靜疲勞試驗 的英文怎麼說

中文拼音 [jìngpíláoshìyàn]
靜疲勞試驗 英文
static fatigue test
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  • 試驗 : trial; experiment; test
  1. It can be seen from the results that the control beam had good plastic property in the static failure experiment after two million fatigue loading circles. all specimens with corroded main bars were failure under the fatigue loads within one million fatigue circles. fatigue lifespan of reinforced concrete beam was sharply shortened after main bars corroded in it and the beam was destroyed bristly without any prediction

    試驗結果表明，振動測試不能夠對銹蝕鋼筋混凝土梁的疲勞破壞做出可靠的預測;對比梁在經過200萬次疲勞循環加載后的靜力試驗中仍表現出良好的延性破壞特徵;銹蝕梁在100萬次疲勞循環內均因主筋疲勞斷裂而破壞;主筋銹蝕使得梁的疲勞壽命急劇縮短;梁發生脆性破壞而沒有徵兆。
  2. Test methods for static bending fatigue of fine ceramics

    精細陶瓷靜態撓曲疲勞的試驗方法
  3. Effect on the characteristics of fatigue life of composite soils and dynamic modulus were discussed. the deformation behavior of stabilized soil on static and dynamic loading were compared. the characteristics of frequency spectrum of composite soils were analyzed in the thesis

    對水泥?水玻璃加固土進行循環荷載下的疲勞試驗研究，分析水泥?水玻璃加固土的疲勞壽命及其影響因素，以及固結土的動模量特徵，並對水泥土在動、靜荷載作用下的變形特徵進行比較，分析對比不同振幅與頻率的動荷載作用下的水泥加固土的應變響應及其頻譜特性。
  4. A series of static and fatigue experiments which include lots of specimens are performed on bolted composite laminates that include different sizes, different lay orientations and different torques. dye - enhanced x - radiography is used to check the progressive damage process as evaluation techniques, which can be made nondestructively. finally, the ultimate strength and fatigue life of composite bolted joints in static tension and

    層合板接頭的試驗研究考慮了多種幾何尺寸、多種鋪層及不同擰緊力矩對其靜強度及疲勞性能的影響，同時使用滲透劑增強的x射線圖象技術對靜載和疲勞損傷擴展及累積過程進行了無損檢測，並對其進行了分析探討。
  5. After fatigue tests were carried out for 44 stand beams, the following consequences were achieved. 1, contrasted with lsfrc, the strength of standing dead load of lhfrc are improved above 10. 62 %. contrasted with plain concrete, the amount is 22

    在對44根標準試驗梁進行抗折疲勞試驗的基礎上，本文主要取得以下成果或結論： 1 、層布式混雜纖維混凝土的靜荷載抗折強度比層布式鋼纖維混凝土提高約10 . 62 ，比素混凝土抗折強度提高了22 . 6 。
  6. An experimental program which includes lots of unidirectional laminae is conducted using t300 / bmp - 316 material for researching the static and fatigue behaviour of the unidirectional ply. the experimental research for mechanical behaviour of a unidirectional lamina is to set up expressions of the normalized fatigue life, the residual strength degradation and the residual stiffness degradation of a unidirectional ply in the longitudinal, transverse and in - plane - shear directions, which also verifies the fact of nonlinear shear stress - strain behavior of a unidirectional ply in the 1 - 2 planes

    其中:分別對材料t300 / bmp - 316單向層合板縱向、橫向及面內剪切靜載力學性能及疲勞特性進行了試驗研究，並採用最小二乘法擬合得到各主方向正則化疲勞壽命表達式，以及單層板各主方向疲勞加載剩餘剛度退化表達式及剩餘強度退化表達式;試驗同時驗證了單向層合板1 - 2面上明顯的剪切應力應變非線性關系。
  7. And the finite element method ( fem ) was used to simulate the stress and deformation of the outer casing and the bearing chock. on the basis of the experiments and fem analysis, the strength and fatigue lifetime, the interaction of creep and fatigue lifetime, the creep lifetime of outer casing and bearing chock have been analyzed, at the end of trail, sem analyses of failure section has been conducted

    同時對航空發動機燃氣渦輪外機匣和軸承座進行了有限元模擬計算，得到外機匣和軸承座的焊接處的強度和變形情況的模擬結果。根據試驗數據和有限元的計算結果，對發動機燃燒室外機匣和軸承座兩種結構（包含焊縫）進行靜強度分析、疲勞壽命分析、蠕變壽命分析、蠕變疲勞交互作用壽命分析以及斷口的金相分析。
  8. Vibration test was done on the beams under different state. main bars of all the specimens were taken out for static tensile experiment after fatigue experiments. it showed that the vibration test cannot predict the fatigue failure of the fatigued beams effectively

    疲勞試驗中，對梁在不同疲勞狀態下的振動特徵進行了測試;在疲勞試驗結束后，取出梁中主筋進行靜力拉伸試驗。
  9. Fatigue test indicates that strain multiplier have not been damaged for fatigue in the service life of fatigue life gage, fatigue response of fatigue life gage can be derived from the strain amplitude equal to specimen strain multiplied by amplification coefficient of strain multiplier

    疲勞實驗研究表明，在疲勞壽命計工作壽命內，應變倍增器無疲勞破壞情況，疲勞壽命計疲勞響應可由靜載標定放大倍數乘試件表面應變后所對應的等幅應變值得到。
  10. Fatigue experiments were performed to obtain the fatigue lifetime under the different loading. the parameters for law of the fatigue crack growth were obtained by crack growth experiments. in order to study the fatigue characteristics at high temperature, creep tests were also done

    本文對多種典型焊接試件開展了諸多的試驗研究工作：進行單軸靜載拉伸試驗以確定構件的強度；進行疲勞壽命試驗以測得疲勞壽命曲線；進行疲勞裂紋擴展試驗以獲得試件的疲勞裂紋擴展規律paris公式；進行蠕變試驗以考察焊接試件疲勞持久特性；進行剩餘壽命試驗以獲得試件的剩餘壽命。
  11. Based on a large numbers of model / simulation test of the intermittent cracked rock - like samples, fatigue strength, fatigue deformation and crack appear in preexisting cracks tips, the growth of crack, the pattern of crack coalescence are studied / analysed systemically by means of cyclic load and static load, in the course of the model test, the difference between cyclic load and static load of crack appear in preexisting cracks tips, the growth of crack and the pattern of crack coalescence are observed and analysed

    在試驗過程中，觀察並分析了循環加載方式下，預置裂隙端部裂紋萌生、擴展、巖橋貫通模式與靜載方式下的差異；探討了疲勞裂紋萌生、擴展的機理，分析了加載頻率、荷載水平對裂隙試樣疲勞強度、疲勞變形（總變形和不可逆變形）的影響規律。
  12. Water hydraulic pressure servo loading system can be used to execute static presses test, the tired test, the sum settle strength test, the resilience split test, static structure strength test, the structure pieces design experiments among others. it has a very extensive application in the aerospace field

    水壓伺服加載系統可用來對負載結構件進行靜力抗壓測試、疲勞測試、額定強度、斷裂韌度、結構靜強度、操作容限設計等試驗，在航空航天領域有著十分廣泛的應用。
  13. Standard test methods for determination of static and cyclic fatigue strength of ceramic modular femoral heads

    預制陶瓷股骨頭的靜態和循環疲勞強度測定的標準試驗方法
  14. The 3 - point bending teat was performed on material testing system ( mts ) to investigate the quasistatic and fatigue behavior of ultra - thick 3 - d orthogonal woven composites ( glass / unsaturated resin ), which aimed to predict the fatigue property of this material

    摘要在材料測試系統mts上，採用三點彎曲加載方式對超厚三維正交機織復合材料（玻璃纖維不飽和聚酯）分別進行靜態及疲勞試驗，對該材料的疲勞性能進行探索和預測。
  15. Rubber or plastics cellular materials. static fatigue test under constant indentation force flexible cellular materials

    橡膠或塑料泡沫材料.在恆定壓痕強度下柔性泡沫材料的靜力疲勞試驗
分享友人
分享到 Line

分享到臉書