靜態控制 的英文怎麼說

中文拼音 [jìngtàikòngzhì]
靜態控制 英文
static control
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Firstly, the status of our nation ' s water resources, flood and arid hazards is overviewed to illustrate the necessity for study on dynamic control of flood season limited water level. disadvantages in traditional limitsd water level design, static control of limited water level design, static control of limited water level and fuzzy limited water level curve are pointed out, and mending methods for these are introduced. dynamic control and its key problems are analyzed hi next section. the allowable range of limited water level is determined, so as the allowable extreme risk index. the definition of extreme risk is re - illustrated, risk analysis methods in reservoir operation is discussed either. according to the definition of extreme risk rate, the allowable extreme risk rate of reservoir is systematically demonstrated with variant extreme risk indexes and flood season limited water level

    本文首先闡述了我國水資源狀況和水旱災害、說明水庫汛期限制水位動態控制研究的必要性；介紹了傳統汛限水位設計、汛限水位靜態控制、模糊汛限水位過程線存在的問題及其初步改進方法；分析汛期限制水位動態控制的方法及關鍵問題；進一步闡述了水庫極限風險率的定義；根據極限風險率定義，詳細敘述了不同極限風險指標時、不同汛期限制水位下起調，水庫所能承受的極限風險率計算方法。然後，基於極限風險率計算方法，以白石水庫為背景，研究「考慮壩體自身安全、考慮壩體安全與下游防護對象控制下泄流量的汛限水位動態控制的極限風險率」 。
  2. Both structures have the good control performances

    兩種方案均取得了令人滿意的動靜態控制效果。
  3. You cannot remove static controls at run time

    無法在運行時移除靜態控制項。
  4. And then in detail the paper explains the main technique in sliding construction, which includes jacking scheme, plan layout, assembly, transport and stacking of component, setting of sliding system, setting of track, conformation of falsework, traction facility etc. third, the paper researches on se veral key points which are sum - up about technics flow of sliding construction, the select of falsework by bearing capacity which was calculated through three methods, the theoretic discuss on auto - control, dynamic or static inspect and adjust

    然後對其中的重點問題作進一步的討論，包括滑移法工藝流程的總結；對胎架的選型參考腳手架的計算，運用規范、軟體程序等三種方法進行受力特徵分析，與已有腳手架試驗結果進行比較分析，得出較為符合實際的胎架承載力值；對滑移過程中的自動控制及動、靜態控制監測等做出了應用分析和理論上的探討。
  5. Converter static control is the basic control mode for the converter computer, the dynamic control for sub - lance is on the basis of static control

    摘要轉爐煉鋼靜態控制是轉爐計算機的基本控制方式，副槍動態控制以靜態控制為基礎。
  6. Moreover, we apply nfnn in the problems of static controlling modeling of steel - making and abstract vanadium by converter and come up with the refrigerant adding sub - model

    本文即是把nfnn應用於某鋼廠轉爐提釩煉鋼靜態控制模型的建立問題之中，建立了轉爐煉鋼的冷卻劑加料子模型。
  7. To increase the rate of hitting the grade of liquid steel based on match between converter and continuos caster in capacity is considered as a promising way to improve process control and make production cost - efficient at steel making division. based on lgmis and the model of process - control of converters, the factors, which impact to the hit ratio of grade of liquid steel, have been investigated in details. the influence of quality and availability of primary raw materials, such as hot metal, semi - steel and mixture hot metal and semi - steel, on quality of liquid steel has investigated

    本文結合攀鋼轉爐煉鋼工藝現狀及全連鑄對鋼水質量的要求，從改進煉鋼過程質量控制的角度，以轉爐連鑄機爐機匹配條件下提高鋼種煉成率為目標，在現有lgmis系統和轉爐煉鋼過程靜態控制模型的基礎上，詳細分析了攀鋼轉爐煉鋼的鋼種煉成率以及影響攀鋼轉爐煉鋼的鋼種煉成率的因素，分析了轉爐煉鋼主原料（鐵水、半鋼、混合鐵水）的質量和物流條件對攀鋼煉鋼過程質量的影響，提出了通過控制轉爐煉鋼主原料質量和物流條件改進煉鋼過程質量控制的策略。
  8. In this paper, nonlinear static analysis methods, structural dynamic time history analyses based on structural state equation in hamilton system, multi - mode control theories of multiple tuned mass dampers, and semi active control laws of " on - off " are investigated

    本文分析和研究了結構靜力彈塑性分析方法、基於hamilton體系下結構狀態方程求解結構動力學問題的數值逐步積分方法、多重調諧質量阻尼器（ mtmd ）的多模態控制理論以及建築結構的半主動控制律。
  9. Like static controls, an ime window does not respond to user input by itself

    像靜態控制項一樣， ime窗口類自己不響應用戶的輸入。
  10. This paper focuses on the research of fuzzy control, especially rule self - adjusting fuzzy control method. by theoretic analysis and simulations, the influences of parameters and system performance characteristic of some kinds of rule on - line self - regulating fuzzy control methods are discussed, and a novel real - time self - adjusting fuzzy control method ( vsrsafc ) is proposed from the diagrammatic point of view. in vsrsafc, the slope of the rectifying curve of rule scaling factor a is altered by the fine - tuning and coarse tuning combined mechanism to adjust the fuzzy control rules according to error e and error change ec, which more coincides with characteristic of system response than the conventional self - adjusting method that adjusts rule scaling factor only according to the error e, and has better static and dynamic performances than the latter

    其中變斜率規則自調整模糊控制的效果較為明顯，它是基於插值的非線性規則自調整模糊控制的引申以及常規全論域規則自調整模糊控制的改進，該方法採用粗、細調結合機制，通過改變規則調整因子的修正曲線斜率，使系統同時根據誤差e以及誤差變化ec在線調整模糊控制規則，比傳統的僅基於系統誤差e的自調整方法更符合系統響應特性，可獲得更好的動靜態控制性能，特別是對于系統參數發生改變、控制參數選取不當等不良狀況，控制器仍能較快自調整，具有較強的在線自適應能力。
  11. Controls are those that are added programmatically, or from a web parts catalog, as opposed to static controls that are declared in the markup of a web page

    控制項是以編程方式添加或從web部件目錄中添加的控制項，而靜態控制項是在網頁的標記中聲明的。
  12. Attempts to remove a static control will throw an exception

    嘗試移除靜態控制項將引發一個異常。
  13. We will now create a static control which we will draw the tiles on

    我們將創建一個靜態控制項。在它上面我們將要畫圖塊。
  14. Unlike a dynamic control, a static control is added to an. aspx page on every request

    與動態控制項不同，靜態控制項在每次請求時添加到. aspx頁。
  15. This event applies to both static declared in the markup of a web page and dynamic controls

    此事件對于靜態控制項（在網頁的標記中聲明的控制項）和動態控制項都適用。
  16. The delete verb is not available on static controls controls declared in the markup of the web page

    刪除謂詞在靜態控制項（在網頁的標記中聲明的控制項）上不可用。
  17. If a control is added by declaring it in the markup of a web page a static control, it is always a shared control

    如果在網頁的標記中通過聲明添加了某控制項（靜態控制項） ，則該控制項始終是共享控制項。
  18. Control is a static control, which means the control is declared in the markup of a web parts page and not added to the page programmatically

    控制項是否為靜態控制項，即控制項在web部件頁的標記中聲明，而不是通過編程方式添加至頁中。
  19. You can manipulate the text programmatically with server code

    可以通過服務器代碼以編程方式靜態控制文本。
  20. Contraposing the controller made up of fixed - plus proportion and intelligent integral can not achieve the expectant dynamic and static characteristic, the control strategies of seasoned manipulators are simulated in different phases of step response curve of the system, a nonlinear pid human - simulated intelligent control algorithm is presented by importing p, nonlinear i and fixed - plus d into human - simulated intelligent control

    摘要針對仿人智能演算法中，由固定增益的比例和智能積分組成的控制器不能獲得滿意的動靜態控制性能的缺點，在系統階躍響應曲線的不同階段，模擬了經驗豐富的操作人員的控制策略，將非線性比例環節、積分環節和固定增益的微分環節引入到仿人智能控制中，提出了一種非線性pid仿人智能控制演算法。
分享友人
分享到 Line

分享到臉書