靜氣燃燒室 的英文怎麼說

中文拼音 [jìngqìránshāoshì]
靜氣燃燒室 英文
quiescent combustion chamber
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Introduction to general ideas in air pollution control, air pollution effects, design of wall collection devices （ gravity settlers, centrifugal separators, electrostatic precipitators ）, design of dividing collection devices （ surface filters, depth filters, scrubbers for particulate control ）, design of controlling by concentration and recovery （ condensation, adsorption, absorption ）, design of controlling by oxidation （ combustion, biological oxidation, biofiltration ） and the choosing of a control technology

    本課程介紹空氣污染防制概念，空氣污染之影響，壁式集塵設備之設計（重力沉降室、離心分離器、靜電集塵器） ，分隔集塵設備之設計（表面過濾器、深層過濾器、洗滌器） ，以濃縮回收之控制設計（冷凝、吸附、吸收） ，以氧化之控制設計（燃燒、生物氧化、生物過濾） ，以及控制技術之選擇。
  2. The convective term is solved by ausm + ( a sequel to ausm which means " the advection upstream splitting method " ). the 7 species 8 steps model and 7 species 7 steps model of hydrogen / air is used in the hydrogen reacting flowfield, the 9 species 5 steps model of methane, the 10 species 10 steps model of ethane and the 10 species 13 steps model of kerosene are used in the hydrocarbon reacting flowfield, the results of the distributions of velocity, mach number, pressure, static temperature, total temperature, species mass fraction and the combustion efficiency are gained, and the numerical results of the pressure of hydrogen and methane are compared with those of the experiment

    計算中通量項採用ausm +通量分裂格式，氫反應流場採用氫/空氣的七組元八方程模型和七組元七方程模型，碳氫反應流場採用甲烷的九組元五方程模型、乙烯的十組元十方程模型和煤油的十組元十三方程模型，得出了超燃發動機燃燒室流場的速度、馬赫數、壓力、靜溫、總溫和組元質量分數分佈及燃燒效率等性能參數，其中氫和甲烷的計算壓力分佈與實驗結果進行了比較。
  3. And the finite element method ( fem ) was used to simulate the stress and deformation of the outer casing and the bearing chock. on the basis of the experiments and fem analysis, the strength and fatigue lifetime, the interaction of creep and fatigue lifetime, the creep lifetime of outer casing and bearing chock have been analyzed, at the end of trail, sem analyses of failure section has been conducted

    同時對航空發動機燃氣渦輪外機匣和軸承座進行了有限元模擬計算，得到外機匣和軸承座的焊接處的強度和變形情況的模擬結果。根據試驗數據和有限元的計算結果，對發動機燃燒室外機匣和軸承座兩種結構（包含焊縫）進行靜強度分析、疲勞壽命分析、蠕變壽命分析、蠕變疲勞交互作用壽命分析以及斷口的金相分析。
  4. While inheriting the hundred years of experience in the manufacture of power generation equipment, the company will be engaged in the manufacture of turbine blades & vanes as well as the assembly of combustion chambers and burners for gas turbines

    延承著西門子發電設備製造的百年經驗，上海西門子燃氣輪機部件有限公司將致力於燃氣輪機動葉和靜葉製造、燃燒室和燃燒器的裝配。
  5. This essay has touched upon the following work : 1. has built up theoretic models including static mathematic models of air compressor, combustion chamber, gas turbine, waste heat recovery boiler and steam turbine which are deduced according to the feature and theory of the equipment of the object of study. upon establishment of each model based on the actual conditions, a method of multiple imitation and combination is applied to parts which have already got characteristic curves to have achieved quite accurate curves whilst the method of neural net is applied to the parts which have no characteristic curves for establishment of models

    本文進行了以下的主要工作：建立理論模型，根據對象的實際設備的特點和理論關系推導壓氣機、燃燒室、燃氣輪機、余熱鍋爐、汽輪機的靜態數學模型；根據本研究的實際情況，在建立各部件模型時，對已有特性曲線的部件，採用多項式擬合的方法，得到較為準確的特性，而對部分沒有曲線的特性，則採用神經網路的方法建立模型。
分享友人
分享到 Line

分享到臉書