霧滴蒸發 的英文怎麼說

中文拼音 [wùdīzhēngfā]
霧滴蒸發 英文
evaporation of droplets
  • 霧 : 名詞1. （水蒸氣凝結成的小水點） fog 2. （像霧的許多小水點） fine spray
  • 滴 : Ⅰ動詞（液體一點一點地向下落） drip Ⅱ名詞（一點一點地向下落的液體） drop; droplet Ⅲ量詞（用於滴下的液體的數量） drop
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  2. The key items influent on the characteristics of spraying have been also studied in the dissertation, we can get a good spraying result by adjusting the related parameters efficiently. ( 3 ) the theoretical model of the dynamical parameters such as temperature, moisture, pressure and contour for hot medium and particle inside the drying chamber were obtained by model, utilized the computational fluid dynamics technique to solve the problem between spraying droplets medium by arranging the double grid dispersing structure and rotary outlet structure and the developed structure improved the drying efficiency and product quality

    （ 3 ）採用-模型實現了壓力噴霧乾燥塔的溫度場、濕度場、流場的理論建模，利用計算流體力學（ cfd ）技術來解決噴霧乾燥過程中熱介質與霧滴間的傳熱傳質以及動量傳遞和湍流擾動等問題，避免了乾燥過程中的設計不合理狀況；通過增加雙格柵均風裝置和旋轉出風裝置，改善了乾燥塔內的熱質傳遞，提高了乾燥塔的體積蒸發強度。
  3. The dehydration time is square of the droplets diameter so the small diameters of the droplets can cut down the drying time then reduce the height of the drying chamber. to the combined spin - flow pressure spray drying, the diameters of droplets are small and the dehydration rate is higher so keeping the qualities of the dried products we can increase the speed of the inlet wind and reduce the temperature of the outlet wind thus can improve the evaporation intensity of the drying chamber and the average energy utilization of the drying equipment

    因霧滴的脫水時間與其直徑的平方成正比，減小液滴直徑有利於縮短乾燥脫水時間，可有效降低乾燥塔的高度；由於旋流式組合壓力噴嘴霧化滴徑的減小，脫水速度明顯加快，在不影響乾燥物料性質的前提下，適當提高進風溫度，同時有效地降低排氣溫度，有利於提高幹燥塔的蒸發強度，也有利於提高幹燥設備的平均能源利用率。
  4. This paper analyses the heat absorption and evaporation process of the droplet, the combustion characteristic of motor spirit and ethanol motor spirit, and oxygen concentration of motor spirit and ethanol motor spirit was measured from burning to self extinguishing in the enclosed space

    摘要分析了細水霧滅火時液滴的吸熱蒸發過程和汽油與乙醇汽油的燃燒特性，進行了汽油、乙醇在封閉空間內從燃燒到自行熄滅時的含氧量變化測量。
  5. The fuel diffusion and vaporization model in the intake port of small gasoline engine are analyzed, and the key factors affecting the formation of droplet and film are generalized

    本文對小型汽油機進氣道內燃油霧化和蒸發模型進行了分析，總結出了影響油滴油膜形成和蒸發的主要因素。
分享友人
分享到 Line

分享到臉書