電聲性能 的英文怎麼說

中文拼音 [diànshēngxìngnéng]
電聲性能 英文
electroacoustic performance
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 能名詞(姓氏) a surname
  1. Analysed the frequence compensation and noise response of the op amps extent

    路的頻率補償和噪進行了一定的分析。
  2. Recommended methods of measurements on receivers for television broadcast transmissions - part 5 : electrical measurements on multichannel sound television receivers using the nicam two - channel digital sound - system

    視廣播接收機的推薦測量方法.第5部分:使用nicam雙道數字音頻系統多視接收機的測量
  3. The in - depth analysis of the noise in gilbert mixer including parasitical capacitors, in which the mixer and lna have been connected together and the noise figure of mixer can be expressed explicitly as that of lna

    回在包括寄生容的情況下,對雙差分對混頻器( gilbertmixer )的噪做了深入分析,把混頻器和低噪放聯系在一起,可像低噪放一樣,直觀的表達混頻器的噪系數。
  4. Because this transducer not only has a firm structure and uses the longitudinal mechanic - electricity coupling coefficient of piezoelectric crystals, but also can be easily made, it has very good electricity - sound ability

    由於製作工藝簡單,結構堅固,且又利用壓陶瓷的縱向機耦合系數,因此具有良好的電聲性能
  5. For micro - cavity semiconductor laser, station model is proposed in this paper and its steady - state and instantaneous characteristics when the coupling efficiency of spontaneous emission into a lasing mode is equal to 1 are analysised. for current noise, sp noise, noise, p noise, as well as current modulation, sp modulation, modulation and p modulation, using small - signal approximation, we derive the laser ' s corresponding transfer functions. and we calculate their signal - to - noise ratio ( snr ) gain in various parameters through frequency domain analysis in the premiss of large input snr

    本文對于微腔半導體激光器,提出站模型,夠較直觀簡潔地分析微腔半導體激光器的穩態和瞬態特,利用此模型對具有重要實用價值的= 1的微腔半導體激光器進行了討論;對于流i噪、自發發射壽命_ ( sp )噪、自發發射因子噪、光子壽命_ p噪,以及流調制、 _ ( sp )調制、調制、 _ p調制,在小信號近似下,得到了相應的激光器的傳遞函數;在大信噪比的前提下,對激光器進行了頻域分析,分別計算了它們在不同參數下的信噪比增益,分析了其抗噪
  6. In chapter 6 a digital interception system is designed and its operating principle is introduced. plenty of experimental results are provided here. in chapter 7 a mathematic model of electron beams in crt of computer vdu is given and entropy preservation performance of tempest transceiving system is discussed, a soft - tempest measure is suggested accordingly

    其中第六章設計了數字偵收系統,介紹了其工作原理,並提供了豐富的實驗結果;第七章給出了計算機陰極射線管顯示器子束的數學模型,據此討論了tempest通信系統的保熵,接著分析了數字偵收系統的抗噪
  7. For phonetic signal modulation, if the pass band range of the band pass filter ( bpf ) is 300hz - 3400hz, the anti - noise properties of laser are approximately independent of bias current and parameters of the cavity ; when the pass band range of bpf increases to a certain degree, modulating bias current and parameters of the cavity can improve the anti - noise properties of laser

    對語音調制情況,如帶通濾波器的通帶范圍取為300hz - 3400hz ,則激光器的抗噪基本不依賴于偏置流和腔內參數;當帶通濾波器的通帶范圍增大到一定程度,調整偏置流和腔內參數可以實現半導體激光器的高抗噪
  8. Measurements of the electrical properties of electronic tubes ; measurement of equivalent noise resistance

    子管測量.第8部分:當量噪阻的測量
  9. Surface acoustic wave ( saw ) motor is a novel micro actuator, which generates saw with the electroacoustic transducer and transfers it to the power of saw motor by the frictional force between the slider and the stator

    表面彈波馬達是一種以器產生表面彈波,並通過馬達動子和定子的接觸摩擦將表面彈波振動轉換為馬達動力的新型執行器。
  10. Transfer function of the closed - loop is presented after analyzing every part of the closed - loop of current control. the time - domain and frequency - domain characteristic of the closed - loop is analyzed and the stability error is discussed, and the closed - loop ’ s ability to restrain the noise is simulated by the tool of simulink, so as to optimize the parameters

    分析了穩流環路的各個環節,得出了穩流環路的控制方程,從控制角度分析了該環路的時域、頻域特和穩態誤差,並對環路抑制路噪進行了simulink模擬,從而得出最佳的參數。
  11. Comparing with conventional nyquist converters, - converters greatly release the requirements for high performance of analog circuit and precisely matched components. additionally, these converters exploit the enhanced speed, circuit density and low cost of modern vlsi technologies. currentlly, - adcs have been widely used for audio a / d conversion

    - adc採用過采樣噪整形技術實現高精度模數轉換,和傳統的nyquist率模數轉換器相比,避免了對模擬指標和元器件匹配精度的較高要求,並可充分利用現代vlsi的高速、高集成度、低成本的優點,已成為音頻模數轉換的主要技術。
  12. Due to the good performance of gaas devices of high frequency, high electron mobility and low noise, the high frequency devices are mostly made of gaas materials now

    由於gaas器件優良的高頻、高子遷移率、低噪,所以現在高頻器件一般都選用gaas材料。
  13. The lna is one of the most important and broad components in microwave communication system receiver, and is used to amplify the low level signal. as the first signal processing block after the antenna, the lna determines the noise figure and input voltage swr and greatly impacts the dynamic range

    低噪放大器( lna )廣泛應用於微波接收系統中,是重要器件之一,主要用來放大低平信號,由於是自天線下來第一個進行信號處理的器件, lna決定了整個系統的噪壓駐波比vswr ,並對動態范圍有著較大的影響。
  14. Abstract : a noise model for the analog correlator used in the ultra wideband receivers is proposed due to lack of simulation capability on noise performance of the correlator in current eda tools. the analog correlator circuit is divided into several parts to calculate the equivalent noise sources respectively. the ideal impulse generators, instead of the noise sources, are then applied to obtain the time varying transfer functions. fourier transforms are carried out to explore the relationship between the noise input and output in frequency domain for each part. then the symmetrical noise sources are grouped together and the periodicity of the circuit is utilized to further simplify the model. this model can be used to evaluate noise performance of the correlator

    文摘:給出了分析模擬相關器的噪模型.將相關器分成不同的幾個子模塊后,對各模塊分別計算等效噪源.然後用理想脈沖源代替噪源計算路的時變傳輸函數,接著用傅里葉變換計算輸入輸出的頻域關系.利用路的對稱結構合併對稱的子模塊可以進一步簡化模型.該模型可以用來估計相關器的噪
  15. Subsequently, on the basis of theoretical analysis of the piezoelectric vibrator ' s electro - acoustic transduction embedded in concrete structure, it is concluded that the static force applies no influence on vibrator ' s transducing behaviors when it has been embedded in an unbroken concrete structure. this conclusion has been proved by

    通過對壓的理論分析,得出在混凝土結構不被損毀的前提下,埋入混凝土中壓元的不隨混凝土結構所受靜載荷的變化而變化,相應的測試實驗驗證了理論分析的結果。
  16. The major contents of this part is composed of the basic principle of the if circuit, the affection of the noise performance of the preamplifier to the whole system, the main constitutes of the receiver and their test results and the modulation circuit of the vco, etc. the test result shows that the performance of these circuits is fairly good

    內容涉及:中頻路的基本原理及指標,前置放大路的噪對整個系統的影響,接收機的主要組成部分(前置放大路、 agc放大路)的基本原理、實現方法、測試結果及分析和vco的調制信號產生路的實現及測試結果。與前端聯調結果表明該部分良好。
  17. Electric, sonic properties and measuring methods for sound level meters

    級計的及測試方法
  18. Measurement of the electrical properties of electronic tubes and valves ; methods of measuring noise factor

    子管測試.第6部分:噪系數的測量方法
  19. In view of the importance of rf front - end circuits in the receiver system, the paper finally is focused on the analysis and design of the rf front - end circuits, including the design of low noise amplifier ( lna ), microstrip filter and balanced mixer. all the circuits above are simulated individually using ansoft serenade, and the results are satisfying with the desired performance

    考慮到射頻前端的好壞會直接影響到整機的,文中還重點論述了該接收機射頻前端路的分析和設計,主要包括低噪放大器、微帶濾波器和單平衡混頻器的理論分析和實際設計,並在ansoftserenade環境下進行了模擬模擬,模擬結果符合設計要求。
  20. On basic of researching the principle of phase locked loop, this article analyzes the output signal whose noise characteristics depend on the each part of pll, and designs a scheme to realize the frequency synthesizers using the high performance chips with integrated prescalers and phase detectors. the visualized circuit structure is given in this paper

    本文在研究鎖相環路基本原理的基礎上,分析了鎖相式頻率合成器路中各部件對環路輸出信號噪的影響,設計了以一個高的集成鎖相環頻率合成器晶元為基礎實現頻率合成的方案,並給出了具體的路形式。
分享友人