。
  15. Abstract : lining etching mechanism in smelting and main factors affecting lining life are expounded by dissecting low carbon fecr furnace lining and testing samples, and some brief views of prolonging lining life are also pointed out

    文摘:通過微碳鉻鐵電爐爐襯的解剖和取樣檢測，論述了冶煉過程中爐襯的侵蝕機理及影響爐襯壽命的主要因素，並指出了延長爐襯壽命的幾點簡要看法。
  16. Electric ovens for household use - methods for measuring the energy consumption

    家用電爐.能量消耗的測量方法
  17. Methods for analysis of water for boiler and for cooling - the determination of ph - the glass electrode method

    鍋爐用水和冷卻水分析方法ph的測定玻璃電極法
  18. Analysis of water used in boiler and cooling system. determination of ph. the glass electrode method for pure water

    鍋爐用水和冷卻水分析方法ph的測定用於純水的玻璃電極法
  19. However, the main material used in the eaf is scrap steel

    然而，在電弧爐法中主要的原料是廢鋼。
  20. Analysis of water used in boiler and cooling system - determination for dissolved oxygen - internal electrolysis

    鍋爐用水和冷卻水分析方法溶解氧的測定內電解法
分享友人
分享到 Line

分享到臉書