電荷控制參數 的英文怎麼說

中文拼音 [diànhékòngzhìshēnshǔ]
電荷控制參數 英文
charge control parameter
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 參 : 參構詞成分。
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. This software can not only measure the real time data of hydroelectric plant, but also carry out the auto generate electricity on the hydroelectric plan t and ordinal startup - stop of the dynamotor. the software also carrys out the functions of alarm disposal, report forms, print and load curve

    該軟體不僅實現了對水電站內各種模擬參數和數字信號的實時監測功能，還實現了對水電站的自動發電、機組順序啟停的控制，以及報警處理、報表列印、負荷曲線等功能。
  2. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  3. By picking up actual load on road of car body, use the electro - hydraulic servo road simulating system and the remote parameter cantrol system to iterate, take the iterating control target as an accelerated speed signal of spindle nose, iterate separately the loading spectrums on different road surfaces and finally merge the iterated results to obtain the loading spectrums for tests in the test bench

    通過對轎車車身實際道路載荷的採集，採用電液伺服道路模擬系統和遠程參數控制系統進行迭代（迭代控制目標為軸頭加速度信號，對不同路面的載荷譜分別進行迭代，最後將迭代的結果合併） ，得到用於臺架試驗的加載譜。
  4. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比，汽車空調的工作環境惡劣，條件差，控制難度要增加很多，主要體現在以下幾個方面：一是車外熱負荷變化大，難以確定控制參數；二是要求空調負荷大，而且要控制空調使其降溫迅速：三，不便於用電力作為動力源，必須用汽車發動機或輔助發動機來帶動壓縮機，當採用汽車發動機作為動力源時，由於汽車的車速變化大，發動機轉速的變化可從600r min到4000r min ，壓縮機轉速與發動機轉速成正比，其轉速變化高達7倍，給空調系統製冷劑流量控制帶來困難。
  5. Many protective and monitoring functions are integrated in the system, such as earth - fault monitoring, short circuit protection, over - load protection, phase symm etry and phase loss monitoring, over voltage protection, under voltage protection, motor thermal monitoring and so on

    該系統能自動轉換控制方式，具有漏電、短路、過載、斷相、欠壓、過壓等保護功能，並且能通過漢字顯示終端顯示各路負荷的工作狀態和工作參數。
  6. The control parameters influenced the loads of the stall wind turbine small. but it will be bigger to the variable pitch wind turbine and the variable speed wind turbine

    對于bladedforwindows軟體，定槳距失速調節型風力發電機組控制參數的輸入量比較少，對機組載荷的影響也比較小。
  7. ( 2 ) the method of finite element discrete and optimal parameter back analysis is adopted. ( 3 ) concentrated on the question of high external water pressure of the deep - lying tunnel, the basic theory and method calculating external water pressure are systematically studied. ( 4 ) based on jinping cascade 2 hydropower station, numerical simulation rain infiltration of seepage field under different drainage pattern and grouting pattern are studied, also, the high external water pressure is analyzed and studied and some seepage control measures are put forward

    （ 2 ）採用有限元離散?優化法進行參數的反演分析； （ 3 ）針對深埋隧洞的高外水壓力問題，進一步分析和研究了襯砌水荷載及外水壓力的作用機理和計算方法； （ 4 ）以錦屏二級水電站深埋長引水隧洞作為本文的主要研究對象，採用考慮降雨入滲滲流場分析的方法對排水方案和灌漿封堵方案不同情況下的滲流場的水頭分佈進行了數值模擬，並對其外水壓力進行了分析和研究，提出了滲流控制的具體措施。
  8. Many protective and monitoring functions are integrated in the system, such as pilot circuit monitoring, earth - fault monitoring, short circuit protection, over - load protection, phase symmetry and phase loss monitoring, over voltage protection, under voltage protection, motor thermal monitoring and so on. all measuring results, fault states, fault parameters and error messages of six motors controlled by the sys tem are sent to the liquid crystal display module via the existing serial data connection

    該系統能自動轉換控制方式，具有漏電、短路、過載、斷相、欠壓、過壓、過熱等保護功能，通過觸摸式液晶顯示系統，不僅能顯示各路負荷的工作狀態和工作參數，而且能記憶其故障狀態和故障參數。
  9. Charge control parameter

    電荷控制參數
  10. In the charge pump principle section, the principle of linear mode and skip mode are analyzed in detail. the principle of step - up / step - down and the main parameters are also given in there. in sub - block circuit section, the typical circuits including reference, operational amplifier, thermal protection and current limit are introduced

    在電荷泵基本理論中，詳細分析了線性（ linear ）模式、跳周期（ skipcycles ）模式和具有遲滯控制的跳周期模式;同時也介紹了電荷泵的升壓/降壓工作原理以及主要性能參數及其意義。
  11. Taking the soft ? sensing of oxygen content in flue gas, unburned carbon content in fly ash and coal load in ball mill as examples, we emphatically analyze the current status, modeling method of their soft ? sensing and the secondary variable selection in the soft ? sensing ; and also summarize some other thermal parameter soft ? sensing techniques in our country, which is a guidance for the development of the thermal parameter soft ? sensing technique in power plant, and has some value for the optimization of thermal control systems

    以煙氣含氧量、飛灰含炭量、球磨機負荷為例，著重分析和總結了其測量的現狀、軟測量建模方法和二次變量的選取，並概括了國內現有的其他熱工參數軟測量技術，對火電廠熱工參數軟測量技術的發展具有一定的指導意義，對熱工控制系統的優化具有一定的參考價值。
  12. Considering the randomness of physics parameters of structural material, geometric dimensions, damping, loads and closed loop control voltage respectively or simultaneously, the analytic model of the stochastic structure under random forces are built. the solving methods are proposed. the computational expressions of the numerical characteristic of the structural dynamic response are developed

    2 、考慮壓電智能桁架結構物理參數、幾何參數、結構阻尼和外荷載、閉環系統控制電壓分別或同時為隨機變量，構建了結構在隨機力作用下的動力響應分析模型，提出了求解方法，推導出結構動力響應隨機變量的數字特徵計算表達式，通過算例驗證了所建模型和所提求解方法的正確性和有效性。
  13. The unit coordinated control of coal - fired power plant is essential to the automatic generation control ( agc ). in order to get the fast load response characteristic and the stable main parameters that the power network dispatching center required, we must reconsider the existing unit coordinated control schemes by analyzing the specialty of the coal fired power plant

    燃煤電廠的機組協調控制是機組投入自動發電控制（ agc ）的基本條件，為了機組能夠迅速響應電網的負荷要求，同時保證機組各主參數保持相對的穩定，必須在進一步分析機組被控對象的特性的基礎上，重新研究現存機組協調控制方案。
分享友人
分享到 Line

分享到臉書