靜態電流 的英文怎麼說

中文拼音 [jìngtàidiànliú]
靜態電流 英文
current, quiescent
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. With this understanding, the advancing analysis method of the steady - state voltage stability integrated the continuation power flow analysis, the system jacobi matrix eigenvalue structure analysis and the correlative sensitivity analysis, provided the comprehensive and veracious informations about the steady - state voltage stability of power system under the future operating state, these informations - included the margin of stability, the weak buses, the crucial branch and the crucial generator

    提出了將連續潮流演算法與系統jacobi矩陣特徵結構分解法以及相關的靈敏度方法相結合的靜態電壓穩定預測分析方法，這種方法可以提供關于系統在未來運行狀態下的靜態穩定性信息：系統穩定裕度、系統中的薄弱區域、關鍵支路與關鍵發電機。
  2. 5 ) the system ' s sensitivity and snr can be improved by the method of balancing the standing capacitance using dc offset compensation

    採用直流反饋補償的方法消除電容傳感器極板間的靜態電容，提高了系統的解析度和信噪比。
  3. The typical ground current ( quiescent current ) is 1ma at full load, 60 a with no load and, and less than 1 a in shutdown mode

    在滿負載條件下，靜態電流為1ma ;在空載情況下，靜態電流為60 a ;在關斷情況下，靜態電流小於1 a 。
  4. The typical performance characteristics include : line and load transient response, efficiency, output voltage ripple, quiescent current, maximum load current, output voltage temperature characteristics and the short

    其中，整體模擬指標包括:晶元線性調整率和負載調整率、轉換效率、輸出電壓紋波、晶元靜態電流、最大負載電流、輸出電壓溫度特性及短路負載電流。
  5. Describes the design and realization of partial run - time reconfigurable fpga in detail. in order to reduce the affect of the reconfiguration time on system execution time, mostly static circuit design method in logical design stage and incremental routing method in component implementation stage are proposed. the fft parallel processing algorithm is examined through vvp platform

    本章詳細闡述了基於vvp平臺的多sharc功能插板的具體硬體實現，以動態重構fpga設計為核心，論述了局部動態重構fpga設計流程和方法，提出了極大靜態電路邏輯設計方法和遞增式布線方法，以達到減小動態重配置時間，提高系統運行效率的目的。
  6. The on - resistance of the synchronous rectifier is as low as 0. 4 ?. it has a very high efficiency even in the light load thanks to its low quiescent supply current

    整個晶元具有極低的靜態電流，使得此晶元即使在輕載的時候也有很高的效率。
  7. Maximum static current : 3a

    最大靜態電流： 3a
  8. This paper is mainly about some researches in three areas : iddq detecting method, iddt detecting method and fault location algorithm

    本文著重在靜態電流檢測方法、動態電流檢測方法以及故障定位演算法三個方面進行了研究。
  9. With the “ skip ” modulation technique, quiescent current are reduced to a minimized value of 1ma with full load, 60ua with no load, and less than 0. 01ua in shutdown mode

    在典型情況下，晶元滿載時的靜態電流為1ma ，空載時的靜態電流僅為60ua ，關斷電流小於0 . 01ua 。
  10. But this method can ’ t detect some kinds of faults under some high performance ics. recently, a novel fault diagnosis technology including iddq and iddt has developed rapidly

    基於電流的故障診斷方法包括靜態電流診斷方法（ iddq ）和動態電流診斷方法（ iddt ） ，是近期發展起來的新方法。
  11. Through the experiments of the synthetical irradiation effects on different 80c196kc20 and psd501b1 scm ( single chip microprocessor ) system chips, it was found that the static current did not increase apparently

    通過對80c196kc20和psd501b1兩種不同晶元在該環境下開展綜合輻照試驗，發現總的靜態電流增長不明顯。
  12. In iddq detecting area, the basic principle and strongpoint of iddq testing are introduced. then, the influence of deep - submicron technology on iddq testing is explained. and the improved iddq testing methods are also given

    在靜態電流檢測方面，首先闡述了iddq檢測的基本原理以及優缺點;分析了深亞微米技術對iddq測試的影響以及iddq的改進方法。
  13. While it works with supply voltages down to 1. 5v, the standby current is lower than 80n a together with the static power consumption lower than 240u w as well as the dynamic range of output voltages and currents is very wide

    模擬結果表明，電路工作於1 . 5v的低電壓時，靜態電流小於80 a ，靜態功耗不到240 w ，電壓輸出端和電流輸出端的輸出動態范圍大。
  14. Static power convertors ; semiconductor convertor equipment ; rating code

    靜態電源轉換器.半導體整流設備.額定值代碼
  15. See iohs static high - level output current for further information

    更進一步的信息，參見靜態電平輸出電流iohs 。
  16. The simulated results present that the circuit can offer several advantages such as low static state current ( < 100a ), low power ( < 300w ), wider dynamic swing and higher signal transfer precision when the operation voltage is 1. 5v

    模擬結果表明，當此電路工作於1 . 5的低電壓時，靜態電流小於100 a ，靜態功耗低於300 w ，同時電路的信號動態范圍大，信號轉換精度高。
  17. The conclusion is that under the neutron and 7 - ray synthetical irradiation environment of a reactor, ionization effects of neutron on the vlsi made with cmos technology are weak, and that the displacement effects of neutron induces the decreases of mobility ratio and density of charge carrier, which causes the decrease of the total static current, so it compensates the increase of the static current caused by the synthetical ionization effects of neutron and - ray

    對試驗結果綜合分析得出：在反應堆的綜合輻照環境下，中子電離效應較弱，並且由於中子位移效應引起載流子遷移率降低和載流子濃度降低，使得總的靜態電流下降，從而抵消中子和射線綜合電離導致的靜態電流增長。
  18. But often what is not obvious when reading a manufacturer ' s data sheet is how the initial accuracy of the device is affected by other key device parameters such as line regulation, load regulation, initial voltage error, output voltage temperature coefficient ( tc ), output voltage noise, turn - on settling time, thermal hyste - resis, quiescent supply current, and long - term stability

    但，人們閱讀廠家的數據手冊時，因受諸如（電源電壓）線性調整率、負載調整率、初始電壓誤差、輸出電壓溫度系數tc 、熱遲滯（系數） 、靜態電流和長期穩定度等參數的影響而使初始精度往往不明顯。
  19. Now, more and more electronic equipments are portable and multifunctional, which make the dc / dc converters must have special properties, such as high efficiency, low quiescent current, small board space, low weight and low cost

    小型化和多功能是便攜式電子產品的發展趨勢，因此要求dc / dc轉換器具有高效率、低靜態電流、小的板級面積、小體積和低成本等特性。
  20. In fault location area, a novel algorithm for fault location using iddq and iddt is designed in this paper. this algorithm is realized by combination of iddq and iddt based on wavelet transform. after classification of the potential faults by pattern recognition, the actual faults can be accurately located effectively

    在故障定位演算法方面:本文設計了一種基於電流信息的電路故障定位演算法，該演算法將靜態電流診斷方法與基於小波分析的動態電流診斷方法相結合，並通過模式識別進行決策，可以實現cmos集成電路多故障的準確定位。
分享友人
分享到 Line

分享到臉書