靜力矩 的英文怎麼說

中文拼音 [jìnglìjǔ]
靜力矩 英文
first moment
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  1. The structure of the upper platform on the simulating table that is put forward is analysed with analysis software ansys of finite element. and the mass of subjacent platform for simulating table is calculated with the method of equilibrium of moments under conditions of the simulating table is static or operating no take place overturn

    機械設計方面：設計了模擬轉臺上、下平臺的結構，並運用有限元分析軟體ansys對所提出的模擬轉臺上平臺結構進行分析，利用力矩平衡方法計算了模擬轉臺在靜止以及運動過程中不發生傾覆所需要下平臺的質量。
  2. In the paper, the effects of mooring position, towing line length and towing speed on the course stability and towline tension are analyzed firstly for the ship towing system in calm water

    由於在實際海況中，除了受到風、流的影響之外，波浪作用力所造成的影響更為巨大，在波力及波力矩的作用，船隻航行的航向穩定性與靜水中相去剩甚遠。
  3. Firstly, a set of formula is developed for uniplanar x - and multiplanar xx - joints loaded with axial forces, in - plane bending moments and out - of - plane bending moments respectively. in china, it is the first time to develope a set of formula for full - width joints considering the membrane effect

    在總結國內外研究成果的基礎上，本文對方管平面x型和空間xx型相貫節點在軸力、平面內彎矩和平面外彎矩等荷載工況作用下的靜力工作性能建立了一種更合理的理論簡化模型研究方法。
  4. The shear mechanism, failure mode, deformation capacity, bearing capacity and the reliability of the anchored angle steels of the wrapped steel concrete cast - in - site frame typical story exterior joints under the middle and high axial compression ratio ( n = 0. 3, 0. 5, 0. 6 ), the working performance, failure mode, and the shear capacity of top story joints under the crack moment, the hysteresis characteristic and the dissipation energy capacity of the test joints are all analysed based on the 1 / 4 model pseudo - static tests of five specimens of wrapped steel concrete cast - in - site frame exterior joints, which varied in axial compression ratio, distribution of the beam angle steels and the stirrup ratio

    基於上述分析，本次試驗通過五個外包鋼混凝土邊節點1 4比例模型的偽靜力試驗，以柱的軸壓比、梁角鋼布置形式、配箍率等為主要參數，分析外包鋼混凝土現澆框架一般層邊節點在中高軸壓比（ n = 0 . 3 、 0 . 5 、 0 . 6 ）條件下，節點的抗剪機理、破壞模式、變形能力、承載能力和角鋼錨固的可靠性；分析了頂層邊節點在張開彎矩作用下的工作性能、破壞模式和抗剪承載力；分析了試驗節點的滯回性能和耗能能力。
  5. As novel concept actuators, ultrasonic motors have been attracting intensive attention at home and abroad with their outstanding features such as low speed and high torque, large holding torque, rapid response, light weight and compact sizes, simple structure, and no magnetic disturbance, etc. traveling wave ultrasonic motors are especially attracting researchers ’ interest for their good controllability and flexible constructions

    超聲波馬達作為一種全新的驅動器，以低速大轉矩、靜態保持力矩大、響應速度快、體積重量小、結構簡單以及無磁場干擾等優點受到國內外的廣泛關注，其中行波超聲波馬達以其控制性能良好和結構靈活等優點尤為引人矚目。
  6. 3. magnetic powder brake control for automatic unreeling tension system, reeling with moment motor, alloy guide roll in static balance, maintaining stable tension

    3放卷自動張力系統磁粉制動器控制，力矩電機收卷，靜平衡鋁合金導輥，保持了張力穩定。
  7. As novel concept actuators, ultrasonic motors have been attracting intensive attention at home and abroad with their outstanding features such as low speed and high torque, large holding torque, rapid response, light weight and compact sizes, simple structure, and no magnetic disturbance, etc, and which have been applied to many fields

    超聲波電機作為一種全新的驅動器，以低速大轉矩、大靜態保持力矩、響應速度快、體積重量小、結構簡單以及無磁場干擾等優點受到國內外的廣泛關注，並在眾多領域得到了應用。其中駐波超聲波電機具有驅動和控制電路簡單，轉速平穩，波動較小等突出優點。
  8. Thus it is necessary to study moment resistance, rotation stiffness and rotation capacity of the joints. in this paper, six specimens on end - plate composite beam - to - column joints and two specimens on end - plate composite beam - to - column joints were designed to subject to static load. the factors of m - characteristics about semi - rigid composite joints, including bolts, profiled steel sheeting, beam, column, stiffen rib and reinforcement, are studied

    本文設計了6個端板型鋼-混凝土組合樑柱節點與2個端板型純鋼樑柱節點，通過對這些試件的靜力荷載試驗，重點研究了端板型鋼-混凝土組合節點的彎矩-轉角性能的影響因素，包括高強螺栓、壓型鋼板、型鋼梁、型鋼柱、加勁肋，以及混凝土板內縱向鋼筋配筋率等。
  9. Standard test method for measuring the quasi - static release moments of alpine ski bindings

    測量高山滑雪板綁帶的準靜態脫扣力矩的標準試驗方法
  10. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺摩擦特性的方法，通過對轉臺在無外推力作用下的速度衰減曲線的擬合以及電機啟動過程電流和轉速的測量，可以得到最大靜摩擦力矩、庫侖摩擦力矩、粘滯摩擦系數及轉動慣量。
  11. In this paper the research object is new model alternating current servo system. according to the request that was the static state - dynamic state precision and the celerity of response brought forward by task book, aimed at the bad circs of large inertia variety load and the sway of launch flat, we made deep research

    本文以新型交流伺服系統作為研究對象，依據設計任務書所提出的靜態、動態精度和響應快的要求，針對大慣量、變負載和力矩干擾等惡劣情況之下的伺服控制問題進行了深入研究。
  12. Statical equilibrium means that both forces and moments are in balance.

    靜態平衡意味著力和力矩都處于平衡。
  13. The experiment and simulation results show that the stabilization error peak is caused by the step friction torque when the disturbance changes its direction

    實驗和模擬顯示轉臺穩定誤差在擾動換向時的「尖峰」由轉臺轉軸的靜摩擦階躍干擾力矩產生。
  14. A series of static and fatigue experiments which include lots of specimens are performed on bolted composite laminates that include different sizes, different lay orientations and different torques. dye - enhanced x - radiography is used to check the progressive damage process as evaluation techniques, which can be made nondestructively. finally, the ultimate strength and fatigue life of composite bolted joints in static tension and

    層合板接頭的試驗研究考慮了多種幾何尺寸、多種鋪層及不同擰緊力矩對其靜強度及疲勞性能的影響，同時使用滲透劑增強的x射線圖象技術對靜載和疲勞損傷擴展及累積過程進行了無損檢測，並對其進行了分析探討。
  15. Starting from the basic equations of static condensation, the algorithm is available to calculate the rotational response in accordance to structural displacement data by solving the generalized inverse matrix

    該演算法從靜力凝聚的基本方程出發，求解廣義逆矩陣，由結構的位移測量信息計算結構的轉角信息。
  16. Firstly, this paper proposes the mathematical model and finite - element analysis model of torque motor with mf and without mf. secondly, the electromagnetic field of torque motor is analyzed using the ansoft maxwell software ; static output torque of torque motor with mf and without mf is calculated. then the rotary angle of torque motor with different input electric current and mf is measured using three - coordinate measurement device

    本文首先給出了添加磁流體和不添加磁流體的力矩馬達磁路數學模型及有限元分析模型，其次，利用ansoft公司的maxwell電磁場分析軟體進行了力矩馬達的二維和三維磁場有限元分析，對添加磁流體和不添加磁流體的力矩馬達靜態輸出力矩進行了計算，並採用三坐標位移測量儀對不同輸入電流作用下、添加不同特性磁流體時力矩馬達的轉角進行了測量，從而對輸出力矩特性進行了實驗研究。
  17. Talk about how to use the virtual work principle to solve the relative problems of electrostatics, show it ' s simple, direct and convenient to use virtual work principle in working out electric field intensity, electric field force, moment of force

    舉例討論了應用虛功原理求解靜電學有關問題的具體做法，說明在求解電場強度、電場力、力矩等矢量時，應用該原理確實簡捷、方便。
  18. Lognitudinal and transversal members of grillage, regarded as cuved - beam element and straight - beam element, are analyzed by finite element method, and the module for grillage static analysis is formed, by using table of information of nodal point restraint to assemble stiffness matrix for structure in restraint

    將梁格縱橫構件分別按曲梁和直梁兩種單元進行有限元分析，引入結點約束信息表進行約束結構剛度矩陣的組集，形成了曲桿梁格靜力分析模塊。
  19. Nonlinear static analysis of moderately thick rectangular plate considering the coupled effect of elastic foundation

    考慮地基耦合效應的矩形中厚板的非線性靜力分析
  20. The causes and classification of the imbalances of momentum wheels are explained in detail. the formulas for time varying disturbance torques generated by them are deduced, and the corresponding researchs in literatures are fully summarized

    詳細分析了動量輪不平衡產生的原因、分類，給出了動量輪靜動不平衡產生的時變干擾力矩的具體公式，並對文獻相關研究成果進行了較全面的總結。
分享友人
分享到 Line

分享到臉書