靜態響應 的英文怎麼說

中文拼音 [jìngtàixiǎngyīng]
靜態響應 英文
static response
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  1. Then the trait of the gma is tested including static and dynamic. the static test composes of static displacement and static force. the dynamic test composes of dynamic displacement, dynamic force and dynamic stagnancy

    其中靜態特性實驗由靜態位移輸出實驗、靜態力輸出實驗組成，動態特性實驗由動態位移輸出實驗、動態動力輸出特實驗、動態響應實驗組成，在此基礎上對數據進行分析。
  2. The optimal parameters for a cantilever piezolaminated beam are analytically obtained to ensure the free end displacement to remain zero

    與有限元結果比較表明：本文的理論模型能夠模擬壓電激勵的小曲率圓形曲梁的靜態響應。
  3. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  4. Analysis results of histogram statistics and section electron microscopic scan technique, are that fracture feature of the cracks of the hbbb is similar and the crack is multi - source strain fatigue one. internal defects of the cast, such as impurities, gas holes, etc, are the main causes for early cracks. the contrast analysis of static strength, model and transient respond on three structures with fem proves that geometrical stress concentration in partial area has influence on early crack, also

    利用直方圖等統計方法和電鏡掃描技術對該抱軸箱體裂紋分析的結果是：抱軸箱體的裂紋斷口特徵相近，裂紋性質屬于多源性低周疲勞裂紋，鑄件中的夾雜、氣孔等內部缺陷是導致過早裂損的主要原因；利用有限元法對該抱軸箱體三種結構的靜強度、模態和動態響應對比分析，證實了局部幾何性應力集中對過早裂損也有一定影響。
  5. In this paper, a new method is proposed, using the instant response of the induction motor to voltage pulse and current break when the motor stops

    本文首先利用感應電動機對脈沖電壓和階躍電流的瞬態響應，對電機參數進行了靜態測量，模擬結果表明了方法的可行性。
  6. Compared with the static model in errors, dynamic degrees and response curves, dynamic model is better. when voltage is above 0. 6 pu, the karlsson - hill model is suitable. when below, with air conditioner stalled, a new subsection model is established

    先分析比較靜態模型和動態模型，通過辨識的誤差、動態程度d以及響應曲線分析，發現採用動態模型更為合適； u 0 . 6u _ n時採用karlsson - hill模型； u 0 . 6u _ n時空調停機，構造一分段的模型，結果表明該負荷模型可以很好的擬合空調的動態響應。
  7. But at present, the static performances of the double reticulated domes applied on the different load combination of wind load, snow load, live load, seismic load and dead load are not adequately studied. also the study on the dynamical response under seismic action is not sufficient

    但目前對于這類空間結構在雪載荷、風載荷、恆載荷、活載荷、地震載荷等各種載荷共同作用和各種載荷分佈方式下的靜力性能研究還不充分，特別是對其在地震作用下的動態響應的研究還不足。
  8. Presented is the theory and methods on the strength analysis, model analysis and transient respond of mechanical components by means of the finite element method ( fem )

    系統地闡述了利用有限元法對機械結構零部件進行靜強度、模態和動態響應分析的相關理論和方法。
  9. The effect of initial static load on the instantaneous response makes the amplitude of vibration of horizontal and vertical displacement bigger than that without the effect

    初始靜力效應對結構瞬態響應的影響與剛度、質量、阻尼等因素有關，剛度越小，質量、阻尼越大時，初始靜力荷載效應對結構最大位移影響越小。
  10. A static and a transient analysis of an embedded crack in a long elastic strip are carried out. the results are approximate to the ones that existed. and the effects of the factors including the crack configuration, the crack depth, the strip length and the strip thickness on the transient response are discussed

    對含內埋橢圓裂紋的板條進行了靜態和瞬態分析，得到的結果與已有的解吻合良好，對影響瞬態響應的因素如裂紋形狀、裂紋深度、板條長度、板條厚度做了分析比較。
  11. In this dissertation, in allusion to the limit that the domestic analysis and studies of the body structure only concentrate on the static bend, torsion and some extreme conditions in nowadays and the studies on transient analysis of the whole vehicle that contains the suspension model, tire model and the road model are few, the applications of the fem on the analysis of the car body structure are studied. and in this dissertation the method of building connecting means models, the dynamic response of the body, the fatigue analysis of the body and the reforming measures of the body are deeply discusses

    本論文針對目前國內車身結構分析的研究只限於對車身或車架結構在靜態扭轉、彎曲載荷以及幾種極限工況載荷作用等幾種情況的研究，對含有懸架、輪胎以及路面模型的整車瞬態響應分析的研究較少的實際情況，對有限元方法在汽車結構分析中的應用作了些研究工作，尤其是在車身連接件處理、車身動態響應、車身疲勞強度分析、車身結構改進方案等方面進行了較深入的探索。
  12. Abstract : according to the deep analysis of the typical punching process, the loading charts and the amplitude - frequency curves of straight side cnc turret press frame are obtained. in the end the dynamic response of a typical process is calculated using modal superposition method by fem software marc and the static and dynamic stress of some nodes is compared as well

    文摘:根據板料沖裁時的工作負荷圖確定了數控回轉頭壓力機的動載荷譜，並通過傅立葉展開，獲得了壓力機的幅頻譜，最後通過marc軟體採用模態疊加法計算了典型沖裁時機身的動態響應，分析了其動態特性，並對特徵點的動靜態應力進行了比較。
  13. The test results demonstrate that this prototype has excellent comprehensive performances such as small bulk, lower weight, high efficiency, high steady precision, fast dynamic response, wide range input voltage, good output waveforms, strong over - load and short - circuit ability, and strong function with different nature load and three - phase unbalanced load

    試驗結果表明，該變流器具有體積重量小、變換效率高、靜態精度高、動態響應快、輸入電壓變化范圍寬、輸出波形質量高、過載與短路能力強、帶不同性質負載和帶三相不平衡負載的能力強等優良的綜合性能。
  14. Through the static and standard traffic cyclic loads, the responses of the pavement and subgrade have been attained. the studies on these responses such as elastic deformations, accumulative settlements and stress have been made under the changed characters of subgrade, such as moisture content, relative compaction of subgrade. the results of the experiments show that superfluous moisture content increases the vertical stress and the settlements of the construction under the similar relative compaction

    通過靜力加載和模擬路面承受的豎向交通荷載的重復加載試驗，研究了路面路基結構在雙輪車輛荷載作用下的動靜態響應，分析了路面路基結構在浸水狀態（土層含水量增加）和壓實密度降低等不利因數的影響下，路面路基各結構層的動靜力學響應特性，如彈性變形、累積下沉、土壓應力等的變化規律。
  15. In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research

    在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
  16. In this thesis, the internal force and transfiguration of the double reticulated dome under different load combination are studied ; the linear and nonlinear analysis are separately performed ; compare the difference between space girder element and space truss element ; at last analyze the dynamical response under seismic action. the horizontal seismic response of double layer oblate lattice shell is analyzed by using step - by - step integration procedure. the effect of some parameters such as exterior load, different support conditions and damping ratio on the dynamic internal forces and dynamic properties is studied

    本文旨在研究雙層球狀網殼結構在各種載荷組合下的內力和變形，分別進行了線性和非線性靜力分析；進行了空間梁單元和空間桿單元兩種計算模型的比較；最後進行了在地震荷載作用下的動力反應分析，動力分析中用子空間迭代法得出了這類空間結構的動力特性，用時程法中的振型疊加法分析了結構在水平地震作用下的動態響應規律。
  17. Investigation of the effect of bonding characteristics on static and dynamic behavior of a smart functionally graded beam

    界面特性對功能梯度智能梁靜動態響應的影響研究
  18. Shows the use of atl server s default error response, custom static responses, and custom dynamic responses

    說明如何使用atl server的默認錯誤響應、自定義靜態響應和自定義動態響應。
  19. In experimental, static response and frequency response of coupling acoustic / vibration optic fiber sensor have been analyzed. the results indicate that the response of the sensor to static pressure has high sensitivity. because the resonant frequency of different materials and structure is different, the sensor has maximum sensitivity in specific frequency

    試驗研究中，對耦合型聲振動光纖傳感器的靜態響應特性和頻率響應特性進行了試驗分析，分析結果表明該類型傳感器對應變的響應非常靈敏，而對頻率的響應則由於材料及結構本身的共振頻率的差異有不同的峰值響應頻率。
  20. Also, while this tip demonstrates the synchronous sending and receiving of messages, the jaxm api, available as an optional download, allows for the use of a messaging provider for asynchronous delivery through the use of a

    雖然本示例中的端點是提供靜態響應的servlet ，但是實際的響應取決于服務的功能和請求的性質。同時，雖然本篇技巧文章演示了消息的同步發送和接收，但是通過使用
分享友人
分享到 Line

分享到臉書