靜電系儀表 的英文怎麼說

中文拼音 [jìngdiànxìyíbiǎo]
靜電系儀表 英文
electrostatic instrument
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 儀 : 名詞1 （人的外表） appearance; bearing 2 （禮節; 儀式） ceremony; rite 3 （禮物）present; gift 4 ...
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 靜電 : [物理學] static electricity; franklinism; franklinic electricity
  • 儀表 : 1. （人的外表） appearance; bearing 2. （各種測定儀） meter; instrument; apparatus
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. General model c38 dc meters are portable taut - band suspended moving coil instruments with light - spot indication. the meters have the feature of extremely high in sensitity and small in consumpition being particularly suitable to be used for measuring weak electric quantity on dc circututs, also for testing the static paramenters of transistors as well for measuring the output of millivolt values of zhermocouple in the vacuun furnaces ( or hydrogen furnaces )

    C38型直流電表是磁電系張絲支承光點指示可攜式電表儀表具有極高的靈敏度，功耗小，特別適合弱電量直流電路測量及晶體管靜態參數測試用以及用做真空爐（或氧氣爐）中測量熱電偶的輸出毫伏值
  3. The company is mainly engaged in the development and production of power transmission and transformation line protection, primary power equipment protection, substation comprehensive automation system, hydropower and thermal power plant automation system, and other automation products

    是國內最大的電力系統靜態保護、成套自動化設備、土工試驗和大壩觀測儀器以及電力測試儀表的國家大型骨幹企業。
  4. Besides, our static controlling and testing products such as sticky mat, anti - static shoes, gloves, surface resistance tester etc. have also obtained a good market in local and abroad

    先後開發和生產出全系列的無塵車間使用的一次性凈化產品，粘塵墊，防靜電鞋，防靜電表面電子測試儀等十幾種靜電控制與檢測，並遠銷國外。
  5. Finally, the paper expatiates the realization process of this design, including the rotation equipment management, the static equipment management, examines and service project management, the electrical management, the meter computer management, the water quality management, the lubricating oil management, the static seal management, the craft pipeline management, the bearing management, the pressure vessel

    最後，文章對系統的設計實現過程進行了闡述，分別對大慶石化總廠設備管理系統的轉動設備管理、靜設備管理、檢維修計劃管理、電氣管理、儀表計算機管理、水質管理、潤滑油管理、靜密封點管理、工藝管線管理、軸承管理、壓力容器管理、安全閥管理進行重點描述。
  6. It emphases the selection of secondary voltage of the step - down transformer, the control and protection of thyristor, the calculation of compensation capability and group capability, the technique of cross - zero switched on / off capacitors or reactor, the solution of avoiding possible resonance in switching on / off groups of capacitors or reactor and the measure of the best time to switch ( including the design of the computer survey and control system, instrument deliver system, delay operate and protect system ). although thyristor as a no - contact switch can avoid almost the problem of contact switch with contact, it can not solve the over - voltage, over - current and transient process itself as switching on / off capacitors or reactor. so we must develop a set of thyristor - switched control and protect system with great reliability so that it can realize of cross - zero switching on / off capacitors or reactor at any time

    晶閘管具有過零、動作快速的特點，本研究以晶閘管為電容器和電抗器的分組投切開關，重點研究了協調變壓器二次電壓的選擇、晶閘管觸發控制及保護、動態補償容量及分組容量的計算確定、過零投切電容器和電抗器技術的實現、以及分組投切電容器和電抗器可能發生諧振的處理計算方法，給出實現最佳補償投切選擇方法（測控系統、儀表變送系統、操作和保護系統的設計步驟） ，研製了一套高可靠性晶閘管觸發控制及保護系統，實現對無功的靜止可調補償。
分享友人
分享到 Line

分享到臉書