震動轉接 的英文怎麼說

中文拼音 [zhèndòngzhuǎnjiē]
震動轉接 英文
percussive transition
  • 震 : Ⅰ動詞1 （震動） quake; shake; shock; vibrate 2 （情緒過分激動） be greatly excited; be deeply ast...
  • 轉 : 轉構詞成分。
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 震動 : shake; shock; vibrate; quake; chatter; tremulation; succussion; oscillation
  • 轉接 : change-over; throw-over; switch; transfer; transit; reset; adapter coupling; built-up connection
  1. The hardware mainly consists of three parts : signal pre - amplifying and conditioning circuit is used to amplifying the microseismic signals which have detected, signal processing and target identifying circuit based on singlechip is used to convert the analog signals which have been amplified to digital signals and go through signal analysis, processing to identify the moving target, the sending and receiving setting is used to send the identifying result to the decision - making and he can take relevant action according to the result

    硬體主要由三部分組成：信號調理電路對檢測到的微弱地震動信號進行放大；基於單片機的信號分析與目標識別電路將放大后的模擬信號進行a d轉換，進一步將得出的數字信號分析、處理，實現目標識別；識別結果發射與接收裝置將識別結果發射給決策者，由其根據接收結果採取相應的措施。
  2. The notable torsion effects of the surface ground motion above the alluvial valley are illustrated and the torsion effects become stronger as the frequency of the incidence is higher. ( 4 ) antiplane surface motion of the underground circular soft inclusion and the underground homogeneous soft interlayer is investigated in this paper. the results indicate : surface displacement amplitudes just above the soft inclusion of small depth - to - width ratio is amplified and soft interlayer of small depth - to - thickness ratio is amplified to a certain degree, and moreover, the latter is lower limit of the former

    結果表明：垂直入射時，小深寬比軟夾塞上方地表位移幅值有較大的放大，小深厚比軟夾層的地表位移幅值也有一定的放大，且後者為前者的下限；波接近掠入射時，軟夾塞正上方地表點和軟夾層的中國地震局工程力學研究所碩士學位論文一地表位移幅值都沒有放大，而軟夾塞迎波面一側地表點的位移幅值會有一定的放大；軟夾塞上方的地表位移運動有較強烈的扭轉效應，且此扭轉效應隨入射波頻率的增高而增強。
  3. Study on the laser scanner is very important since fluctuate of rotating speed of the motor, wobble of the shaft of the laser scanner, tremble introduced by motor changing phase, shake generated out of dynamic balance, turbulence introduced by the deflector rotating at high speed have an influence on rotating shaft and light beam so as to decrease quality of the laser imagesetter

    轉速的波動、掃描器主軸的晃動、電機換相過程中的抖動、動不平衡產生的震動、轉鏡高速旋轉產生的湍流對轉軸和光束的影響等諸多因素，直接影響激光照排的質量。所以，對轉鏡式激光掃描器的研究有十分重要的意義。
  4. Heavy duty front steering arms with fully adjustable pivot ball suspension. hardened chrome cvd ' s are the same length in all 6 places ( front / rear / center drive )

    強壯的前轉向臂全部用可調校球型連接頭安裝和減震.用同長度鉻加硬的cvd （前/后/中驅動桿）
  5. This is a newly introduced slight shocking, direct driving centrifugal hyro - extractor. the electric locomotive on its base is semi - closed, internal ventilating, self cooling, weight adding and energy saving. the internal drum and rotational drum are istalled on the axel of the locomotive and drived directly, which effectively decreases energyloss, and simplifies therotation. acontrolling box is used in the machine to start through frequency conversion. and stop through resistance. the showing board shows the rotation speed and adjusts the speed and time. the featues of this machine areenergy saving, durable and repair infrequent. this machine is spcially used for cloth hydroectraction

    本機系最新引進直微震直驅式離心脫水機，它使用半封閉內通風自冷加重型專用節能電機裝于中間底座，內桶及轉鼓裝于電機軸而直接驅動之，有效地減小了多功能損耗，簡化了傳統的多級繁瑣轉動，本機配有一個電控箱機變頻起動，電阻剎車於一體面板有轉速顯示並可調速度及時間，該機特點省電、耐用、維修機會極少，本機適合布匹脫水使用。
  6. A hasty lunch was eaten as they stood, without leaving their positions, and then another couple of hours brought them near to dinner - time ; the inexorable wheels continuing to spin, and the penetrating hum of the thresher to thrill to the very marrow all who were near the revolving wire - cage

    到了吃午飯的時間，他們就站在那兒，動也沒有動，就急急忙忙地把午飯吃了，又接連幹了兩個小時的活，才到吃晚飯的時候無情的輪子不停地轉動著，脫粒機的嗡嗡聲刺人耳膜，而靠近機器的人，機器的嗡叫聲一直震到了他們的骨髓里。
  7. Prestack migration method, based on wave motion equation, is also developed for receiver function, and compared with ray method. both p - to - s conversion wave and direct p phase contained in receiver function are migrated and imaged by reverse - time migration for data gather including all receiver functions recorded in all seismological stations for one event, and imaging profile is finally obtained by stacking for all events

    本文還在接收函數射線反投影疊加成像的基礎上，提出了一種基於波動方程的接收函數疊前偏移成像方法，將同一事件接收函數中的轉換波和直達p波震相以各自的速度向深度方向逆時延拓成像，並通過不同慢度接收函數的疊加，得到最終的偏移成像結果。
  8. Ultrasonic plastic welding theory is generated by the generator 20khz or 15khz pressure, high - frequency signals, the system can be adopted for the high - frequency signals into mechanical vibrations, and in plastic products working, through working surface and internal friction among elements spread by the department of the interface temperature, when the temperature reached the melting point of her own, that the working interface rapid melting, and then fill in the gaps between the interfaces when shock stop working at a certain pressure and cooling will be a perfect welding

    的高壓高頻信號通過換能系統，把信號轉換為高頻機械振動，加於塑料製品工件上，通過工件表面及內在分子間的磨擦而使傳處到介面的溫度升高，當溫度達到此工件本身的熔點時，使工作介面迅速溶化，繼而填充于介面間的空隙，當震動停止，工件同時在一定的壓力下冷卻定形成完美的焊接.點擊數： 723錄入時間： 2006 - 5 - 14
  9. Then a semi - rigid joint behavior can be modeled as a finite stiffness rotation spring. basing on rotation and displacement equation, we obtain the element stiffness matrixes with semi - rigid connections where the effects of material nonlinear, hysteresis behavior and shear forces in the connection deformations have been considered in and at the same time we modify the fixed - end forces. finally, a program for calculating the elastic - plastic earthquake seismic of semi - rigid connected steel frame structure by step and step integration of wilson -

    本文在介紹和分析半剛性連接彎矩與轉角連接關系模型的基礎上，用帶有轉動剛度的彈簧表徵半剛性連接，推導出半剛性連接的剛度矩陣，並對桿件固端力進行修正，同時在考慮剪切變形、材料彈塑性、及構件的動力滯回性能的基礎上，編制了結構彈塑性地震動力時程分析有限元計算程序。
  10. Through balance test of gear disk with high speed, it is proved that even if this machine is rotated at high speed, it is stable and no vibration during the period of ordinary operation. being adapeted the interlock apparatus between gear disk with high speed and driving shaft, it is complete reliable in operation

    本機因高速旋轉，故高速齒盤經平衡測試整機在正常使用過程中達到平衡無震動，高速齒盤與傳動軸連接採用鎖緊裝置在使用中更完全可靠。
  11. Through balance test of gear disk with high speed. it is proved that evne if this machine is rotated at high speed. it is stable and no vibration during the period of ordinary operation. being adapted the interlock apparatus between gear disk with high speed and driving shaft, it is complete reliable in operation

    本機因高速旋轉，故高速齒盤經平衡測試整機在正常使用過程中達到平穩無震動，高速齒盤與傳動軸連接採用鎖緊裝置在使用中更完全完全可靠。
  12. By changing some parameters of the original model, such as the location and stiffness of the link members, the location of the transfer - story, the stiffness of the girders on transfer - story, the stiffness of core - tube, the area of the removed slabs and so on, this paper studies the influence of these parameters on seismic behaviour and dynamic characteristics and the seismic behaviours of this building and gives the reasonable proposals on the design of the structure

    在上述研究的基礎上，改變原型結構的有關參數，如連接構件的位置及剛度、轉換層的西安建築科技大學博士學位論文位置、轉換大樑的剛度、核芯筒的剛度、樓板開洞的大小等，分析了上述參數變化對結構的動力特性和抗震性能的影響，並對此類結構的設計提出了合理化建議。
分享友人
分享到 Line

分享到臉書