靜力學的 的英文怎麼說

中文拼音 [jìngxuéde]
靜力學的 英文
static
  • : Ⅰ形容詞1. (安定不動; 平靜) still; calm; motionless 2. (沒有聲響; 清靜) silent; quiet Ⅱ名詞(姓氏) a surname
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : Ⅰ動詞1 (學習) study; learn 2 (模仿) imitate; mimic Ⅱ名詞1 (學問) learning; knowledge 2 (學...
  • : 4次方是 The fourth power of 2 is direction
  1. Statics, the physicist knows, is only an abstraction from dynamics.

    物理家知道,只是動一種抽象。
  2. 1. hemodynamic effects of agmatine in dahl salt - sensitive hypertensive and dahl salt - resistant rats the hemodynamic effects of agmatine were investigated in anaesthetized dahl salt - sensitive ( ds ) hypertensive and dahl salt - resistant ( dr ) rats. the results are as follows : ( 1 ) agmatine ( 1, 10, 20 mg / kg, iv. )

    一、胍丁胺對dahl鹽敏感型高血壓大鼠和dahl鹽抵抗型大鼠血流動影響在麻醉dahl鹽敏感型( ds )高血壓大鼠和dahl鹽抵抗型( dr )正常血壓大鼠,研究了注胍丁胺對血流動影響。
  3. Static evaluation is used to determine motions in a direction that bisects the angle between the directions of illumination and observation.

    計算是用來決定照射方向與觀察方向之間角分線方向運動。
  4. For statically determinate frames, the stress-resultants at all sections may be found by statics alone.

    對于定剛架只用就可以求出所有截面上
  5. The problem is placed under the division of statics.

    該問題歸結為靜力學的范疇。
  6. Over pumping of ground-waters produces a difference in hydrostatic head in favor of the seawater.

    過量抽取地下水時,產生利於海水流體水位差。
  7. This course is an introduction to principles of naval architecture, ship geometry, hydrostatics, calculation and drawing of curves of form

    本課程介紹船舶設計、船舶幾何、船舶流體、船體曲線計算與繪圖等科目原理。
  8. Analysing the reasons of floating for objects in the reference system of non - inertia, the paper discusses the relationship between the depth and time, as well as the floating object and its acceleration, these relationships will provide convinient to explain some questions of the hydrostatics

    摘要通過分析浮體在非慣性參考系中浮沉原因,探討浮沉深度與時間關系、浮沉體積與加速度關系,這些關系將給解釋一些流體問題帶來方便。
  9. Statics treats of special cases in which the acceleration is zero, and kinematics deals with motion only.

    是研究加速度為零特殊情況,而運動只討論物體運動。
  10. Simulated experiments effects of intrathoracic pressure change on hemodynamics model i and ii tests demonstrated that the same itpc had different actions on the simulated ventricular fillings. the itpc would not change the pressure in the simulated right heart but its volume while it changed the pressure in the simulated left heart without direct influencing on its volume

    模擬實驗胸壓變化對血流動影響3第四軍醫大博士位答辯論文外周脈壓和模擬胸腔壓變化相同時所引起右心室容積變化是相同;當兩者同時同步變化時,右心室容積無變化。
  11. On the basis of kinetics ' basic principle of well drilling shaker, the kinetic condition of solid phased particles in well drilling liquid, under the status of un submersion, doing four movements as backward sliding, tossing, keeping motionless and forward sliding relative to the surface of vibrating sieve has been analyzed

    摘要根據鉆井篩動基本原理,分析了鉆井液中固相顆粒在非淹沒狀態下相對于振動篩面作后滑、拋擲、止和前滑4種運動狀態條件。
  12. It is assumed that the reader has previously studied the analysis of certain types of trusses in a course of statics.

    假定讀者在課程中已經過某些類型桁架分析。
  13. In a dynamic situation the vector sum of the forces acting on the body vanished as in the static case.

    在動狀態下,作用在物體上矢量和與情形一樣化為零。
  14. When no damaged compartment, damaged stability calculation is just intact stability calculation and when waterplane is horiental, geometric properties calculation is the base of hydrostatic curves. because ship hull is a kind of typical free - form surface, it is satisfactory to be modeled with nurbs

    在這種情況下,船舶性能計算,可以突破以往計算中所必須一些假設及簡化,而是直接通過船舶性能計算基本原理,在船體曲面圖形上直接進行計算。
  15. This paper analyses the engineering feasibility of using the static fem in the fatigue strength design of the shipunloaders structure through discussing the difference of infinite fatigue life design and finite fatigue life design and puts forward the calculating work cycle of this structure after considering the shipunloaders work process. it is useful for crane design - engineer to introduce the general fatigue strength design processes of the shipunloaders

    分析了有限壽命疲勞設計和無限疲勞壽命設計異同,研究了用靜力學的有限元法進行結構疲勞強度設計技術可行性問題;並結合裝卸橋工作過程,提出了相應計算工作循環;介紹了裝卸橋疲勞設計一般步驟
  16. Variational principles for nonlinear elastostatics of orthogonal cable - net structures

    彈性正交索網結構靜力學的各類變分原理
  17. Investigation on piston assembly ' s mechanical load and test computation on thermal load, including the discussion on the analysis on movement and structure dynamics of piston assembly

    此部分包括簡單運動分析和結構靜力學的論述,並於最後指出了活塞組結構動分析難點和重點。
  18. The multi - objective computational model involving static and dynamic objectives was worked out where minimizing compliance and maximizing mean eigenfrequencies were both concerned

    以結構靜力學的剛度和動特徵值作為優化兩個目標函數,提出並建立了連續體結構拓撲優化設計多目標優化模型。
  19. The critical error has been found through computation, which is the error circling the gear. the load sharing characteristics of two kind of star - type gearing train has been determined through comparison. based on computation, the load sharing capability of two - stage external gear train is better than that of two - stage internal and external gear train

    其次,從靜力學的角度分析了各誤差對系統均載性能影響,比較了各誤差對系統均載性能影響大小,得到了較大影響系統均載誤差因素,即圓周方向分佈誤差;比較了兩種星型齒輪系統均載性能,根據計算結果,兩級外嚙合傳動系統均載性能要好於兩級內外嚙合傳動系統。
  20. First, the basic theory of static load sharing mechanism has been presented, mainly including manufacturing and assembly error of each gear component ' s axis and each bearing ' s axis, gear size ( tooth thickness ) errors, simultaneous error of middle two - tooth. the formula of equivalent mesh error has been deduced, the load sharing coefficient has been computed. second, the influences of each error on the static load sharing coefficient have been discussed

    首先,從靜力學的角度研究了星型齒輪系統均載基本原理;確定了影響齒輪系統均載特性製造和安裝誤差,主要包括:各個齒輪構件中心軸線製造和安裝誤差、軸承中心軸線製造和安裝誤差、齒厚偏差、雙聯星輪同時嚙合線誤差;推導了這些誤差當量嚙合誤差計算公式,分析了系統均載特性。
分享友人