電路測試器 的英文怎麼說

中文拼音 [diànshì]
電路測試器 英文
circuit tester
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 名詞(古代占卜用的器具) astrolabe
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 電路 : [訊] circuit (ckt); electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  • 測試 : test; testing; checkout; measurement
  1. On the demand of application and according to the soluhons menhoned above, a method of displacement waiting auto - sy ' nchronizing is put forward, which is based on match filters. at the end a complete and speeflc set of hardware circuits and software programs which haplements the scheme, is also presented in the ancle. the synchronization system was tested in the pool and in the shallow wate near m port, the result of the test shows that its performance is satisfactory

    論文著重介紹實現了跳頻通信系統同步的一般方法,並詳細分析和對比跳頻同步系統的捕獲方案,在此基礎上,提出了一個基於匹配濾波的位移等待式自同步方案,設計、完成並給出了詳細硬體連線圖、軟體程序流程圖和部分程序清單,該自同步方法在實驗室水池實驗取得良好的效果,並在廈門港海域進行了現場實驗,具有較低的誤碼率和一定的檢概率,結果令人滿意。
  2. The test results show that each parameter of the devices and circuits fulfihle the anticipative demand ; some parameters even exceed the demand

    結果表明,件和的各項參數均以達到甚至超過了設計指標要求。
  3. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2控單元連接設計製成輸入輸出子控制檢端子,並在檢面板上布置了obd -診斷插座和燃油壓力表。使該動態系統能實現對噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢;並通過obd -診斷座、 ecu輸入輸出檢端子和故障模擬處理單元實現對噴發動機控系統各傳感控單元、執行進行故障碼讀取與清除;動態數據讀取和波形和故障模擬等。此外,本論文還分析了傳感和執行典型故障波形。
  4. Hardware engineers started working at higher levels of abstraction and using simulators and other forms of automation to do all the stuff they used to do on breadboards

    硬體工程師從抽象的更高層次開始工作,並使用模擬和其他自動化的形式在板上進行原料填充。
  5. Accurate credibility, avoided mutually interference when data is transmitted in the several measurement equipments ( 2 ) for the electronic measure equipments which is out of network test system, it has data storage model oneself. designed a set of data read program that is used exclusively to read the measured data of electronic measure equipments, and it can connect with spc computer, deliver the data to the computer, prepare to carry on the further analysis

    ( 2 )對于未進入網系統的子檢設備,檢設備上本身就有數據存儲,設計了一套專門用來讀取子檢設備保存的量數據的數據讀出,該讀出可與spc計算機相連,將數據傳送給計算機,準備進行進一步分析。
  6. Together with undertaking the power cords designing and researching, it usually takes 15 days to do the development for the new products. the project department has advanced testing equipments mainly including bending testing machine, inserting drawing machine, temperature testing machine, standing pulling machine, internet inspecting machine, chromatic testing machine, static testing machine, salt - spraying machine, burning testing machine, non - toxic inspecting machine

    該部門擁有的驗檢包括:搖擺機2臺插拔力驗機1臺高低溫驗箱1臺立式拉力儀2臺網儀1臺色差儀1臺靜儀1臺鹽霧驗機1臺燃燒驗儀1臺低毒檢儀1臺。
  7. Taking dc motor test as an example, a creative idea of applications of some advanced signal processing tools, such as time - frequency analysis, wavelet, and instantaneous frequency ( if ) evaluation, in motor testing field is presented. the paper systematically summarizes basic theories of time - frequency analysis and wavelet transform based on which an in - depth research of effective if evaluation based on wavelet ridge and wavelet curve is carried out. in the end a fast t - n characteristic testing system with neither torque nor speed sensor is successfully developed

    本論文主要關注小波分析在機性能自動系統中的應用,針對傳統系統以及信號處理技術在領域中應用的不足,以直流機為例,提出了將時頻分析、小波包變換以及基於小波脊的瞬時頻率提取方法應用到領域的新思;較系統地總結了時頻分析和小波變換的基本理論,深入探討了基於小波脊線和小波曲線的瞬時頻率提取,並成功開發了基於正交小波包分析和基於小波脊線的瞬時頻率提取的無轉矩轉速傳感的直流機快速系統。
  8. The experimental results indicate that it is feasible to applied at - speed current testing to at89c51 microprocessor at instruction level. through testing of data paths, we can not only detect the faults arose by data path, but also find the faults brought in by control parts

    實驗結果表明,用全速在指令級對at89c51微處理進行是可行的,通過所有的數據通,不僅可以檢數據通的故障,而且可以檢由於控制錯誤而引起的數據傳送錯誤。
  9. Comparing with local of the same kind product this device have the low cost, good characteristics of interface of person and machine, very suit the chinese state of the nation, and have the value of expansion

    與傳統的方法相比高壓斷儀的特點是:精度高、驗速度快。與國內同類產品相比它具有成本低、人機界面良好的特點,很適合中國國情,具有推廣價值。
  10. Standard for metal - enclosed low - voltage power circuit breaker switchgear - amendment 1 : short - time and short - circuit withstand current tests ; minimum areas for multiple cable connections

    金屬殼密封的低壓力線開關設備標準.修改1 :短時間和短可耐;多纜連接的最小區域
  11. In this paper an fault simulator for iddt testing is presented, which can detect concurrently the multi - faults. due to the subtle error among equipment manufacturing, the gate delays of circuits are not the same but range within limits. which induces the uncertainty of the waveform transforming time

    本文從故障激活的條件入手,利用五值邏輯,對瞬態中的延時變化進行波形分析和波形計算,採用並發模擬演算法,編程實現了一個iddt的故障模擬。實際中由於製造工藝的限制,邏輯門的延時並不相同,而是在一定范圍內變化,引起波形變化的時間不確定。
  12. Etbi can conveniently and efficiently access the structure and function information of rtl circuits for atpg. this dissertation presents a format - transformer, which can transform iscas - 85 and iscas - 89 benchmarks verilog hdl descriptions to inner data structure, etbl, applied in rtl atpg

    並且實現了相應的格式轉換,將veriloghdl描述的iscas - 85和iscas - 89系列的rtl轉換為etbl描述的能運用於rtl產生的內部數據結構。
  13. Base on the existing synchronous sequential circuits fault simulator - hope, the test vector generation method of sequential circuits based on ant algorithm is systematically researched firstly

    本文在同步時序故障模擬? hope的基礎上,率先對基於螞蟻演算法的時序矢量生成方法作了系統的開拓性研究。
  14. The test system including power circuit, restoration circuit, pulse circuit, the circuit of the memory ( sram and flash ), jtag interface circuit, the control circuit of the touch - panel, lcd interface circuit

    系統的功能模塊包括,復位,晶振,存儲( sram和flash ) , jtag介面,觸摸屏控制, lcd介面
  15. Ideal for analyzing designs with both analog and digital components, the 54600 - series scopes combine three critical features

    54600系列示波是分析數字和模擬混合的理想工具,它組合了如下四項關鍵功能特性
  16. Test vector generation based on ant algorithm is presented and implemented, the pheromone computation formula for sequential circuits and status transfer rules are given, and the test results are compared with the results of the other existing test generators - hitec, gatest, cris, digate and strategate, based on standard sequential circuits iscas ' 89 and other synchronous sequential circuits

    提出並實現了基於螞蟻演算法的矢量生成,給出了針對時序矢量生成的信息素計算公式和狀態轉移規則。在iscas 』 89標準時序和幾個同步時序上實現了生成,並將生成結果和其它現有生成( hitec , gatest , cris , digate , strategate )的生成結果作了比較、分析。
  17. In the pressure characteristic test, a new method of testing pressure difference is brought out. with an entire bridge circuit and two pressure sensors, the structure is simple but the result is of high precision

    液伺服閥壓力特性實驗中,提出利用兩只壓力傳感通過全橋量差壓的新方法,該方法硬體結構簡單,精度高。
  18. This dissertation focuses on automatic test generation ( atpg ) algorithms for very large - scale integrated circuits at register - transfer - level ( rtl )

    本文主要是對大規模、超大規模集成寄存傳輸級( rtl )的自動產生演算法進行研究。
  19. The main contents are as follows : the structure of mixed - signal circuit which newly - defined in ieee1149. 4 std is analyzed in detail, especially anolog boundary module and test bus interface circuit. on the basis of mixed - signal boundary scan technology, a scheme of mixed - signal boundary - scan test system is presented and the hardwares are implemented, including the controller and display unit

    主要研究的內容以及所作的工作如下:詳細分析了ieee1149 . 4標準中針對混合信號新增的結構,即模擬邊界模塊及介面。基於混合信號邊界掃描技術標準,提出混合信號邊界掃描控制的設計方案並實現了其硬體設計,包括邊界掃描控制模塊、顯示驅動模塊等。
  20. In order to insure pressurize, the edges and corners of the flume box should be agglomerated with right - angle aluminum material. in the part of the water heater circuit design and analysis, base on the induction cooker circuit, the main circuit, control circuit, protection circuit were mainly analyzed. and some circuits those do not relate close to the water heater circuit were ignored

    磁渦流熱水設計分析部分,主要在磁爐的基礎上,著重對主、控制、保護進行分析,分析了的工作原理和工作過程,而對于與磁渦流熱水關系不大的某些探脈沖產生和負載檢等可以忽略。
分享友人