電蝕陽極 的英文怎麼說

中文拼音 [diànshíyángjí]
電蝕陽極 英文
galvanic anode
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 陽 : Ⅰ名詞1 （太陽; 日光） the sun 2 （山的南面; 水的北面） south of a hill or north of a river 3 （中...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 陽極 : [物理學] positive pole; positive electrode; anode; positive plate; ultor
  1. Preparation of photo - electrochemical anticorrosion tio2 films by anodization method

    陽極氧化法制備光電化學防腐蝕二氧化鈦薄膜
  2. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc （惰性氣體蒸發凝聚原位溫壓法）制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅（冷軋紫銅、電解銅）在酸性硫酸銅溶液和中性含氯溶液中，在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法（ cv ）和電化學阻抗譜（ eis ）等方法。 x -射線衍射（ xrd ）的方法用來估算納米晶銅晶粒尺寸。
  3. In the third chapter, the influence of current density, solution concentration, erosion time and aging in ambient air on the pl spectra of ps suggests that peak would blue shift with current density increasing, and with erosion time and aging time prolonging ; with the increasing of solution concentration, peaks would red shift when solution concentration less than 1 : 1 but blue shift when solution concentration greater than 1 : 1. above phenomena can be explained by quantum confinement and light center model, but do not deny the action of si - h bonding and defect on the surface in the process of photoluminescence. at present, radiation mechanism is still one of the primary problems in the study of ps

    在第z三章中；通過對比，分析了電流密度、陽極化時間、溶液濃度以及自i然氧化時間對多孔硅光致發光光譜的影響，認為在一定的范圍內，多i孔硅的發光峰位會隨電流密度的增大而藍移，要獲得較強的發光，需z要選擇合適的電流密度；隨著腐蝕時間的延長，多孔硅的發光峰位會i發生藍移；當f酸的濃度較小q ： 1 ）時，峰位隨濃度的增大表現為向i低能移動；而當f酸的濃度較大河山時，峰位隨濃度的增大則表現z為移向高能；多孔硅在空氣中自然氧化；其發光峰位發生藍移，而強i度隨放置時間的延長而降低。
  4. As a pre - treatment primer for oxidative and physically drying paints on galvanized steel and non - ferrous metals such as non - anodized aluminum in mildly to moderately corrosive environment

    可作為氧化物理乾燥型油漆的預塗底漆，塗佈於輕微至中等腐蝕性環境下的電鍍鋼板和有色金屬板表面。 （例如無陽極化的鋁板表面） 。
  5. A modified definition of polarization resistance calculated from the equivalent circuit of eis make its value dependent on the grain size. in anodic polarization test ( sweeing and stair - steps ), the maximum ( critical ) current density increases while the passivation potential and breakdown potential lowers with the reduction of the grain size. fegsem images showed the grain growth and pitting corrosion of the nc copper surface, uniform corrosion in the mc copper surface and the broken passivation layer in both surfaces

    在陽極極化實驗（包括掃描法和臺階法）中，致鈍電流雖晶粒尺寸減小而增大，而致鈍電位和擊穿電位都隨著晶粒細化而降低。 fegsem照片發現了納米晶銅的晶粒長大和孔蝕，微米晶銅表面的均勻腐蝕，和兩種銅表面破碎的鈍化膜。
  6. It was found that more rolling passes lead to homogenous rolling deformation and benefit the formation of final cube texture

    並用三維取向分佈函數織構定量檢測和掃描電子顯微鏡觀察、研究了超薄型高壓陽極鋁箔的立方織構及其對腐蝕比電容的影響。
  7. Study on anodic oxidation etching of pan - based carbon fiber

    基炭纖維陽極電解表面刻蝕工藝研究
  8. The electrode potential of zinc was less than that of ndfeb magnetic powders. ndfeb magnetic powders were protected because zinc had been the anode through the electrochemistry corrosion

    金屬鋅鍍層比基體ndfeb電極電位更負，在發生電化學腐蝕作用時，可起到犧牲陽極保護基體的作用。
  9. Craphite anode has the properties of superior electric conductivity, excellent anticorrosion, antioxidation, and high mechanical strength. lt is typically used as an anode in the electrolysis of aqueous sodium chloride

    石墨陽極具有導電性性好、耐腐蝕、抗氧化、機械強度高等性能，主要用於電解食鹽水溶液的電解槽內作陽極使用。
  10. The distinct anodic current peak was observed in the seawater containing srb. it was presumed that it was the result of electrochemical oxidation of sulfide

    在接近自然腐蝕電位（ ecorr ）附近，出現了顯著的陽極電流峰值，電流峰值是硫化物氧化的結果。
  11. The salt spray tester is to test the anti - erosion quality of the surface of all materials after the rust - proof of painting ， coating ， electroplating ， anodinggreasing

    本試驗機是針對各種材質之表面，經油漆、塗料、電鍍、無機及有機皮膜經陽極、防銹油等防腐蝕處理后，測試其製品之耐腐蝕性。
  12. The salt spray tester is to test the anti - erosion quality of the surface of all materials after the rust - proof of painting ， coating ， electroplating ， anoding and greasing

    本試驗機是針對各種材質之表面，經油漆、塗料、電鍍、無機及有機皮膜經陽極、防銹油等防腐蝕處理后，測試其製品之耐腐蝕性。
  13. The anode material of aluminum electrolysis is present in the odiously working environment of high temperature and strong corrosiveness medium, so it is very difficult for modern material science to select inert anode material

    摘要鋁電解陽極材料處在高溫、強腐蝕性介質的惡劣工作環境中，所以惰性陽極材料的選擇是現代材料科學難度很大的課題之一。
  14. The investigation indicates the electrochemical corrosion resistance characteristic of uranium surface has also been enhanced. the corrosion resistance of uranium with high carbon content may be lower than that of uranium with low carbon content. therefore we consider the carbon format ( carbide or free carbon ) may be the mainly reason of improving corrosion resistance

    採用電化學方法，我們得到了表面經超臨界co _ 2處理的鈾試樣在50 g / gcl ~ -中的陽極極化曲線和自腐蝕電流等抗蝕評價指標，結果表明經超臨界co _ 2處理后的鈾樣品其抗化學介質腐蝕性能也有一定的提高。
  15. For example, the silicon is etched anisotropically in the koh solution, the lucent al film is made with the magnetron sputtering system, the pressure hole is drilled by the supersonic stiletto machine and the silicon and the glass are bonded with electrostatic bonding setup

    例如， koh溶液對硅的各向異性腐蝕，磁控濺射臺製作光亮的鋁膜，超聲打孔機製作導壓孔，靜電鍵合裝置對硅島膜與玻璃極板的陽極封接等等。
  16. In this paper, based on the previous research result, by using theory of electrochemical mechanism, probability math, reliability theory, basic theory of pre - stressed concrete structures, structure optimum design, theory of control, maintenance strategy decision theory of structures and etc., the research on steel corrosion monitoring method, structural corrosion damage model, reliability analysis, the maintenance and repair method that based on corrosion control, the optimum structural design method of new bridge structures that consider durability and the optimum maintenance strategy decision theory are carried out. 2. corrosion mechanism and monitoring technique it is widely accepted that the corrosion of steel in concrete structure is a electrochemical process, include the formation of anode & cathode area on metal surface and potential difference between different ' area

    本文在已有理論研究的基礎上，針對預應力混凝土橋梁建設及使用中存在的影響結構耐久性的實際問題，綜合運用電化學理論、概率理論、結構可靠性理論、混凝土和預應力混凝土結構基本理論、結構優化理論及控制維修決策等理論和方法，詳細研究了基於電化學理論的鋼筋銹蝕檢測方法、預應力混凝土橋梁結構的腐蝕損傷模型、可靠性分析、基於腐蝕控制的維修方法、橋梁結構方案選型及優化設計以及在役橋梁結構的優化維修決策等問題第二章混凝土結構的腐蝕機理及檢測技術目前普遍認為，結構混凝土中鋼筋的腐蝕是一種電化學的過程，包括在金屬表面形成陽極（腐蝕）和陰極（鈍化）區域以及不同區域間的電位差等。
  17. Based on different soil corrosion factors and pipe corrosion principle, obligated current negode protection and sacrifice anode protection can be used here

    根據不同的土壤腐蝕因素以及管道腐蝕原理，可以採用強制電流陰極保護和犧牲陽極的陰極保護。
  18. The alloy can be well anodized so it is applied to various structural compenent requiring medium strength, high weldability and corrosion resistance. such as plate, tube, bar and section material used in truck, tower building, vessel, trolley, railway vehicle and furniture

    典型用途：陽極氧化性能良好，用於要求有一定強度，可焊性與抗腐蝕性高的各種工業結構件，如製造卡車、塔式建築、船舶、電車、鐵道車輛、傢具等用的板管，棒，型材。
  19. The results show that, the capacitance of aluminum foils is increased at the different rated formation voltage, the forming time become so little that the power was mostly saved, but the withstanding voltages of the dipping foils become lower. the dipping time and the annealing temperature are the key factors influencing the capacitance of aluminum foils fabricated by sol - gel technology. 2

    結果表明: sol - gel技術在鋁腐蝕箔表面成功制備出了高介電常數的al - ti復合氧化膜;經tio2溶膠處理過的鋁腐蝕箔陽極氧化后，復合氧化膜使不同陽極氧化電壓下的化成箔比容均有不同程度的提高，而且陽極氧化過程變短，節約了電能;但是耐電壓特性變差。
  20. The simulation and experiment result indicate that the dual pole tool weakens the electric field at the side wall of the machined hole and hence leads to the reduction of hole taper and the improvement of the machining accuracy

    模擬計算和加工試驗表明，輔助陽極可以顯著減弱孔側面間隙區域的電場強度，從而有效地抑制發生在側壁的雜散腐蝕，減小孔錐度，提高加工精度。
分享友人
分享到 Line

分享到臉書