電磁測程儀 的英文怎麼說

中文拼音 [diàncícèchéngyí]
電磁測程儀 英文
electromagnetic log
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 儀 : 名詞1 （人的外表） appearance; bearing 2 （禮節; 儀式） ceremony; rite 3 （禮物）present; gift 4 ...
  • 電磁 : [電學] [物理學] electromagnetism電磁安（培） abampere （電磁系電流單位）; 電磁泵 electromagnetic ...
  1. When measuring the magneto performance parameter ， we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard ， and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ； because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable ， it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時，發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表，而觀測到的波形多為不規則的形狀，根據測量原理，顯然不能用其來做定量的分析；由於點火系統的放電過程比較復雜，伴隨著很強的電磁干擾，點火電流、點火電壓都是變量，使得點火能量的測量成為點火系統性能測試的一個難點。
  2. Test method for d - c magnetic properties of materials using ring and permeameter procedures with d - c electronic hysteresigraphs

    使用d - c電子磁滯曲線記錄儀響鈴和磁導儀程序的材料的d - c磁化特性測試方法
  3. The primary theory of absorption and desorption was also explained. the effects of primary process parameters, such as hydrogen pressure, time and temperature on the magnetic properties of ndfeb have been researched. the structure and magnetic properties have been analyzed by means of optical metallographic microscopy, scanning electronic microscopy, x - ray diffraction analysis, infrared oxygen detector and magnetic properties measurement

    本文設計了燒結ndfeb的氫爆制粉設備，對設備調試以及使用過程中出現的主要問題進行了簡要的說明，提出了一系列解決方法；闡述了吸氫、脫氫的基本原理；研究了氫氣壓力、通氫時間、氫爆溫度等基本工藝參數對磁性能的影響；利用金相顯微鏡和掃描電子顯微鏡， x射線衍射分析，紅外線測氧分析及綜合磁性測量儀等手段分析了材料的組織結構和磁性能。
  4. The composition of sample was identified by means of x - ray diffractometer ( xrd ). magnetic properties were measured by vibrating sample magnetometer ( vsm ). the combustion behavior and crystallization process of the gel were studied by means of differential thermal analysis - thermogravimetric analysis ( dta - tg )

    利用x射線衍射儀（ xrd ）確定樣品物相，振動樣品磁強計（ vsm ）進行磁性測量，綜合熱分析儀研究凝膠的燃燒和析晶過程，掃描電子顯微鏡（ sem ）和透射電子顯微鏡（ tem ）觀察粉末的形貌與粒度。
  5. The inspection equipments including speedometer odometer tester and electron tachometer tester all of them are developed and designed by ourselves have reached the advanced quality at home and the same to the magnetizer demagnetizer. all of them can be provided to customer with our quality products together

    公司自主設計開發製造的車速里程錶測試儀和電子轉速表測試儀充磁機退磁器等具有國內先進水平，可隨儀表產品一起滿足顧客的需求。
  6. Solid astra luoyang fire of anti - corrosion materials engineering limited, founded in 1993, is the collection of china ' s famous anti - corrosion materials research and production and fire at the scene for the construction of an integrated enterprise, in addition to fire anti - corrosion coating production, but also professional cathodic protection system for the production of various sacrificial anode and supporting materials, products including magnesium - based, zinc - based, aluminum sacrificial anodes, with magnesium, magnesium rod, with zinc, titanium / mixed metal oxide anode zone, a titanium, astm265, high silicon anode cast iron, steel or cement testing poles, various reference electrode welding mode and flux, mandatory current cathodic protection act by magnetic saturation potentiostatic yee

    洛陽固雅特種防腐防火材料工程有限公司成立於1993年，是國內著名的集防腐防火材料科研生產和現場施工為一體的綜合性企業，除生產防腐防火塗料外，還專業生產陰極保護系統所需的各種犧牲陽極和輔助材料，產品包括鎂基、鋅基、鋁基犧牲陽極、鎂帶、鎂棒、鋅帶、鈦/混合金屬氧化物陽極帶、一級鈦、 astm265 ，高硅鑄鐵陽極、鋼制或水泥測試樁，各類參比電極、焊模和焊劑，強制電流法陰極保護用磁飽和恆電位儀等。
  7. Recommended practice for instrumentation for magnetic flux density and electric field strength meters - 10hz to 3khz

    10hz - 3khz磁通密度檢測儀表和電場強度計的推薦實施規程
  8. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  9. The paper describes the design thought, inspection principle of the intelligent electromagnetic nondestructive testing system ( wfy - 1 instrument ), introduces the whole design procedure of analogue system, digital system and software system

    本文詳細論述了智能電磁無損檢測系統（ wfy - 1儀）的設計思想和檢測原理，詳細介紹了系統的模擬部分，數字部分以及軟體部分的整個設計過程。
分享友人
分享到 Line

分享到臉書