靜態測量 的英文怎麼說

中文拼音 [jìngtàicèliáng]
靜態測量 英文
static measurement
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Htg petroleum and liquid petroleum products - direct static measurements - contents of vertical storage tanks - mass measurement by hydrostatic tank gauging

    石油和液體石油產品立式罐內油量的直接靜態測量法
  2. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  3. The smaller of particle size, the bigger of light scattering energy jumpiness, which reflects jje ( % hi } ) " " & " a ' ^ tjjij ri. ' ff - ' fe ift a " _ abstract that brownnian motion of small particle is more acute than big particle ' s

    （ 2 ）樣品靜態測試中發現在7角處，顆粒粒徑越小，能量跳動量越大，這與顆粒在液體中的布朗運動規律相符合。
  4. Dynamic measurement includes dynamic balance, power efficiency and servo load. the servo load is highly influenced by static lead lag angle

    動態測量包括動態平衡，功效和舵機載荷。舵機載荷對靜前沿滯角度后很敏感。
  5. The static drift error and dynamic test error of liquid floated reactive rate gyro are analyzed also

    分析了液浮力反饋速率陀螺的靜態漂移誤差和動態測量誤差。
  6. By the way, a displaying system and a communicating system is added. this dissertation is divided into four chapters altogether : chapter one is the introduction, introducing the hore component and its important characteristic and putting forward the basic task ; chapter two introduce the principle of the auto - tracking system and respective parts of the auto - tracking system ; chapter three introduce the applications of auto - tracking system under static condition and dynamic condition and give out the experiment results ; chapter four introduced the displaying system, communicating system and the applicability of the auto - tracking system to other sensors

    本文共分為五章：第一章緒論中，介紹了霍爾元件及其一些重要特性，並提出了測量系統的基本方案；第二章詳細介紹了測量系統各部分的構成及原理，特別是對直流通道、溫度補償模塊和音圈電機為核心的隨動機構的論述；第三章介紹了實際系統在靜態測量和動態測量兩種模式下的應用及實驗結果；第四章介紹了系統的顯示功能和遠程通信功能並討論了系統對其它傳感器的適用性。
  7. - the focal point of this paper is studying the problem of cargoes ? weight measurement, besides the component of mechanical system, the component and control of electric - control system, the full - digital dc speed adjustment system and the hardware and software design of plc control system. this paper puts forward the project of current static measurement method and corrects it with acceleration dynamic measurement

    本文除分析介紹了集裝箱橋吊的機械繫統組成、電控系統的組成及控制、全數字直流調速器以及plc控制系統的軟硬體設計外，重點研究了集裝箱裝卸橋中的貨物稱重問題，提出了應用電流靜態測量法的稱重方案，並且採用了加速度動態測量法對其進行動態校正，在實際應用中取得了令人滿意的效果。
  8. In this paper, a new method is proposed, using the instant response of the induction motor to voltage pulse and current break when the motor stops

    本文首先利用感應電動機對脈沖電壓和階躍電流的瞬態響應，對電機參數進行了靜態測量，模擬結果表明了方法的可行性。
  9. Standard test method for static measurements on tires for passenger cars, light trucks, and medium duty vehicles

    乘用車輕型載重車和中型車輛的輪胎靜態測量的標準試驗方法
  10. The hardware circuit design include : industrial control computer configuration, selection of industrial control board type, design of the power supply and monitoring interface circuit, design of signal processing interface circuit ( the constant current source circuit, the time base signal processing circuit, the processing circuit for the signal to be measured ), design of panel control circuit, design of the system self - checking circuit, and etc. the program flow hart include : main program flow chart, system boot - strap self - checking program flow chart, manual static testing program flow chart, semiautomatic static testing program flow chart, automatic static testing program flow chart, dynamic testing program flow chart, transient testing program flow chart, source voltage and current monitor program flow chart, investigate function testing program flow chart, and etc. the measure system offers six working power supplies, the signal of time base, the signal of constant current source, sine wave signal and step to leap signal, and measures the frequency of the output pulse signal of the wide range pulse convert circuit accurately under three kinds of different test state ( static form, dynamic form and transient form )

    硬體電路設計包括：工控機配置、工控板卡選型、產品電源及監控介面電路設計、信號處理介面電路（恆流源電路、時基信號處理電路、被測信號處理電路）設計、面板控制電路設計、系統自檢電路設計等。程序流程圖包括：主程序流程圖、系統開機自檢程序流程圖、手動靜態測試程序流程圖、半自動靜態測試程序流程圖、自動靜態測試程序流程圖、動態測試程序流程圖、暫態測試程序流程圖、電源電壓和電流監控程序流程圖、研究功能測試程序流程圖等。測試系統提供六路工作電源、時基信號、恆流源信號、正弦波信號和階躍信號，並對三種不同測試狀態（靜態、動態、暫態）下大量程脈沖變換電路輸出脈沖信號的頻率進行精確測量。
  11. The input value of static weighing system is instant and the interference is small. nsr is high, then interference signal is ease to dispose. while dynamic weighing systems have different signal modes, yawp interference magnitude size and mode when it is in different facilities and different testing objects. in this thesis has optimum attempt in this point and find a solution which has perfect practicality

    動態定量稱量技術是一項很有前景的技術，在我國發展也有很久了，但是這方面的技術還是不成熟，由於動態比靜態稱量要復雜得多，靜態稱量由於輸入值是恆定、干擾小、信噪比大，干擾信號易處理；而動態稱量系統對不同的設備、不同的測試對象產生的信號形式、噪聲干擾大小、方式均不同。
  12. There are two kinds of ways to measure the railway vehicle wheel tread irreguiarities. one is the static measurement that uses the mechanical ruler, electro - testing apparatus and device equipped with ccd. another is the dgnamic measurement that mainly depends on the technology of ultrasonic and ccd

    鐵路貨車車輛輪對踏面擦傷的測量方式可以分為靜態檢測和動態檢測：靜態檢測主要採用機械測量尺、電子測量儀和基於ccd技術的測量裝置；動態測量主要採用超聲波和ccd技術。
  13. Petroleum and liquid petroleum products - direct static measurements - contents of vertical storage tanks - mass measurement by hydrostatic tank gauging

    石油和液態石油產品.直接靜態測量.立式儲罐容量.流體靜力儲罐量規法的質量測量
  14. The static measurement includes weight, center of gravity, static lead lag, bending stiffness and torsion stiffness

    靜態測量包括重量，重心，靜前沿滯后，彎曲鋼度，和扭區鋼度。
  15. Standard test method for repassivation potential of aluminum and its alloys by galvanostatic measurement

    通過電流靜態測量對鋁及其合金折回潛力測定的標準試驗方法
  16. Test relating to pavement. eveness test. part 4 : continuous static measurement of a profile

    路面試驗.滑度試驗.第4部分:表面的連續靜態測量
  17. The study includes three parts : ( l ) researching on the new static method of physical fitness measurement. ( 2 ) developing an experimental instrument. ( 3 ) making some experiments by the instrument to prove the feasibility of the new method

    課題的研究工作主要由三部分組成： 1 、人體體能靜態測量方法的研究； 2 、實驗樣機的研製； 3 、人體實驗驗證。
  18. On the basis of different characters of static and dynamic measurement, the author corrects error for the system using linear fitting and neural network, respectively, thus achieving satisfactory results

    針對檢測系統靜態和動態測量時誤差的不同特點，分別用直線擬合法和神經網路對系統的誤差進行了修正，達到了令人滿意的效果。
  19. Specification for calculation procedures for static measurement of refrigerated light hydrocarbon fluids

    致冷輕質液態烴靜態測量用計算規范
  20. The new method has the good future. because of the limited conditions our work will be improved by increasing the experiment samples and necessary physiological parameters. we will gradually make the new method available for practical use

    由於條件的限制，我們的工作還有待完善，如進一步擴大實驗樣本量和增加必要的生理參數等，使人體體能靜態測量的新方法一步一步走向實用。
分享友人
分享到 Line

分享到臉書