電聲損耗 的英文怎麼說

中文拼音 [diànshēngsǔnhào]
電聲損耗 英文
electric acoustic loss
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. Abstract : experiments were made on a ultrasonic machining tool with work - piece adhered to ultrasonic transducer head, to machine micro - holes on hard and brittle materials such as soda glass and si, to study the effects of tool materials ， work - piece materials ， amplitude ， machining load ， slurry concentration ， tool length and the size of work - piece on machining rate and wear ratio. in this experiment, the micro - tool was made through wedg

    文摘:通過以wedg放電加工手段製作微細超聲加工用工具，在採用工件加振方式的微細超聲加工機上對碳酸玻璃、半導體硅等硬脆材料試件進行微孔加工的實驗，來探討在某一特定加工條件下工具材料、工件材料、工件的振幅、加工靜載荷、磨料懸浮液濃度、工具長度及工件尺寸等重要因素對加工速度、工具損耗率的影響，為微細超聲加工技術的實用化提供參考依據。
  2. A novel bi - directional dc / dc converter was introduced in the dissertation, which based on refer much converter data. the soft switching, phase - shifted pwm and bi - directional dc / dc converter hang together, depress circuit switch ullage and noise effectively, which provide condition to increase switch frequency, efficiency and reduce size and weight for the converter ; at the same, the converter have the virtue of structure compact, voltage and current stress small etc such as ordinary hard switch converter

    本文作者在查閱國內外大量雙向dc dc變換器資料的基礎上，採用一種新型雙向dc dc變換器的拓撲結構，把軟開關技術和移相控制pwm技術以及雙向dc dc變換器技術有機結合在一起，有效地降低了電路的開關損耗和開關噪聲，為變換器裝置提高開關頻率、效率以及降低尺寸及重量提供了良好的條件。
  3. The soft switching, phase - shifted pwm and bi - directional dc - dc converter hang together, depress circuit switching loss and noise effectively, which provide condition to increase switch frequency, efficiency and reduce size and weight for the converter ; at the same time, it is proved the converter can achieve zvs in larger load variation, and the converter has the virtue of structure compact, voltage and current stress small such as ordinary hard switch converter

    該變換器把軟開關技術和相移控制pwm技術以及雙向dc - dc變換器技術有機結合在一起，有效地降低了電路的開關損耗和開關噪聲，為變換器裝置提高開關頻率、效率以及降低尺寸及重量提供了良好的條件;同時，能拓寬零電壓開關的范圍，使變換器在較寬的負載變化范圍內都能實現軟開關。
  4. Three phase dry type power transformer, which make it with those features : safety, reliability, and energy saving, fireproof, flameproof, simple maintenance etc., the design is advanced ; the structure of products is reasonable and the outline is fine, the main performances of the products are much better than the national standards, for example, partial discharge level no - load loss, on - load loss, noise level, it is adaptable for application on heavy humidity and severely pollute places which are near to lake, sea and rive, as well as, high demand - fireproof, heavy load capacity place, such as : high building, airport, station, port, underground, hospital, electrical power station, metallurgy, shopping center, residential area and petroleum chemical industry, nuclear power station, nuclear - powered submarine

    非包封線圈三相干式變壓器，具有安全可靠節能防火防爆維護簡單等優點。其設計先進結構合理外形美觀。主要性能指標均優于國內標準，如局放水平空載損耗負載損耗噪聲以及能適應高溫度環境使用等，可安裝在靠近湖海河邊污穢潮濕的環境及防火要求高負荷較大的地區，適用於高層建築機場車站碼頭地鐵醫院電廠冶金行業購物中心居民密集區以及石油化工核電站核潛艇等場所。
  5. Dr is made of microwave ceramic with high dielectric constant and very low loss. using dr, the phase noise of an oscillator could be made to be extremely low

    介質諧振器（ dr ）由高介電常數、低損耗的微波陶瓷材料製作而成，它能極其容易地實現微波頻率源的低相位噪聲。
  6. In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )

    與張瑞英博士一起，首次利用該種有源區結構制備出偏振不靈敏半導體光放大器，並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬，在不同信號波長，不同信號功率0 - 200ma的注入電流范圍內，偏振相關損耗均《 0 . 9db ，在耦合差損為7db / facet的條件下，最大fiber - to - fiher增益達10db ，無損操作電流為50 - 70ma ，消光比達50db以上，而噪聲指數則低於8db ，最小可達4 . 6db 。
  7. Also ; claims that such materials as ultra - pure copper or silver in cables create improvements is absolute nonsense, in my opinion ; these do not affect network characteristics significantly

    順便說說，對功放而言，這些超聲能量能產生巨大的超聲功耗，顯然這會使功放產生過熱的情況，有時會損害輸出電路甚至熔斷保險。
  8. The simulated results show that we can improve the sensitivity by setting the optical bias at / 2, reducing the gap of electrode, increasing the overlap integral factor, reducing the insert lose, adopting suitable segmentation number, increasing the electrode length, increasing the optical power, reducing the wavelength and the relative intensity noise and reducing the receive bandwidth ; obtain the wider bandwidth utilizing reducing the electrode length and the capacitance of modulator, segmentation the electrode ; increase the dynamic range using lowering noise, increasing the optical power at the detector and lower optical bias

    通過計算得知，使傳感器相位偏置為/ 2 ，減小電極間距，提高電光重疊因子，減小器件插入損耗，採用合適的分段數，增加電極長度，增大光功率，降低激光的波長，減小相對強度噪聲，減小接收帶寬，對提高靈敏度的效果是非常明顯的。而減小天線長度，降低調制器電容，電極分段，都可以獲取較大的帶寬。降低系統噪聲;增加到達探測器的光功率，採用較低的光學偏置，都可以增大線性動態范圍。
  9. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
  10. The sine wave pulse width modulation ( spwm ) is used to reduce the wastage and the noise of the motor more effectively, as comparing to the equal pulse width modulated pwm

    相對于等寬脈寬調制pwm ，正弦波脈寬調制spwm可以有效地降低電動機的損耗和噪聲。
  11. Incidentally, with power amplifiers, this ultrasonic energy can cause huge amounts of ultrasonic power to be generated, causing the amplifier to overheat for no apparent reason, sometimes damaging output circuitry or blowing fuses

    順便說說，對功放而言，這些超聲能量能產生巨大的超聲功耗，顯然這會使功放產生過熱的情況，有時會損害輸出電路甚至熔斷保險。
分享友人
分享到 Line

分享到臉書