靜壓傳感器 的英文怎麼說

中文拼音 [jìngyāzhuàngǎnqì]
靜壓傳感器 英文
static pressure transducer
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 壓 : 壓構詞成分。
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導，對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計，對主噴嘴和測量噴嘴的不同組合，將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計，並通過實驗驗證了理論推導，從而使氣動測量系統量程的示值范圍達到40 m ，靈敏度達到100mv m ，解析度達到0 . 05 m ，測量不確定度小於0 . 2 m ，滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  2. The accuracy of the mfc was 3. 8 % fs, and the rotor flow meter ' s was 2 % fs. 2. the measurement of pressure was carried out by using semiconductor silicon piezometer

    （ 2 ）壓強的測量採用半導體硅壓阻式壓強傳感器，通過測量mpt進氣管路的靜壓，結合理論分析計算得到mpt諧振腔的總壓。
  3. Standard practice for static calibration of electronic transducer - based pressure measurement systems for geotechnical purposes

    土工用電子傳感器型壓力測量系統靜態校準標準規程
  4. The effect of electrostatic force of the drive voltage on the accelerometer had been researched when the bias voltage polarity is positive - negative configuration

    前人在研究驅動信號對傳感器的靜電力效應時，用偏置電壓極性為正?負配置的驅動信號進行研究。
  5. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。
  6. By virtue of their high self - resonance, good transient response and very small measuring distance, the tension compression force transducers are equally suitable for both static and dynamic applications

    依靠它們很高的自振性良好的瞬時響應和很小的測量距離，無論靜態或是動態場合，拉壓力傳感器都同樣適用。
  7. In chapter 3, the mechanism, static and dynamic characters of the piezoresistive accelerometer with the double thin plates - mass. and the simulation of ansys was used for the optimal design of this sensor and obtained the parameters of the structure

    第三章詳細論述了具有雙薄板梁島結構的壓阻式加速度傳感器晶元的工作原理、分析了器件的靜態、動態特性，用ansys模擬並進行了優化設計，在此基礎上確定了傳感器的結構參數。
  8. The disease in jaw surface will be drop the bite force ; the bite force in the patient who disease in temporal jaw joint descent obviously than normal person ; serious mistake in join deformity, the acute damage in the area arthritis can also drop the bite force evidently ; compare to normal children, wenneberg fund that the bite force lower and the duration of the biggest bite force shorter in the children who fall ill of the chronic arthritis ; the bite force also be used in appraise of the recovery condition in surgical operation 、 disorder in jaw arthritis and the serious bone offset in bite lopsided etc. some materials, it will be produce polarization phenomenon inside when suffered some force in certain direction, at the same time, it produce opposite electric charge in two of the surface ; and resume to the station of on - electrification when removed the outside force ; change the direction of the outside force, the polarity of the electric charge also be changed, this kind of phenomenon is called as “ piezoelectric effect ”

    本文設計了石英晶體壓電傳感器，以它作為傳感元件把咬合力信號轉變成電信號;利用ts5860型準靜態電荷放大器把傳感器的電荷信號轉變成電壓信號;選用usb7822數據採集卡，編寫該數據採集卡的驅動程序，採集該電壓信號並送到計算機里;編寫labview程序對該信號進行處理，得出咬合力值和咬合力曲線，並把測量結果以電子表格的形式保存，以便做進一步的分析和研究。通過對該測量儀的靜態標定、動態標定、溫度漂移標定以及實際測量試驗，證實了本測量儀具有較高的靈敏度、受動態力和溫度變化的影響比較小、能實時地顯示咬合力曲線和較準確地顯示咬合力值，滿足了咬合力測量的要求。
  9. Have been several key techniques of making dif - pressure sensors such as plane technics, minuteness engine machining, static sealing etc. in the paper in the intellectualized researching field there are two ways which are examine - form, curve simulanting, to carry out dif - pressure sensors non - linear self - emendating ; adopt the several curves approaching and curve simulating to achieve the aims of dif - pressure sensor error self compensation

    論文首先討論了差壓傳感器的設計原理，並對差壓傳感器中復合敏感晶元（差壓、靜壓、溫度）和整體結構進行了設計，還解決了差壓傳感器製作中的平面工藝、微機械加工、靜電封接及真空充油等關鍵技術。
  10. In the dissertation, the effects of bias voltage polarity on the measurement and the normal operation are deeply researched when the voltage polarity is positive - positive, negative - positive and negative - negative respectively. the results are compared with the ones studied by others when the voltage polarity is positive - negative. the air damping of the laterally driven microstructures is slide - film air damping

    本文通過改變偏置電壓極性分別為正?正、負?正、負?負，並和偏置電壓極性為正?負配置時進行對比，深入研究了電容式傳感器在不同偏置電壓極性下，驅動信號產生的靜電力對傳感器檢測和工作性能的影響。
  11. As for the dynamic performance, the linear variable differential transformer ( lvdt ) displacement sensor using signal conditioner ad598 is not so good, so the differential rectifier is designed as the measuring circuit of the sensor so as to increase its cross - over frequency. also, the static test and dynamic test is made for the sensor along with the lvdt

    由於使用線性差動變壓器信號處理晶元ad598為測量電路的差動變壓器式傳感器的動態性能不夠理想，本文設計製作了差動整流電路作為差動變壓器式傳感器的測量電路以提高傳感器的截止頻率，並對差動變壓器式傳感器進行靜態和動態標定。
  12. This sensor is especially suited to the measurement of static and quasi - static compressive forces

    這個型號的傳感器特別適合於測量靜態或準靜態壓縮力。
  13. Based on silicon - piezoresistive method, the paper first gives the theory of array silicon piezoresistive pressure, acceleration sensor, and the design of its incorporated chip, microstructure and out - circuit. several key techniques of making array silicon piezoresistive pressure, acceleration sensor such as 1c technic, mems ( silicon - silicon direct bonding, anodic bonding, anisotropic etching ) is also studied. minuteness engine machining, anode bonding etc. in the paper there are three ways which are examine - form, curve simulanting, to carry out sensors non - linear self - emendating ; adopt the several curves approaching and curve simulating to achieve the aims of sensor error self compensation, fusion technology etc. therefore, it providing referenced values of ways and directions for sensor system directing on

    論文首先以硅壓阻效應原理為基礎，討論了陣列式硅壓力、加速度傳感器的設計原理，並對陣列式硅壓力、加速度傳感器中集成敏感晶元（壓力、加速度） 、總體結構和壓力陣列的信號處理電路進行了設計，在陣列式硅壓力、加速度傳感器的研製中，還研究了半導體平面工藝、大規模集成電路技術、微機械加工技術（硅硅鍵合、靜電封接、各向異性腐蝕）等關鍵技術的應用。
  14. Aiming at the pressure sensor in fcs, the static nonlinear compensation vi with neural networks ( nn ) is designed using labview. secondly, the dynamic characteristic of the sensor is analyzed

    首先，本文分析傳感器的靜態特性和非線性誤差，利用labview針對飛控系統中的壓力傳感器，運用神經網路方法設計靜態非線性溫度補償儀。
分享友人
分享到 Line

分享到臉書