靜曲強度 的英文怎麼說

中文拼音 [jìngqūqiángdù]
靜曲強度 英文
mor
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. Laminated wood plastics. compreg determination of static bending

    木質層積塑料.靜曲強度的測定
  2. Basing on the discussion of the development status and the direction of block board in china and the key problem existing currently, this essay mainly discussed the research to the influential factors of bending strength about block board and its importance and necessity

    摘要通過對我國細木工板發展現狀、趨勢和目前存在主要問題的論述，探討對細木工板橫向靜曲強度影響因素研究的重要性和必要性。
  3. Hard fibreboard - determination of bending strength

    硬質纖維板靜曲強度的測定
  4. The results indicate that if the value of press stress is over certain figure, press stress and al plate ’ s thickness have little influence on sawtooth distortion for the same kind of sawtooth ; sawtooth distortion is well - regulated under static press, while it is irregular under impact press. bottom coating make great influence on bond strength of samples which can improve the value remarkably ; bonding mechanism of clad steel is mechanism of mechanical effect that sawtooth which is hooked occludes with al plate

    結果表明：同種齒型，當壓應力大於一定的值時，壓應力和覆板的厚度對齒形的變化影響不大；靜壓下齒形變化比較規則，鋸齒頂端向一側彎曲成鉤狀；沖壓下齒形比較凌亂，鋸齒的頂端沒有明顯的變形；后處理對試樣的結合強度影響很大，打底試樣由於粘結層的作用，結合強度較高；機械作用機制是復合鋼板的主要復合機理，鋸齒彎曲成鉤狀和鋁板形成機械咬合。
  5. Using lysozyme as a model, the effect of static magnetic field on me activity of lysozyme was studied using information provided by impedance response, two response models were first time proposed, which contained the parameters of magnetic field intensity and the magnetization time of lysozyme, respectively

    利用阻抗響應曲線提供的信息，以溶菌酶為代表酶，研究了靜磁場對酶活性的影響。首次提出了包含磁化時間和磁場強度變量的響應模型。
  6. Hard fibreboard - defermination of bending strength

    靜曲強度的測定
  7. Hard fibreboard defermination of bending strength

    靜曲強度的測定
  8. Medium density fiberboard determination of static bending strength and elastic modulus

    靜曲強度和彈性模量的測定
  9. The results showed that polypropylene content has different effects on the ib, tc, mor and moe

    結果表明，聚丙烯比例對復合材料的內結合強度、吸水厚度膨脹率、靜曲強度和彈性模量有不同的影響。
  10. Frame : strictly high - temperature sterilized, dried ( moisture content 8 % ), fine hard timber is used for sofa ' s frame so that the problems of being insect - eaten, bent or deformed can be avoided and the sofa can have a long life

    骨架材料：均採用經嚴格高溫殺菌，烘乾（平均含水率為8 % ） ，握釘力及靜曲強度高的優質硬木材料做沙發骨架，徹底避免出現蟲蛀、翹曲、變形等質量問題，保證沙發經久耐用。
  11. The seismic behavior of longitudinal middling - high r. c shear wall with frame column is discussed through model experimentations and finite element methods in this paper, after taking frame - shear wall structure of a main factory building of the large capacity power plant as experimentative prototype. the major work as follow : in order to appliance pseudo static test, the longitudinal middling - high r. c shear wall with frame column in the large capacity power plant ' s main factory building has been simulated to a model structure with 1 / 15 reduced - scale. the contents of study are process of cracking, course of damage, skeleton curve, rigidity degradation, ductility characteristic etc. that the seismic behavior of this kind of middling - high r. c shear wall is excellent has been proved by chubby hysteretic curve and fine capacity of energy dissipation

    本文以某大型火電廠主廠房縱向框架一剪力墻結構為原型，通過模型試驗和有限元分析，研究了縱向帶邊框柱中高剪力墻結構的抗震性能問題，主要內容有：選用1 15縮尺比把某大型火電廠主廠房縱向帶邊框柱剪力墻原型結構模擬為一個模型結構，並進行了偽靜力試驗，研究了這類縱向帶邊框柱中高剪力墻結構的開裂與破壞過程、骨架曲線、剛度退化、延性性能等問題，試驗滯回曲線飽滿，消能能力強，說明此類中高剪力墻的抗震性能較好。
  12. Fatigue experiments were performed to obtain the fatigue lifetime under the different loading. the parameters for law of the fatigue crack growth were obtained by crack growth experiments. in order to study the fatigue characteristics at high temperature, creep tests were also done

    本文對多種典型焊接試件開展了諸多的試驗研究工作：進行單軸靜載拉伸試驗以確定構件的強度；進行疲勞壽命試驗以測得疲勞壽命曲線；進行疲勞裂紋擴展試驗以獲得試件的疲勞裂紋擴展規律paris公式；進行蠕變試驗以考察焊接試件疲勞持久特性；進行剩餘壽命試驗以獲得試件的剩餘壽命。
  13. In this dissertation, in allusion to the limit that the domestic analysis and studies of the body structure only concentrate on the static bend, torsion and some extreme conditions in nowadays and the studies on transient analysis of the whole vehicle that contains the suspension model, tire model and the road model are few, the applications of the fem on the analysis of the car body structure are studied. and in this dissertation the method of building connecting means models, the dynamic response of the body, the fatigue analysis of the body and the reforming measures of the body are deeply discusses

    本論文針對目前國內車身結構分析的研究只限於對車身或車架結構在靜態扭轉、彎曲載荷以及幾種極限工況載荷作用等幾種情況的研究，對含有懸架、輪胎以及路面模型的整車瞬態響應分析的研究較少的實際情況，對有限元方法在汽車結構分析中的應用作了些研究工作，尤其是在車身連接件處理、車身動態響應、車身疲勞強度分析、車身結構改進方案等方面進行了較深入的探索。
  14. In this dissertation, the theories of finite element and the buckling analysis of shell are discoursed systematically. under the direction of these theories, with the help of ug software and msc / nastran software, the defective casing texture is analyzed on static strength and buckling, and then, the maximum loads of the texture with different defect value are gotten, the changeable curve of the maximum load with the defect value and the permissible defect value are gotten. that the texture with various defects can be destroyed variously is discoursed in considerable detail as well

    本論文系統論述了有限單元法和板的屈曲穩定理論，並在這些理論的指導下，以ug軟體和msc nastran軟體為工具，對存在一定幾何缺陷的典型箱形構件進行靜強度和屈曲的綜合分析，分別得出了不同缺陷度的構件的極限載荷，從而得到缺陷度與極限載荷的變化曲線，給出了缺陷度的最大許用值；同時，本論文還針對不同缺陷度構件的破壞形式不同這一問題進行了詳盡的論述。
  15. The result of the experiment indicated that the capability of adsorption decrease with ultrasound intensity, while the rate of the extraction and adsorptin increase. the model resulst also showed that the theoretical value of the homogeneous model considering intrapartical diffusion and outside - surface diffusion with freundlich phase equilibrium equation are agfeeable with the experimental value

    在吸附實驗中，測定了不同強度超聲場下梔子甙與1300樹脂上吸附平衡曲線、靜態吸附動力學曲線、動態穿透曲線。實驗結果表明，吸附容量隨著超聲波強度的增加而減少，而浸取、吸附速率隨著超聲波強度的增加而增大。
  16. Based on a quasi - static test of two - lay - three - story concrete - filled rectangular steel tubular frame ( crstf ), ductility behavior, dissipation of seismic energy, degeneration of stiff and intensity of the crstf under low - frequency, horizontal, repeat load are analyzed. hysteretic curves to each floor of crstf between displacements and repeat loads, together with corresponding framework curve and resilience model to top floor of crstf is shown, too

    本文基於一榀三層兩跨方鋼管混凝土框架擬靜力試驗，分析了低周反復水平荷載作用下框架的延性性能和強度與剛度的退化以及抗震耗能能力，給出了框架各層位移隨反復荷載變化的滯回曲線，並根據頂層滯回曲線進一步得出了框架頂層骨架曲線及相應的恢復力模型。
  17. In addition, the structures of four track concrete paver and milling machine are analyzed on static strength and buckling by use of this software. the finite element analysis results can be of great use for verifying the security of loads and the economization of material. the results also present a proposal to design the structure reasonably

    此外，本論文還利用上述軟體對具有國際先進水平的四履帶水泥混凝土攤鋪機和四履帶銑刨機中的構件進行了靜強度分析和屈曲分析，有限元分析結果為校核其承載的安全性及合理用材提供了理論依據，同時提出了結構設計方面的合理建議，本論文的研究方法和分析結果對機械結構強度分析具有很好的參考價值。
  18. Testing methods for static flexural strength of piezoelectric ceramics

    壓電陶瓷材料靜態彎曲強度試驗方法
  19. In chapter four the effects of a static electric field and different initial states on hhg are studied. under an additional electric field the spectrum exhibits a double - plateau structure. furthermore, the ionization probability and hhg also behave differently when the hydrogen atom is in different initial states

    在第四章中，我們研究了外加平行靜電場以及初態的不同對電離率和高次諧波的影響，發現附加一適當的靜電場會使諧波曲線呈現一雙平臺結構，電離率會隨著電場強度的增大而增大；當氫原子在初始時刻處于不同態時，根據選擇定則，諧波曲線和電離率都會有較大差別。
分享友人
分享到 Line

分享到臉書