電阻測定 的英文怎麼說

中文拼音 [diànzǔcèdìng]
電阻測定 英文
resistance measurement
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  • 測定 : determine; determination; setting-out; admeasurement; assignment; assay; finding
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc （惰性氣體蒸發凝聚原位溫壓法）制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅（冷軋紫銅、電解銅）在酸性硫酸銅溶液和中性含氯溶液中，在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法（ cv ）和電化學阻抗譜（ eis ）等方法。 x -射線衍射（ xrd ）的方法用來估算納米晶銅晶粒尺寸。
  3. Di - on electric one of the beijing hi - new - tech enterprise develop and manufacture lots of equipment like sf6 dewpoint meter dp100, cable fault location system cfl6000 and more. di - on electric supply the most advanced technology and equipment on such as gis surge arrestor on line monitoring, resistance measuring, ac dc metrology, thermal - temperature bridge, power transformer diagnostic and testing, cable diagnostic and fault location, sf6and oil moisture measuring, oil treatment and testing, optic fiber temperature monitoring, circuit breaker testing, relay testing and more

    迪揚電氣在gis和避雷器的帶電測試與故障診斷分析，電力電纜的故障定位與局放檢測，變壓器電抗器的各種測試診斷與溫度監測， sf6的水分測量與回收，絕緣油的測試分析與濾油處理，紅外測溫與光纖在線測溫，以及各種電阻測試與計量，溫度計量與電能計量等方面擁有世界一流的技術與成熟的儀器設備。
  4. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  5. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  6. Because the former test results were stable and accurate, it was the nation ' s standard method and arbitration basis. the latter was convenient and fast, and therefore, it was commonly applied when the moisture content of the textile was determined in the department for purchasing the cotton fiber and the cotton - tested laboratory of the textile enterprise

    其中，烘箱法因測試結果穩定、準確，是國家標準方法和仲裁依據；直流電阻測濕法方便快捷，在棉纖維收購部門和紡織企業棉檢室採用的棉花水分含量測定中得到了較普及的應用。
  7. In this paper, the main reasons resulting in the errors in measuring the inner resistances of microdetector are analysed, and the improved method are put forward

    摘要分析了光點復射式靈敏電流計內阻測定中誤差產生的原因，提出了改進方法。
  8. Measuring of insulating resistance

    絕緣電阻測定
  9. Semiconductor parameter analyzers, miscellaneous signal generators, oscilloscopes, logic analyzers, multimeters, insulation resistance measurement equipment, dielectric strength voltage testers, noise testers, thermostats

    半導體參數分析儀，各種信號發生器，示波器，邏輯分析儀，萬用表，絕緣電阻測定器，絕緣耐壓檢驗器，噪音檢驗器，恆溫槽。
  10. Resilient floor coverings - determination of the electrical resistance ; german version en 1081 : 1998

    彈性鋪地材料.電阻測定
  11. But the former consumed energy and cost time and unfavorable for the quick - test situation. the stability, accuracy and interchangeability of the former were worse, and therefore, its use was limited

    但烘箱法耗能費時，不利於需要快速測試的場合；直流電阻測濕法的穩定性、準確性和通用性較差，應用場合十分有限。
  12. Resilient floor coverings. determination of the electrical resistance

    彈性地板覆蓋物.電阻測定
  13. Standard practice for determining the impedance of absolute eddy - current probes

    專用旋流探針電阻測定的標準實施規程
  14. Method for determination of the electrical resistance to earth of an installed textile floor covering

    拼裝式鋪地織物對地電阻測定方法
  15. Adhesives - test of adhesives for floor coverings - determination of the electrical resistance of adhesive films

    膠粘劑.地板覆蓋物用膠粘劑的試驗.膠粘劑薄膜的電阻測定
  16. Railway applications - track - test methods for fastening systems - part 5 : determination of electrical resistance

    鐵路設施.軌道.緊固系統的試驗方法.第5部分:電阻測定
  17. Rubber and plastics hoses and hose assemblies - determination of electrical resistance iso 8031 : 1993 ; german version en iso 8031 : 1997

    橡膠和塑料軟管及軟管組件.電阻測定
  18. Test method for measuring resistivity of semiconductor silicon or sheet resistance of semiconductor films with a noncontact eddy - current gage

    半導體矽片電阻率及硅薄膜薄層電阻測定非接觸渦流法
  19. Railway applications - track ; test methods for fastening systems - part 5 : determination of electrical resistance ; german version en 13146 - 5 : 2002

    鐵路設施.路軌.緊固系統試驗方法.第5部分:電阻測定
  20. Standard test method for solidification point of industrial organic chemicals by thermistor

    用熱敏電阻測定工業用有機化學品凝固點的標準試驗方法
分享友人
分享到 Line

分享到臉書