電解陰極銅 的英文怎麼說

中文拼音 [diànjiěyīntóng]
電解陰極銅 英文
standard specification for electrolytic copper cathode
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 解動詞(解送) send under guard
  • : Ⅰ名詞1 (中國古代哲學認為宇宙中通貫物質和人事的兩大對立面之一) (in chinese philosophy medicine ...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • : 名詞(金屬元素) copper (cu)
  • 電解 : electrolyze; electrolysis; electrolyzation; galvanolysis 電解銅 [冶金學] electrolytic [cathode] c...
  1. Standard specification for electrolytic copper cathode

    標準規范
  2. The influence factors to electrochemical deposition and gradient distribution of pmgcf, such as the predrying extent of the swelling cathode film, the excessive power voltage of the cathode, the ph value of electrochemical reduction medium solutionn, the microstrucure of polymer matrix, were majorly invested in this thesis

    本文著重討論了了溶脹膜的預乾燥程度、位、質溶液的ph值、聚合物基體的結構等因素對金屬在溶脹膜中的沉積分佈以及結晶的形態的影響。
  3. Methods for chemical analysis of electrolytic cathode copper

    電解陰極銅的化學分析方法
  4. Electrolytic cathode copper

    電解陰極銅
  5. Method for photoelectric emission spectrochemical analysis of electrolytic cathode copper

    電解陰極銅的光發射光譜化學分析法
  6. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜( scf )中的溶劑與液中的溶劑相同都是水,克服了以前膜內外不同溶劑之間擴散的問題,結果使得流最終趨於一種穩態,因此可以更好實現用化學條件來控制mpgcf的形態結構;硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為材料時有利於溶漲復合膜( scf )與表面的結合以及膜的剝離,因此是作為的理想材料;化學條件中的乾燥程度和壓能夠明顯的影響離子在膜內的遷移,從而對mpgcf的形態結構造成較大的影響;而提高反應溫度和增大液中離子的濃度也有利於在膜中的沉積生長。
分享友人