電解質相 的英文怎麼說

中文拼音 [diànjiězhíxiāng]
電解質相 英文
bath phase
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 解 : 解動詞（解送） send under guard
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 電解質 : [物理化學] （在溶液中或在熔融狀態下能形成正負離子, 因而能導電的物質） electrolyte; electrolytic
  • 電解 : electrolyze; electrolysis; electrolyzation; galvanolysis 電解銅 [冶金學] electrolytic [cathode] c...
  1. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  2. Most author agree that they include interactions at the contact of solid particles and electrolytic solution which exist in the ground.

    大多數作者認為，它們包括了地層中固體顆粒與電解質溶液接觸面上所發生的相互作用。
  3. Cells with dense ysz films provideopen - circuit voltage ( ocv ) of 1. 08v, which is very close to the ocv predictedby nernst equation

    基於緻密電解質膜的電池開路電壓可以達到1 . 08v ，與根據能斯特方程計算的理論開路電壓相當。
  4. The improvement of the compatibility of nonaqueous electrolytes with electrodes, and the progress on the electrolyte optimization to improve the compatibility of electrolyte with electrodes are introduced

    改善電解質與電極的相容性，提高電極表面鈍化膜的穩定性是提高電池綜合性能的有效途徑。
  5. 2. aqueous solution electrolyte such sulphuric acid starts to decompose about iv or so, but nonaqueous solution such as 1 mol / 1 eunbf4 / pc ca n ' t decompose below 2 - 5v. at the same current, the capacity of capacitors with monaqueous electrglyte is higher than that of aqueous electrolytes, but the former have high internal resistance, the latter has low resistance but it erodes the systems

    由於水系電解質h _ 2so _ 4的耐分解電壓只有1v左右，而非水系電解質1mol 1et _ 4nbf _ 4 pc的為2 . 5v左右，在相同的電流下充放電時，電解質為非水系電解質的電阻大，這樣增大了電容器的內阻；而水系電解質h _ 2so _ 4的電阻低，但是它腐蝕設備。
  6. For the pemfc cathode, besides above the parameters, the effects of the thickness of the reaction layer, the ion conductivity of nafion electrolyte and the electronic conductivity in carbon phase of the reaction layer on the electrode performance have also been investigated

    在對pemfc陰極的研究中，除了以上參數以外還考慮了反應層厚度， nafion ~ （ ? ）電解質的離子傳導率以及反應層中碳相傳導率對電極性能的影響。
  7. Now the ion conductivity of gel polymer electrolyte ( gpe ) can reach the magnitude of 10 - 3s / cm, which can satisfy the practical request. however, it is still lower than that of liquid electrolyte ( 10 - 2 s / cm ), which causes the fall of high rate discharge and low temperature performance of lithium battery

    目前凝膠聚合物電解質（ gpe ）的室溫離子電導率可達10 ~ （ - 3 ） s cm數量級，已經能基本滿足應用的要求，但相比液態電解液的電導率（ 10 ~ （ - 2 ） s cm ） ， gpe的電導率仍然偏低，使得凝膠聚合物鋰離子電池的高充放電速率和低溫性能都大大的降低。
  8. These patterns of urinary excretion, with the exception of phosphate excretion, are similar to those of edit its with hypertension

    上述之變化與成人突發性高血壓癥病人的尿電解質排泄狀況相似。
  9. Standard practice for electrolytic extraction of phases from ni and ni - fe base superalloys using a hydrochloric - methanol electrolyte

    用鹽酸甲烷電解質從鎳和鎳鐵積超熱合金中進行相位的電解提取
  10. The compounds that make up both electrodes react with each other via the electrolyte to generate electrons

    用以製成兩個電極的化學物質透過電解質互相反應，產生電子。
  11. 3. when table sugar was used as starting materials, it was used and pyrolyzed directly or was first mined with sulphuric acid after surface area of those materials is not larger than that of pas capacity is small in their electric double - layer capacitor, specific surface area has great effect on capacity, the larger specific surface area is, the higher capacity is, . but bulk density will decrease with increase of specific surface area

    當以食糖為熱裂解碳的原料時，採用直接焦化和酸洗焦化兩種方式。所制備的樣品比表面積沒有聚並苯材料的大，在以30 h _ 2so _ 4為電解質的雙電層電容器中，容量相對較小。電極活性物質的比表面積對雙電層電容器的容量有很大的影響。
  12. The grafted membranes were capable of rejecting an anionic dyestuff. in common with other polyelectrolytes, the conformation of grafted ampsa polymeric chains is sensitive to environmental factors such as ph and ionic strength ( i )

    聚丙烯酰胺基甲基丙磺酸為高分子電解質，接枝在膜表面后高分子鏈與溶質分子相互作用，可使接枝鏈構象發生變化，從而改變膜孔徑的大小，使膜具有環境響應。
  13. The present studies have proved that the most important factor which influences the performances of lithium metal anode in battery is the solid electrolyte interphase interface - film ( sei film ) on lithium anode. and how to make lithium metal anode have a sei film with favorable composition and stable configuration, or make the sei film have better stability, is the key to improve the electrochemistry performances of lithium metal anode in lithium secondary battery

    已有的研究證明:影響金屬鋰負極在電池中性能的主要因素是其表面的固體電解質中間相界面膜（ sei膜）的性能;如何使鋰金屬電極表面具有組成良好、結構穩定的sei膜，或者使鋰電極表面sei膜能夠更好的「穩定化」 ，是提高鋰二次電池中鋰金屬負極電化學性能的關鍵。
  14. Compared with dc - mhd propulsion, ac mode has no electrode and does n ' t apply electric field to fluid directly. thus it avoids the detriment and noise caused by the air bubble generated by electrolysis, and makes the ship more quietly. these characters will help to develop a more efficient ship thruster

    與直流磁流體推進相比，交流磁流體推進方式的最大特點就是沒有電極，因此沒有電極壽命問題，消除了電極表面壓降對推進器效率的影響，也沒有電機表面電化學過程產生的不良效應，如氣泡、電解質對海水的污染等。
  15. The systems that are being used may include the poly - poly system, the poly - electrolyte system and the newly - developed micellar system

    目前主要應用的雙水相體系有高聚物-高聚物體系、高聚物-電解質體系和近年來剛發展起來的膠束雙水相體系。
  16. The reasons of the precipitate cover the following factors : the addition of small quantity of electrolyte in the production, the mixture of two kinds of colloidal solution of opposite electric charge, and heating which would accelerate colloid coagulation and damage liquor stability

    生產過程加入少量電解質、兩種帶相反電荷膠體溶液混合及加熱等是加速白酒膠體聚沉、破壞白酒穩定性，產生沉澱的原因。
  17. Although our country is preliminary in the amtec technology, the correlative technology research has good foundation in our country. there are manufacturers and research schools can produce the solid electrolyte and other material. we can carry through and extend this technology so long as we can corporate with these manufacturers and schools

    我國在amtec技術領域的研究工作基本處于起步階段，但國內的相關技術研究已經具備了很好的基礎，目前已有生產廠家和研究院所生產固體電解質等相關材料，與這些生產廠家和研究院所開展技術合作，我們就可以進行這種能量轉換技術的研究和推廣工作。
  18. The stability of nano - alumina aqueous dispersion is tokened by spectrophotometer and particle size distribution instrument. it is proved that when condition is dispersant pmaa = 0. 4 %, ph = 9, nano - - alumina content = 4 % ( wt % ), ultrasonic for twenty minites, excellent stable nano - alumina aqueous dispersion can be acquired. nano particle average size is 205nm

    用分光光度計和粒度分析儀表徵了納米粒子水分散液的穩定性，結果表明納米相al2o3濃度為4 % ，分散劑為陰離子聚電解質，用量0 . 4 % ， ph = 9 ，採用超聲波分散20分鐘得到最好的分散效果，納米顆粒的平均粒徑為205nm 。
  19. The compatibilities of sample a3000 with six kinds of electrolytes were investigated too. the compositions of the solid electrolyte interphase ( sei ) films formed during the first charging process were analyzed by ftir spectra. the relationship between the sei films and the compatibilities of samples with electrolytes was examined

    考察了具有最佳貯鋰結構的a _ （ 3000 ）試樣和六種電解液之間的相容性，利用ftir圖譜對a _ （ 3000 ）試樣在上述六種電解液中首次充電時在炭負極表面所形成的sei （固體電解質中間相）膜的成分和織構進行了分析，研究了試樣和電解液的相容性與sei膜的關系。
  20. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
分享友人
分享到 Line

分享到臉書